Several organostibine chain‐transfer agents possessing polar functional groups have been prepared by the reactions of azo initiators and tetramethyldistibine ( 1 ). Carbon‐centered radicals thermally generated from the azo initiators were trapped by 1 to yield the corresponding organostibine chain‐transfer agents. The high yields observed in the synthesis of the chain‐transfer agents strongly suggest that distibines have excellent radicophilic reactivity. As the reactions proceeded under neutral conditions, functional groups that are incompatible with ionic conditions were incorporated into the chain‐transfer agents. The chain‐transfer agents were used in living radical polymerization to synthesize the corresponding α‐functionalized polymers. As the functional groups in the chain‐transfer agents did not interfere with the polymerization reaction, well‐controlled polymers possessing number‐average molecular weights (Mns) predetermined by the monomer/transfer agent ratios were synthesized with low polydispersity indices (PDIs). The organostibanyl ω‐polymer ends were transformed into a number of different functional groups by radical‐coupling, radical‐addition, and oxidation reactions. Therefore, it was possible to synthesize well‐controlled telechelic polymers with the same and also with different functional groups at their α‐ and ω‐polymer ends. Distibine 1 was also found to increase PDI control in the living radical polymerization of styrene and methyl methacrylate (MMA) using a purified organostibine chain‐transfer agent. Well‐controlled poly(methyl methacrylate)s with Mn values ranging from 10 000 to 120 000 with low PDIs (1.05–1.15) were synthesized by the addition of a catalytic amount of 1 . The results have been attributed to the high reactivity of distibine 1 towards polymer‐end radicals, which are spontaneously deactivated to yield organostibine dormant species. 相似文献
The irradiation degradation of methamidophos in aqueous solutions by 60Co‐γ rays was investigated. The effects of absorbed doses, saturated gas, and the additive of H2O2 on the degradation were also studied. The results showed that the oxidative radical, such as ·OH, played an important role in the irradiation degradation of methamidophos; while the reductive radicals, e?aq and ·H, had no contribution to the degradation. The degradation rate of methamidophos increased with the increase of the irradiation dosage. At certain irradiation dosage, methamidophos could be degraded completely. The degradation rate of methamidophos in the solution saturated with oxygen was higher than those saturated with other gases, which reached 100% when the absorbed dose was 8 kGy. H2O2 degraded methamidophos slowly when it was used alone, but could accelerate the degradation obviously when it was used with irradiation together. 相似文献
The solid-state postpolymerization of slowly crystallized methacrylic acid was studied at 0°C with 60Co γ-radiation as the initiator. The yield, molecular weight, molecular weight distribution, and stereosequencing of the polymer product were determined as a function of polymerization time. The narrow molecular weight distribution and the linear dependence of molecular weight on polymer yield were attributed to a polymerization mechanism characterized by both independent chain propagation and essentially no termination step. The overall polymerization rate was substantially faster than that reported previously for shock-crystallized monomer, a result which was attributed to termination by the occlusion of propagating radicals at defects in the shock-crystallized monomer. Although largely atactic, the polymer synthesized in the solid state contained a secondary kind of stereosequencing; the meso triad probability was highest at the end of the chain, where propagation had initiated and decreased continuously with chain growth. The gradient in stereosequencing along the chains was attributed to defects that were introduced into the monomer crystals by the growing polymer chains. 相似文献
Summary: The ambient temperature (20 °C) reversible addition fragmentation chain transfer (RAFT) polymerization of N‐isopropylacrylamide (NIPAAm) and acrylic acid (AA) conducted directly in aqueous media under γ‐initiation (at dose rates of 30 Gy · h−1) proceeds in a controlled fashion (typically, < 1.2) to near quantitative conversions and up to number‐average molecular weights of 2.5 × 105 g · mol−1 for PNIPAAm and 1.1 × 105 g · mol−1 for PAA via two water‐soluble trithiocarbonate chain transfer agents, i.e., S,S‐bis(α,α′‐dimethyl‐α″‐acetic acid)trithiocarbonate (TRITT) and 3‐benzylsulfanylthiocarbonylsulfanyl propionic acid (BPATT). The generated polymers are successfully chain extended, which suggests that the RAFT agents are stable throughout the polymerization process so that complex and well‐defined architectures can be obtained.
An increase of the monomer/CTA ratio leads to an increase of the molecular weight for the RAFT polymerization of NIPAAm under γ‐radiation in water using TRITT at ambient temperature. 相似文献
The initiation and propagation reaction in γ-ray-induced polymerization of ethylene was studied by the two-stage irradiation method, i.e., a first stage in which initiation and propagation occur at a high dose rate, and a second stage where only the growth of polymer radical occurs. The rate of initiation is calculated from the amount of polymerized monomer and the degree of polymerization as the rate of increase in the number of polymer chains. The initiation rate is shown to be proportional to the ethylene density in the reactor and dose rate. GR of radical formation is found to be about 1.6 at 30°C. at a dose rate of 2.5 × 104 rad/hr. and is almost independent of ethylene density but decreases slightly with increasing irradiation dose rate. The lifetime of the growing polymer chain radical is shown to be long at normal temperature. The absolute propagation rate is proportional to the square of ethylene fugacity and depends on dose rate to some extent. For chain growth, irradiation of low dose rate is necessary. The apparent activation energy for the propagation reaction is ?9 kcal./mole. 相似文献
Photooxidation of alkanes by dioxygen occurred under visible light irradiation of 2,3‐dichloro‐5,6‐dicyano‐p‐benzoquinone (DDQ) which acts as a super photooxidant. Solvent‐free hydroxylation of cyclohexane and alkanes is initiated by electron transfer from alkanes to the singlet and triplet excited states of DDQ to afford the corresponding radical cations and DDQ??, as revealed by femtosecond laser‐induced transient absorption measurements. Alkane radical cations readily deprotonate to produce alkyl radicals, which react with dioxygen to afford alkylperoxyl radicals. Alkylperoxyl radicals abstract hydrogen atoms from alkanes to yield alkyl hydroperoxides, accompanied by regeneration of alkyl radicals to constitute the radical chain reactions, so called autoxidation. The radical chain is terminated in the bimolecular reactions of alkylperoxyl radicals to yield the corresponding alcohols and ketones. DDQ??, produced by the photoinduced electron transfer from alkanes to the excited state of DDQ, disproportionates with protons to yield DDQH2. 相似文献
The most abundant naturally occurring terpene, α‐pinene, which cannot be directly polymerized into high polymers by any polymerization method, was quantitatively converted under visible‐light irradiation into pinocarvone, which possesses a reactive exo methylene group. The bicyclic vinyl ketone was quantitatively polymerized in fluoroalcohols by selective (99 %) ring‐opening radical polymerization of the four‐membered ring, which results in unique polymers containing chiral six‐membered rings with conjugated ketone units in the main chain. These polymers display good thermal properties, optical activities, and contain reactive conjugated ketone units. Reversible addition fragmentation chain transfer (RAFT) polymerization was successfully accomplished by using appropriate trithiocarbonate RAFT agents, enabling the synthesis of thermoplastic elastomers based on controlled macromolecular architectures. 相似文献