Low Reynolds number axisymmetric turbulent boundary layer on a cylinder

In the present study, an axisymmetric turbulent boundary layer growing on a cylinder is investigated experimentally using hot wire anemometry. The combined effects of transverse curvature as well as low Reynolds number on the mean and turbulent flow quantities are studied. The measurements include the mean velocity, turbulence intensity, skewness and flatness factors in addition to wall shear stress. The results are presented separately for the near wall region and the outer region using dimensionless parameters suitable for each case. They are also compared with the results available in the open literature.The present investigation revealed that the mean velocity in near wall region is similar to other simple turbulent flows (flat plate boundary layer, pipe and channel flows); but it differs in the logarithmic and outer regions. Further, for dimensionless moments of higher orders, such as skewness and flatness factors, the main effects of the low Reynolds number and the transverse curvature are present in the near wall region as well as the outer region.     

The effect of particles on fluid turbulence in a turbulent boundary layer over a cylinder

The turbulent fluid and particle interaction in the turbulent boundary layer for cross flow over a cylinder has been experimentally studied. A phase-Doppler anemometer was used to measure the mean and fluctuating velocities of both phases. Two size ranges of particles (30μm–60μm and 80μm–150μm) at certain concentrations were used for considering the effects of particle sizes on the mean velocity profiles and on the turbulent intensity levels. The measurements clearly demonstrated that the larger particles damped fluid turbulence. For the smaller particles, this damping effect was less noticeable. The measurements further showed a delay in the separation point for two phase turbulent cross flow over a cylinder. The project supported by the National Natural Science Foundation of China     

Aerodynamic heating in the region of shock and turbulent boundary layer interaction induced by a cylinder

Detailed distributions of heat flux in the region of shock wave and turbulent boundary layer interaction induced by a cylinder were measured in the shock tunnel. Oil flow patterns and Schlieren photographs were taken. Empirical relations were given for determining separation shock angle, peaks of heat flux and their locations on both cylinder leading edge and flat plate surface, and other characteristic parameters of the interaction region.     

Transport of particles in an atmospheric turbulent boundary layer

A program incorporating the parallel code of large eddy simulation (LES) and particle transportation model is developed to simulate the motion of particles in an atmospheric turbulent boundary layer (ATBL). A model of particles of 100-micrometer order coupling with large scale ATBL is proposed. Two typical cases are studied, one focuses on the evolution of particle profile in the ATBL and the landing displacement of particles, whereas the other on the motion of particle stream.The English text was polished by Yunming Chen.     

Modal characteristics of a flexible cylinder in turbulent axial flow from numerical simulations

In this paper the vibration behavior of a flexible cylinder subjected to an axial flow is investigated numerically. Therefore a methodology is constructed, which relies entirely on fluid–structure interaction calculations. Consequently, no force coefficients are necessary for the numerical simulations. Two different cases are studied. The first case is a brass cylinder vibrating in an axial water flow. This calculation is compared to experiments in literature and the results agree well. The second case is a hollow steel tube, subjected to liquid lead–bismuth flow. Different flow boundary conditions are tested on this case. Each type of boundary conditions leads to a different confinement and results in different eigenfrequencies and modal damping ratios. Wherever appropriate, a comparison has been made with an existing theory. Generally, this linear theory and the simulations in this paper agree well on the frequency of a mode. With respect to damping, the agreement is highly dependent on the correlation used for the normal friction coefficients in the linear theory.     

Interaction of an oscillating vortex with a turbulent boundary layer

An oscillating vortex embedded within a turbulent boundary layer was generated experimentally by forcing a periodic lateral translation of a half-delta wing vortex generator. The objective of the experiment was to investigate the possibility that a natural oscillation, or meander, might be responsible for flattened vortex cores observed in previous work, which could also have contaminated previous turbulence measurements. The effect of this forced oscillation was characterized by comparison of measurements of the mean velocities and Reynolds stresses at two streamwise stations, for cases with and without forcing. The Reynolds stresses, especially w, were affected significantly by the forced oscillation, mainly through contributions from the individual production terms, provided the vortex was not too diffuse.List of Symbols a amplitude of forced vortex motion - f frequency of forced vortex generator motion - l vortex generator root chord - L flow length scale - R _Y , R _Z vortex core radial dimensions in vertical and spanwise directions, respectively - R_r vortex circulation Reynolds number R = / - u, v, w instantaneous velocity components in X, Y, Z directions - U, V, W mean velocities; shorthand notation for u, , w - X, Y, Z right-hand Cartesian streamwise, vertical, and spanwise coordinate directions - boundary-layer thickness - overall circulation - air kinematic viscosity - _x streamwise vorticity, _X = W/Y–V/d+t6Z - ( )₀ reference value (measured at X = 10 cm) - ( )c refers to vortex center - ( ) _max maximum value for a particular crossflow plane - ( ) (overbar) time average - ( ) (prime) fluctuating component, e.g., u=U+u     

