用推广的李群约化法求解非线性薛定谔方程

用推广的经典李群约化法，得到了色散系数、非线性系数、补偿（或损失）系数为时、空变量函数时的非线性薛定谔方程的精确解.深入研究了非线性薛定谔模型的一般孤波解与线性调频孤波解在光纤通讯与光纤放大器中的潜在应用. 关键词： 李群约化 非线性薛定谔方程 光纤通讯     

暗孤子耗散阻尼的周期补偿

用计算模拟方法研究了暗孤子在用光纤放大器周期补偿损耗的光纤中的传播。暗孤子对在这种系统中传播时，其亮背景会产生自激的噪声。与光纤放大器配合使用法布里－珀罗滤波器，可以消除这种噪声，有利于暗孤子的长距离稳定传播。     

Amplification of picosecond pulses and gigahertz signals in bismuth-doped fiber amplifiers

We demonstrate the capability for amplification of picosecond pulses in two bismuth-doped alumosilicate fibers. A spectrally filtered supercontinuum source is used to provide a train of picosecond pulses at discrete wavelengths within the gain bandwidth of bismuth fiber amplifiers. With a 30 m length of active fiber, a small signal gain at 1160 nm of over 20 dB is observed. In addition, we assess the viability of amplification of high repetition rate signals in such amplifiers, applying a 10 GHz modulation to a continuous wave Raman fiber laser operating at 1178 nm, finding that such signals are amplified without noticeable distortion.     

Brillouin gain spectrum characterization in Ge-doped large-mode-area fibers

The dependence of Brillouin gain spectrum (BGS) characteristics, including the Brillouin frequency shift (BFS) and the BGS bandwidth, on germanium concentration in large-mode-area Ge-doped passive fibers is investigated theoretically and experimentally. The simulation results show that the BFS is inversely proportional to GeO₂ concentration, and the BGS bandwidth initially increases with the augment of GeO₂ concentration, and then decreases. The BGSs of four fibers with core diameters of 10 μm and 20 μm for different GeO₂ concentrations are compared experimentally. Experimental results demonstrate that with the same core diameter, the variations of BFS and BGS bandwidths with GeO₂ concentration accord with the simulation results. Additionally, the BGS characteristics of three large-mode-area passive fibers with diameters of 10 μm, 25 μm, and 30 μm are measured, which confirm that the increasing of the fiber diameters will cause the BGS bandwidth to broaden. We believe that these results can provide valuable references for modulating the high-power narrow-linewidth fiber lasers and Brillouin fiber amplifiers.     

光通信中的光电子器件讲座：第一讲 光电子器件在光纤通信中的应用与发展

文章介绍了光纤、激光器及光放大器等光电子器件在光纤通信的产生、发展中的关键作用,分析了现代光纤通信系统中的各种有源、无源光电子器件、并论述了21世纪全光网发展所需的几种典型的光电子或光子器件。     

Transmission capacity of erbium-doped fiber amplifiers as a criterion for quality of erbium-doped optical fibers

A new criterion—transmission capacity in the unsaturated gain regime—is proposed for comparing the quality of glasses for erbium-doped fiber amplifiers, considered as an element of an optical communication system. It is shown that, according to the criterion for the highest transmission capacity, amplifiers based on alumino-phosphate-silicate and zinc-sodium-germanate-silicate fibers are preferred for systems with separate C and L bands, respectively. In broadband systems, the highest transmission capacity is observed in amplifiers based on tellurite fibers.     

Optimized absorption in a chaotic double-clad fiber amplifier

Double-clad fibers with a doped single-mode core and a noncylindrical multimode chaotic cladding are shown to provide optimal pump-power absorption in power amplifiers. Based on the chaotic dynamics of rays in such fibers, we propose a quantitative theory for the pump-absorption ratio and favorably compare the predictions of the theory with numerical results obtained through an adapted beam-propagation scheme.     

大纤芯双模放大Bragg光纤的研究

设计了一种大纤芯实心Bragg光纤,并从理论上证明,利用这种光纤可以实现大纤芯的双模光纤放大器.纤芯的增大使制作光纤放大器的工艺变得简单,并且可以使泵浦光直接灌入纤芯,这样泵浦光与信号光可以最大限度的重合,从而提高了泵浦光的耦合效率.同时,纤芯的增大使光纤芯区的总能量得以增大,这样就可以得到高功率的光纤放大器.     

Variational analysis of propagation characteristics in thermally diffused expanded core fibers

We present a scalar variational method for the analysis of light-propagation characteristics in thermally diffused expanded core (TEC) fibers. The method leads to simple closed-form expressions regarding the mode field diameter, numerical aperture, waveguide dispersion as well as coupling losses produced by radial, longitudinal and angular misalignments. The dependence of coupling losses on the ‘taper ratio’ and normalized frequency is investigated and previous predictions that TEC fibers transmit light more effectively in free space over the order of millimeters, is confirmed. The coupling losses between small core diameter step-index fibers typically used in most erbium-doped fiber amplifiers and TEC-fibers is also considered.     

