Tuning the Reactivity of Cyclopropenes from Living Ring‐Opening Metathesis Polymerization (ROMP) to Single‐Addition and Alternating ROMP

Ring‐opening metathesis polymerization (ROMP) has become one of the most important living polymerizations. Cyclopropenes (CPEs) remain underexplored for ROMP. Described here is that the simple swap of 1‐methyl to 1‐phenyl on 1‐(benzoyloxymethyl)CPEs elicited strikingly different modes of reactivity, switching from living polymerization to either selective single‐addition or living alternating ROMP. The distinct reactivity stems from differences in steric repulsions at the Ru alkylidene after CPE ring opening. Possible olefin or oxygen chelation from ring‐opened CPE substituents was also observed to significantly affect the rate of propagation. These results demonstrate the versatility of CPEs as a new class of monomers for ROMP, provide mechanistic insights for designing new monomers with rare single‐addition reactivity, and generate a new functionalizable alternating copolymer scaffold with controlled molecular weight and low dispersity.     

Catalytic Living Ring Opening Metathesis Polymerisation: The Importance of Ring Strain in Chain Transfer Agents

A recently developed catalytic living ring opening metathesis polymerisation (ROMP) was investigated using a series of reversible chain transfer agents (CTA) carrying either cyclopentene or cyclohexene rings, differing only in ring strain. All cyclopentene derivatives examined showed significantly faster reaction rates than the corresponding cyclohexene derivatives. This resulted in lower molecular weight dispersities and better control of the molecular weight for the cyclopentene compared to the cyclohexene CTAs. Both Grubbs’ second and third generation catalysts could be employed in catalytic living ROMP using cyclopentene CTA derivatives. The kinetics of different CTAs were studied, block copolymers were synthesised and residual ruthenium quantified by ICP‐OES. All polymers were fully characterised by NMR, GPC and MALDI‐ToF mass spectrometry. The new cyclopentene CTAs are readily synthesised in a few straightforward steps and provide faster reaction kinetics than all previously reported reversible CTAs.     

Catalyst‐Sidearm‐Induced Stereoselectivity Switching in Polymerization of a Racemic Lactone for Stereocomplexed Crystalline Polymer with a Circular Life Cycle

Construction of robust, stereocomplexed (sc) crystalline material, based on a recently discovered infinitely recyclable polymer system, requires blending of enantiomeric polymer chains produced from respective enantiopure, fused six‐five bicyclic lactones. Herein, the stereoselective polymerization of the racemic monomer by yttrium catalysts bearing tetradentate ligands is reported, where the tethered donor sidearm switches the heteroselectivity of the catalyst to isoselectivity when it is changed from the β‐OMe to β‐NMe₂ sidearm. The latter catalyst produces an isotactic stereoblock polymer (P_m up to 0.95) that forms the crystalline sc‐material with a T_m of up to 171 °C. This sc‐material can be fully depolymerized back to rac‐monomer in a quantitative yield and purity, thus establishing its circular life cycle.     

Ring‐Opening Metathesis Polymerization of Biomass‐Derived Levoglucosenol

The readily available cellulose‐derived bicyclic compound levoglucosenol was polymerized through ring‐opening metathesis polymerization (ROMP) to yield polylevoglucosenol as a novel type of biomass‐derived thermoplastic polyacetal, which, unlike polysaccharides, contains cyclic as well as linear segments in its main chain. High‐molar‐mass polyacetals with apparent weight‐average molar masses of up to 100 kg mol^?1 and dispersities of approximately 2 were produced despite the non‐living/controlled character of the polymerization due to irreversible deactivation or termination of the catalyst/active chain ends. The resulting highly functionalized polyacetals are glassy in bulk with a glass transition temperature of around 100 °C. In analogy to polysaccharides, polylevoglucosenol degrades slowly in an acidic environment.     

Broadly Applicable Z‐ and Diastereoselective Ring‐Opening/Cross‐Metathesis Catalyzed by a Dithiolate Ru Complex

A broadly applicable Ru‐catalyzed protocol for Z‐selective ring‐opening/cross‐metathesis (ROCM) is disclosed. In addition to reactions relating to terminal alkenes of different sizes, the first examples of Z‐selective ROCM processes involving heteroaryl olefins, 1,3‐dienes, and O‐ and S‐substituted alkenes as well as allylic and homoallylic alcohols are reported. Z‐Selective transformations with an α‐substituted allylic alcohol are shown to afford congested Z alkenes with high diastereoselectivity. Transformations are performed in the presence of 2.0–5.0 mol % of a recently disclosed Ru‐based dithiolate complex that can be easily prepared in a single step from commercially available starting materials. Typically, transformations proceed at ambient temperature and are complete within eight hours; products are obtained in up to 97 % yield, >98:2 Z/E, and >98:2 diastereomeric ratio. The present investigations reveal a mechanistically significant attribute of the Ru‐based dithiolates that arises from electrostatic interactions with anionic S‐based ligands.