The turbulent/non-turbulent interface in an adverse pressure gradient turbulent boundary layer

The turbulent/non-turbulent interface (TNTI) in an adverse pressure gradient (APG, β = 1.45) turbulent boundary layer (TBL) is explored here by using direct numerical simulation (DNS) data; β is the Clauser pressure gradient parameter. For comparison, the DNS data for a zero pressure gradient (ZPG) TBL is included. The interface is extracted with an approach based on enstrophy criteria. Depending on the enstrophy, the outer boundary layer flow can be classified into the free stream, boundary layer wake, and intermittent flow regimes. The fractal dimension of the interface is obtained by using the box-counting algorithm, and was found to be constant over a long range of box sizes. The TNTI shows a monofractal behavior. The geometric complexity of a TNTI can be determined in terms of the genus, which is defined as the number of handles in a geometric object. We examine the volume and projection area of the genus of the TNTI to analyze the entrainment process. The geometric complexity of the APG TBL interface and the local entrainment are greater than those of the ZPG TBL, as is evident in the increases in the genus near the interface. The local entrainment velocity is dominantly affected by the viscous diffusion at the interface.     

Kinematics of a turbulent boundary layer

In the article an attempt is made, within the framework of the Navier-Stokes equations, to describe the field of the instantaneous velocities of a liquid in the region of a turbulent flow near the wall. It is assumed that the velocities of the liquid are determined by the field of the eddies arising in regions of ejections under the action of pressure pulses in the region near the wall.Translated from Izvestiya Akademii Nauk SSSR, Mekhanika Zhidkosti i Gaza, No. 5, pp. 34–40, September–October, 1973.     

Two-dimensional interaction between an incident shock and a turbulent boundary layer in the presence of an entropy layer

The results of an experimental and numerical investigation of flow and heat transfer in the region of the interaction between an incident oblique shock and turbulent boundary layers on sharp and blunt plates are presented for the Mach numbers M_∞ = 5 and 6 and the Reynolds numbers Re_∞L = 27×10⁶ and 14×10⁶. The plate bluntness and the incident shock position were varied. It is shown that the maximum Stanton number St _m in the shock incidence zone decreases with increase in the plate bluntness radius r to a certain value and then varies only slightly with further increase in r. In the case of a turbulent undisturbed boundary layer heat transfer is diminished with increase in r more slowly than in the case of a laminar undisturbed flow. In the presence of an incident shock the bluntness of the leading edge of the flat plate results in a greater decrease in the Stanton number than in the absence of the shock. With increase in the bluntness of the leading edge of the plate the separation zone first sharply lengthens and then decreases in size or remains constant.     

POD investigation of the unsteady turbulent boundary layer developing over porous moving flexible fishing net structure

Particle image velocimetry (PIV) measurements are made to investigate the boundary layer developing over a modeled bottom trawl. The random motion of the fishing net structure as well as the flexibility and the porosity of this structure means that it is not enable to access the main characteristics of such a flow, using classical post-processing mathematical tools. An innovative post-treatment tool based on proper orthogonal decomposition (POD) is then developed to extract the mean velocity flow field from each available PIV instantaneous unsteady velocity field. In order to do so, the whole available velocity database is used to compute POD eigenfunctions and the first POD modes are identified as representing the mean flow field. It is then possible to deduce the mean boundary layer flow field for each position of the fishing net structure during PIV measurements. It is then observed that the mean flow field strongly depends on multiple parameters such as surface curvature, structure porosity, random motion of the structure. Streamwise evolution of classical thicknesses of boundary layer flow are also analyzed. The present work also provides benchmark PIV data of the unsteady flow developing on fishing net porous structures, which helps the progress in unsteady numerical codes for this investigation.     

