Switching Kr/Xe selectivity with temperature in a metal-organic framework

Krypton (Kr) and xenon (Xe) adsorption on two partially fluorinated metal-organic frameworks (FMOFCu and FMOFZn) with different cavity size and topologies are reported. FMOFCu shows an inversion in sorption selectivity toward Kr at temperatures below 0 °C while FMOFZn does not. The 1D microtubes packed along the (101) direction connected through small bottleneck windows in FMOFCu appear to be the reason for this peculiar behavior. The FMOFCu shows an estimated Kr/Xe selectivity of 36 at 0.1 bar and 203 K.     

Facile xenon capture and release at room temperature using a metal-organic framework: a comparison with activated charcoal

Two well-known metal-organic frameworks (MOF-5, NiDOBDC) were synthesized and studied for facile xenon capture and separation. Our results indicate that NiDOBDC adsorbs significantly more xenon than MOF-5, and is more selective for xenon over krypton than activated carbon.     

Dynamic adsorption properties of Kr and Xe isotopes in charcoal

Some batches of²³³U oxide product obtained from the reprocessing treatment of irradiated thorium rods, called J-rods in our plant, have been found to contain thorium as much as 85% and iron above 5% as impurities. This product has to be purified before sending for fabrication of the fuel. The present purification method consists of the following three steps: (1) preferential dissolution of U₃O₈ as compared to thoria, (2) a novel solvent extraction process, and (3) preferential precipitation of Th as oxalate leaving behind the entire U in the filtrate. Development and application of the present purification method to the above²³³U oxide proxduct are presented in this paper.     

Uptake and separation of Xe and Kr by a zeolitic imidazolate framework with a desirable pore window

Journal of Radioanalytical and Nuclear Chemistry - Crystalline solids of zeolitic imidazolate framework (ZIF)-69 with a suitable pore window size matching with atomic diameter of xenon is utilized...     

Sulfate separation by selective crystallization of a urea-functionalized metal-organic framework

Encapsulation of SO(4)(2-) into a Ni coordination framework functionalized with urea anion-binding groups allows selective separation of this strongly hydrophilic anion from a highly competitive aqueous environment.     

Kinetic separation of hexane isomers by fixed-bed adsorption with a microporous metal-organic framework

A three-dimensional microporous metal-organic framework Zn(BDC)(Dabco)0.5 (BDC = 1,4-benzenedicarboxylate, Dabco = 1,4-diazabicyclo [2,2,2]octane), having two types of intersecting pores to encapsulate linear hexane and to block branched hexanes, and thus exhibiting highly selective sorption with respect to n-hexane, has been successfully applied to the kinetic separation of hexane isomers by fixed-bed adsorption.     

Application of a chiral metal-organic framework in enantioselective separation

A modular approach for the synthesis of highly ordered porous and chiral auxiliary (Evans auxiliary) decorated metal-organic frameworks is developed. Our synthesis strategy, which uses known porous structures as model materials for incorporation of chirality via linker modification, can provide access to a wide range of porous materials suitable for enantioselective separation and catalysis. Chiral analogues of UMCM-1 have been synthesized and investigated for the enantioseparation of chiral compounds in the liquid phase and first promising results are reported.     

Adsorption separation of CO2 and N2 on MIL-101 metal-organic framework and activated carbon

In this work, the CO₂ and N₂ adsorption properties of MIL-101 metal-organic framework (MOF) and activated carbon (AC) were investigated using a standard gravimetric method within the pressure range of 0–30 bar and at four different temperatures (298, 308, 318 and 328 K). The dual-site Langmuir–Freundlich (DSLF) model was used to describe the CO₂ adsorption behaviors on these two adsorbents. The diffusion coefficients and activation energy E _a for diffusion of CO₂ in the MIL-101 and AC samples were estimated separately. Results showed that the isosteric heat of CO₂ adsorption on the MIL-101 at zero loading was much higher than that on the AC due to a much stronger interaction between CO₂ molecule and the unsaturated metal sites Cr³⁺ on MIL-101. Meanwhile, the dramatically decreased isosteric heats of CO₂ adsorption on MIL-101 indicated a more heterogeneous surface of MIL-101. Furthermore, the adsorption kinetic behaviors of CO₂ on the two samples can be well described by the micropore diffusion model. With the increase of temperature, the diffusion coefficients of CO₂ in the two samples both increased. The activation energy E _a for diffusion of CO₂ in MIL-101 was slightly lower than that in AC, suggesting that MIL-101 was much favorable for the CO₂ adsorption. The CO₂/N₂ selectivities on MIL-101 and AC were separately estimated to be 13.7 and 9.2 using Henry law constant, which were much higher than those on other MOFs.     

Laboratory-based separation techniques for insoluble compound mixtures: methods for the purification of metal-organic framework materials

In this article, techniques for separating mixtures of insoluble compounds are discussed with respect to the small quantities found in laboratory preparations, as opposed to industrial quantities. The techniques include separations based on density, surface area and differences in particle size. Also discussed are simple apparatus, readily available in the laboratory or from commercial suppliers, for achieving these techniques.     

