Calculation of spatial flow past an inclined flat plate with a detached shock wave

The results of a numerical analysis of a supersonic underexpanded jet impinging on an inclined flat plate are presented. The effects of the angle between the plate and the jet symmetry axis, the distance from the nozzle exit section, the exit Mach number, and the off-design conditions on the distribution of the gasdynamic parameters in the jet flowfield and on the plate surface are demonstrated. Specific features of the compressed layer and obstacle surface flows are revealed. The three-dimensional flow is simulated using the large particle method on the basis of the nonstationary Euler equations written in the cylindrical coordinate system. The calculated results are compared with experimental data. Moscow. Translated from Izvestiya Rossiiskoi Akademii Nauk, Mekhanika Zhidkosti i Gaza, No. 1, pp. 31–35, January–February, 1997.     

Calculation of supersonic gas flow over a ducted body in regimes with a detached shock wave

Calculations were made of the supersonic flow of an inviscid gas which does not conduct heat over two-dimensional and axisymmetric ducted bodies in regimes with a detached shock wave and completely subsonic gas velocity in the cylindrical duct. The investigated bodies have a pointed leading edge. The flow rate of the gas through the duct is assumed to be given. This corresponds to the presence in the exit section of the duct of a throttle or an impermeable barrier (in which case the flow rate is zero). The numerical algorithm used in the calculations is based on stabilization in time and Godunov's difference scheme [1] with separation of the shock wave. The integrated flow characteristics are given. The values of the wave resistance coefficient obtained in the calculations are compared with the values found using Taganov's approximate approach.Translated from Izvestiya Akademii Nauk SSSR, Mekhanika Zhidkosti i Gaza, No. 3, pp. 160–163, May–June, 1981.I thank A. N. Kraiko for regular consultations, Yu. B. Lifshits for a helpful comment, and V. A. Vostretsov for assisting in the work.     

Unsteady supersonic flow around blunt bodies with detached shock wave

The numerical method of calculating the supersonic three-dimensional flow about blunt bodies with detached shock wave presented in [1–3] is applied to the case of unsteady flow. The formulation of the unsteady problem is analogous to that of [4], which assumes smallness of the unsteady disturbances.The paper presents some results of a study of the unsteady flow about blunt bodies over a wide range of variation of the Mach number M=1.50– and dimensionless oscillation frequency l/V=0–1.0. A comparison is made with the results obtained from the Newton theory.     

Behavior of sonic lines in a shock layer behind a detached shock wave

A numerical investigation is made into the formation of local supersonic zones in the subsonic flow region between a detached shock wave and the surface of the body in the case of supersonic three-dimensional flow over conical bodies with opening angle _k = 120 ° of the cone in the range of Mach numbers M = 2.5–15.Translated from Izvestiya Akademii Nauk SSSR, Mekhanika Zhidkosti i Gaza, No.4 pp. 143–145, July–August, 1979.We thank G. I. Petrov for suggesting the problem and for helpful advice and O. M. Belotserkovskii for constant interest in the work.     

Hypersonic flow past a wing at large angles of attack with detached shock wave

The thin shock layer method [1–3] has been used to solve the problem of hypersonic flow past the windward surface of a delta wing at large angles of attack, when the shock wave is detached from the leading edge (but attached to the apex of the wing) and the velocity of the gas in the shock layer is of the same order as the speed of sound. A classification of the regimes of flow past a delta wing at large angles of attack has been made. A general solution has been obtained for the problem of three-dimensional hypersonic flow past the wing allowing for nonequilibrium physicochemical processes of thermal radiation of the gas at high temperatures.Translated from Izvestiya Akademii Nauk SSSR, Mekhanika Zhidkosti i Gaza, No. 3, pp. 149–157, May–June, 1985.     

Unsteady supersonic flow past a sphere moving through a thermal inhomogeneity

Translated from Izvestiya Akademii Nauk SSSR, Mekhanika Zhidkosti i Gaza, No. 2, pp. 186–189, March–April, 1989.     

Ideal gas flow behind a finite-amplitude shock wave

The equations of one-dimensional (with a plane of symmetry) adiabatic motion of an ideal gas are transformed to a form convenient for studying flows between a moving piston and a shock wave of variable intensity. The solution is found for the equations of a motion containing a shock wave which propagates through a quiescent gas with variable initial density and constant pressure. This solution contains four arbitrary constants and, in a particular case, gives an example of adiabatic shockless compression by a piston of a gas initially at rest.     

Boundary conditions on a shock wave in a supersonic flow

Translated from Zhurnal Prikladnoi Mekhaniki i Tekhnicheskoi Fiziki, No. 1, pp. 49–56, January–February, 1989.     

Calculation of supersonic equilibrium-dissociating air-xenon mixture flow past a blunt body

The flow of an equilibrium-reacting multicomponent three-element air-xenon mixture is numerically investigated. The effect of multicomponent diffusion on the convective heat transfer to the body surface is examined. The dependence of the convective heat transfer to the body surface and the total shock-layer spectral radiation flux P_m on the xenon concentration is obtained. A comparison of the calculated data for P_m and the experimental data of [2] gives good agreement. A simple approximation for the convective heat flux at the stagnation point as a function of xenon concentration is proposed.Translated from Izvestiya Akademii Nauk SSSR, Mekhanika Zhidkosti i Gaza, No. 4, pp. 156–164, July–August, 1991.In conclusion the authors wish to thank I. A. Sokolova for supplying data on the resistance coefficients of the various mixtures and S. A. Yunitskii for discussing the numerical method.     