Conditional correlation between a passive scalar and its dissipation in a turbulent boundary layer

 A study of the conditional correlation between a passive scalar and its dissipation offers an interesting strategy for understanding turbulence properties associated with both large and small scales. This correlation is investigated with particular emphasis on the dominant coherent motions in turbulent boundary layers; namely, sweeps and ejections, using a local cross-correlation analysis based on the wavelet transform. Contributions to the three temperature derivatives show different features, reflecting clear “local” departures from isotropy. This property of coherent motions is investigated through the conditional cross-spectra inferred from the wavelet analysis, which provides localized scale decomposition of the quantity under consideration, and is translated in the spectral domain. These decompositions indicate the particular coherent motions of the flow which most contribute to the conditional correlation between temperature and its dissipation. Received: 27 November 1997/Accepted: 20 July 1998     

Periodic boundary layer near an axisymmetric stagnation point on a circular cylinder

An analysis is presented to investigate the time-mean characteristics of the laminar boundary layer near an axisymmetric stagnation point when the velocity of the oncoming flow relative to the body oscillates. Different solutions are obtained for the small and high values of the reduced frequency parameter. The range of Reynolds number considered was from 0.01 to 100. Numerical solutions for the velocity functions are presented, and the wall values of the velocity gradients are tabulated.     

Interaction of an elastic boundary with a viscous sublayer of a turbulent boundary layer

The boundary region of a turbulent boundary layer contributes greatly to the drag. Intense turbulence is generated in this region. Below we investigate the interaction of an elastic boundary with a viscous sublayer for a decrease in the Reynolds stresses, and for a corresponding decrease in the drag. It does not seem possible to investigate the general case. Therefore, the problem is solved within the framework of the limitations made by Sternberg [1] for the theory of a viscous sublayer in a turbulent flow near a solid smooth wall.Translated from Zhurnal Prikladnoi Mekhaniki i Tekhnicheskoi Fiziki, No. 3, pp. 58–62, May–June, 1971.The authors thanks G. S. Migirenko for advice and remarks given during a discussion of the work.     

LES of the adverse-pressure gradient turbulent boundary layer

We describe large-eddy simulations (LES) of the flat-plate turbulent boundary layer in the presence of an adverse pressure gradient. The stretched-vortex subgrid-scale model is used in the domain of the flow coupled to a wall model that explicitly accounts for the presence of a finite pressure gradient. The LES are designed to match recent experiments conducted at the University of Melbourne wind tunnel where a plate section with zero pressure gradient is followed by section with constant adverse pressure gradient. First, LES are described at Reynolds numbers based on the local free-stream velocity and the local momentum thickness in the range 6560–13,900 chosen to match the experimental conditions. This is followed by a discussion of further LES at Reynolds numbers at approximately 10 times and 100 times these values, which are well out of range of present day direct numerical simulation and wall-resolved LES. For the lower Reynolds number runs, mean velocity profiles, one-point turbulent statistics of the velocity fluctuations, skin friction and the Clauser and acceleration parameters along the streamwise, adverse pressure-gradient domain are compared to the experimental measurements. For the full range of LES, the relationship of the skin-friction coefficient, in the form of the ratio of the local free-stream velocity to the local friction velocity, to both Reynolds number and the Clauser parameter is explored. At large Reynolds numbers, a region of collapse is found that is well described by a simple log-like empirical relationship over two orders of magnitude. This is expected to be useful for constant adverse-pressure gradient flows. It is concluded that the present adverse pressure gradient boundary layers are far from an equilibrium state.     

The boundary layer on a slightly yawed cylinder

The velocity in a turbulent boundary layer on a long cylinder at a slight yaw to the free stream was measured using hot wire anemometry for yaw angles of ?0.55°?α?0.55°. The mean velocity profile retains a log region regardless of yaw with a slope that is slightly dependent upon the yaw angle. The boundary layer thickness increases nonlinearly with yaw angle, but the dimensionless distance from the wall of the maximum turbulence intensity is independent of yaw angle.