Kinetic separation of carbon dioxide and methane on a copper metal-organic framework

Separation of carbon dioxide and methane is an important issue in upgrading low-quality natural gas. Adsorption equilibria and kinetics of CO(2) and CH(4) on a copper metal-organic framework (MOF), Cu(hfipbb)(H(2)hfipbb)(0.5) [H(2)hfipbb=4,4'-(hexafluoroisopropylidene) bis(benzoic acid)], were investigated to evaluate the feasibility of removing CO(2) from CH(4) in a pressure swing adsorption process using this new MOF adsorbent. The heat of adsorption of CO(2) on the Cu-MOF at zero-coverage (29.7 kJ/mol) is much lower than those on a carbon molecular sieve and a zeolite 5A adsorbent; and the heat of adsorption of CH(4) on the Cu-MOF (21.4 kJ/mol) is similar to that on the zeolite 5A adsorbent and smaller than that on a carbon molecular sieve. The Cu-MOF being investigated has apertures of (~3.5 × 3.5 ?), which favors the kinetically controlled separation of CO(2) and CH(4). The kinetic selectivity is found to be 26 at 298 K, and the overall selectivity (combining the equilibrium and kinetic effects) is about 25 for an adsorption separation process. These results suggest that the Cu-MOF adsorbent is an attractive alternative adsorbent for the CO(2)/CH(4) separation.     

Large-angle elastic scattering of 59.54keV photons by Kr and Xe

Large-angle elastic scattering of 59.54 keV photons by Kr and Xe is investigated. For Kr, the measured differential cross sections are in good agreement with predictions based on the second-order S-matrix of QED. In case of Xe, the measured cross sections are systematically larger than the predicted ones.     

Highly efficient separation of a solid mixture of naphthalene and anthracene by a reusable porous metal-organic framework through a single-crystal-to-single-crystal transformation

The three-dimensional crystalline porous metal-organic framework [Ni(2)(μ(2)-OH(2))(1,3-BDC)(2)(tpcb)](n) (1) [1,3-H(2)BDC = 1,3-benzenedicarboxylic acid; tpcb = tetrakis(4-pyridyl)cyclobutane] was used to separate a solid mixture of naphthalene and anthracene at room temperature via selective adsorption of naphthalene. The process involved a single-crystal-to-single-crystal transformation. The guest naphthalene molecules could be exchanged with ethanol, and the host, 1, could be regenerated by removal of the guest ethanol molecules.     

A microporous metal-organic framework with high stability for GC separation of alcohols from water

A novel 4(4) square grid microporous metal-organic framework (MOF) JUC-110 with 1D open channels has been synthesized, which shows exceptional hydrothermal stability and capability for separating alcohols from water in gas chromatographic (GC) separation.     

Photoelectron imaging of helium droplets doped with Xe and Kr atoms

Helium droplets doped with Xe and Kr atoms were photoionized by using VUV synchrotron radiation from the Advanced Light Source and the resulting photoelectron images were measured. A wide range of He droplet sizes, photon energies, and dopant pick-up conditions was investigated. Significant ionization of dopants was observed at 21.6 eV, the absorption maximum of 2p (1)P1 electronic excited state of He droplets, indicating an indirect ionization mechanism via excitation transfer. The photoelectron images and spectra reveal multiple photoionization mechanisms and pathways for the photoelectrons to escape the droplet. Specifically, they show sets of sharp peaks assigned to two mechanisms for Penning ionization of the dopant by He* in which the photoelectrons leave the droplet with no detectable energy loss, a broad, intense feature representing electrons that undergo significant energy loss, and a small amount of ultraslow electrons that may result from electron trapping at the droplet surface. The droplet-size dependence of the broad, intense feature suggests the development of the conduction band edge in the largest droplets seen here ((N) approximately 250,000).     

Elastic scattering of low and intermediate-energy electrons by Kr and Xe atoms

The many-body correlation forces, which act between the impinging electron and the bound electrons of the two heaviest rare gas atoms, are treated here using a newly developed correlation-polarisation potential that originates from the calculation of correlation energies in electronic bound-states of atoms and molecules. The new formulation of such forces, already tested by us for the lighter atomic targets, is particularly effective for the present systems and can be implemented very easily even for heavy atomic targets. The calculations reported in this paper show clearly that very good accord is obtained with more sophisticated theoretical treatments and with several experimental data on integral cross sections, momentum transfer cross sections and angular distributions.Von Humboldt — Prize Awardee 1992     

手性金属有机骨架材料的合成及其在对映异构体选择性分离中的应用

手性现象在自然界中广泛存在,手性分离在药物研发、农用化学、药理学、环境科学和生物学等诸多领域具有重要意义。手性金属有机骨架化合物材料(MOFs)是一类具有特殊拓扑结构和可设计的孔道结构的新型多孔材料,加之其比表面积高、孔隙率大、热稳定性良好和溶剂耐受性好等特性,使得MOFs在分析化学领域的应用与研究日益深入。本文简要综述了手性MOFs的合成方法,着重讨论了手性MOFs在对映异构体选择性分离方面的应用及相关机理,最后对该类材料的发展前景做了展望。