Study of unsteady flow past bodies behind shock waves

Several theoretical and experimental studies have been devoted to the problem of the nonstationary action of the stream behind a shock wave on bodies of varied shape. In particular, in [1], the pressure and density are calculated for flow about bodies of the more typical shapes in the initial stage of the process. The basic relations which accompany the interaction of shock waves are considered in [2, 3]. The analysis of the phenomena of diffraction of shock waves on the sphere, cylinder, and cone is presented in [4]. Problems of unsteady flow about a wing are examined in [5, 6]. A detailed review of the foreign studies on unsteady flow is given in [7]. Of great practical interest is the question of the time for flow formation and the magnitudes of the unsteady loads during this period. Experimental investigations have been made recently [8, 9] in which some criteria are presented for estimating the bow shock formation time for supersonic flow about the sphere and cylinder with flat blunting. However the question of the formation time of the stationary pressure on the body surface is not referred to in these studies and no relationship is shown between the transient position of the reflected wave and the corresponding unsteady pressure on the surface. Moreover, in [8] the dimensionless time criterion is determined very approximately, independently of the Mach number of the shock wave. The present study was undertaken with the object of determining the basic criteria which characterize unsteady flow about bodies behind a plane shock wave which has time-independent parameters, and clarification of the shock wave reflected from the body and the pressure on the surface of the body during the transient period. The most typical body shapes were studied: 1) a cylinder with flat face aligned with the stream; 2) a spherically-blunted cylinder; and 3) a cylinder transverse to the stream. The experiments were conducted in a conventional shock tube using the single-diaphragm scheme. The measurements of the pressure on the models and the velocity of the incident shock wave were made using the technique analogous to that of [10, 11]. A highspeed movie camera was used to record the pattern of the wave diffraction on the body. The Mach number of the incident shock wave varied in the range from M=1.5 to M≈6.0, which corresponded to a range of Mach numbers M_∞ of the stream behind the shock wave from 0.6 to 2.1. The calculations of the required gas dynamic parameters for high temperatures were made with account for equilibrium dissociation of the air on the basis of the data of [10, 12, 13]. The magnitude of the relative maximal shock wave standoff Δ at the stagnation point obtained in the present experiments was compared with the values of Δ from other studies. In the case of the flat-blunted cylinder it was in good agreement with the results of [8–14], and in the case of the spherically-blunted cylinder and the transverse cylinder it was in agreement with the results of [15].     

Flow past a sphere of two co-axial supersonic streams

We investigate the flow past a sphere of a parallel supersonic stream which is nonuniform in magnitude; such a flow can be considered as two co-axial streams of an ideal gas. The problem is solved numerically by the method of establishment [1]. Supersonic flow of nonuniform magnitude and direction past blunt bodies and a plane wall was investigated in [2–5],Translated from Izvestiya Akademii Nauk SSSR, Mekhanika Zhidkosti i Gaza, No. 5, pp. 89–94, September–October, 1970.The author wishes to thank G. F. Telenin for his attention to the paper.     

Acceleration of a sphere behind planar shock waves

The paper presents the results of an investigation on the motion of a spherical particle in a shock tube flow. A shock tube facility was used for studying the acceleration of a sphere by an incident shock wave. Using different optical methods and performing experiments in two different shock tubes, the trajectory and velocity of a spherical particle were measured. Based upon these results and simple one-dimensional calculations, the drag coefficient of a sphere and shading effect of sphere interaction with a shock tube flow were studied.     

Particle and drop dynamics in the flow behind a shock wave

The results of an investigation of the dynamics of hard particles and liquid drops in the flow behind a transmitted shock wave are presented. From the equation of motion of a particle in the shock wave, relations for the displacement, velocity and acceleration as functions of time and certain velocity-relaxation parameters taking into account the properties of the gas and the aerodynamic drag of the particles are obtained for unsteady flow around the particles at an acceleration of 10³–10⁴ m/s². It is shown that the velocity-relaxation parameters are universal. Approaches to finding the aerodynamic drag of freely-accelerating bodies from the dynamics of their acceleration after being suddenly exposed to the flow are considered. It is established that under these conditions the drop dynamics observed can be well described in terms of the same velocity-relaxation parameters with account for linear growth of the transverse drop size. All the kinematic functions obtained are confirmed experimentally.     

Calculation of the diffusion combustion of a subsonic jet in a co-current supersonic flow

Translated from Zhurnal Prikladnoi Mekhaniki i Tekhnicheskoi Fiziki, No. 1, pp. 91–95, January–February, 1988.     

Isothermal flow past a blowing sphere

Steady, axisymmetric, isothermal, incompressible flow past a sphere with uniform blowing out of the surface is investigated for Reynolds numbers in the range 1 to 100 and surface velocities up to 10 times the free stream value. A stream-function-velocity formulation of the flow equations in spherical polar co-ordinates is used and the equations are solved by a Galerkin finite-element method. Reductions in the drag coefficients arising from blowing are computed and the effects on the viscous and pressure contributions to the drag considered. Changes in the surface pressure, surface vorticity and flow patterns for two values of the Reynolds number (1 and 40) are examined in greater detail. Particular attention is paid to the perturbation to the flow field far from the sphere.