使用FBG及更短光纤的高效Er3+-Yb3+共掺双包层光纤放大器

提出在光纤放大器中,使用光纤布喇格光栅作为泵浦光反射镜,所需的双包层光纤可以缩短,同时至少保持了与没有光纤布喇格光栅作为反射镜时光纤放大器相同的性能.基于速率及传输方程,对使用和不使用光纤布喇格光栅的铒、镱共掺双包层光纤放大器的性能进行了数值模拟.结果表明,使用光纤布喇格光栅作为反射镜时光纤放大器可以获得与无光栅时相同的输出功率,但仅仅需要后者长度一半的光纤,无论是前向泵浦还是后向泵浦.对后向泵浦方式并使用光纤布喇格光栅作为反射镜,可获得最高的输出功率及光增益,同时使用了较短的光纤.     

光纤参量器件研究进展

综述介绍基于光纤四波混频效应的一些参量器件(放大器、频率转换器、相位共轭器等)的物理特性和工作性能;以及基于这些参量器件的新应用,比如可调谐辐射产生、相位敏感放大器、基于频率转换和色散的缓存以及实时采样等;最后就量子信息实验中的光子产生和频率转换等方面进行一些介绍。     

Generation of high order multi-bound solitons and propagation in optical fibers

We demonstrate experimental generation of multi-bound solitons of up to sextuple in an active FM mode-locked fiber ring laser operating under power saturation in the locking state. The ring laser consists of two booster optical amplifiers operating in saturation regime, an electro-optic phase modulator driven by a sinusoidal electrical wave and a length of dispersive fiber. The periodic phase modulation generates phase chirp of the generated lightwaves in the ring laser. The chirped phase state plays an important role in the phase matching condition for mode-locking as well as the stabilization and the determination of the bound states of multi-solitons. The formation of such high order multi-bound solitons is explained based on the chirping of the phase and the behavior of the optical pulse sequence in the near field region of the dispersive fiber. The propagation of these multi-bound solitons through single mode optical fibers is observed. Experimental and simulation results of bound solitons have been shown to follow similar trends.The propagation of these multi-bound solitons through single mode optical fibers is described. Their mutual interaction through such quadratic phase media shows the influence of the quadratic phase property on the differential phase of individual solitons of the bound group. Simulated results confirm the evolution of the bound solitons over dispersive single mode optical fibers.     

Reduction of fiber-nonlinearity-enhanced amplifier noise by means of phase-sensitive amplifiers

In optical fiber transmission systems near the zero-dispersion wavelength that use in-line erbium-doped fiber amplifiers (EDFA's), the enhancement of optical amplifier noise caused by four-wave mixing (FWM) in transmission fibers degrades signal-to-noise ratio (SNR) excessively. We theoretically show that the enhancement of amplifier noise by the FWM in transmission fibers can be effectively eliminated by implementing in-line phase-sensitive amplifiers (PSA's). Small-signal analysis of the nonlinear Schr?dinger equation shows that the transmission distance limited by the SNR of an in-line PSA system is expanded four times more than that of an in-line EDFA system.     

PSA高速常规单模光纤通信系统的传输性能及其与EDFA系统的比较

本文采用计算机系统仿真的方法研究了应用相敏光放大器(PSA)并附加DCF色散补偿的高速常规单模光纤通信系统的传输性能,并和相同速率的掺铒光纤放大器(EDFA)系统进行了比较.研究着重于传输速率、放大器间距对系统码间干扰限制距离的影响.结果表明PSA系统比EDFA系统更适合于高速率传输并具有更长的传输距离.而且,对PSA系统,在放大器增益正好补偿光纤损耗的条件下,存在一相应于最大码间干扰限制距离的最佳放大器间距.     

Fused angle-polished multi-points side-pumping coupler for monolithic fiber lasers and amplifiers

We have developed theoretical model to investigate characters of fused angle-polished side-pumping coupler for monolithic fiber lasers and amplifiers. In the simulation the interplay of different couplers is considered. Five pumping fibers with different polished angles are employed in the experiment. The results showed that, the backward coupling efficiency, forward and backward pumping leakage are lower than 4%, 8% and 10% respectively, while the forward coupling efficiency is about 100%, with the polished angle suitable for commercial fibers. The experimental results agree well with the simulations. Furthermore, we fabricate a two-points co-propagating fused angle-polished side-pumping coupler, with the coupling efficiency of 94.1% and 87.9%. These couplers are quite suitable for multi-points side-pumping high power monolithic fiber lasers and amplifiers.     

Effects of polarization-mode dispersion on fiber-based parametric amplification and wavelength conversion

We present a vector theory of four-wave mixing in optical fibers and use it to discuss the effect of polarization-mode dispersion (PMD) on the performance of parametric amplifiers and wavelength converters. We show that PMD distorts the gain spectrum and makes it less uniform than that expected in the absence of residual birefringence. PMD also induces large fluctuations in the amplified or wavelength-converted signal.     

Characteristics of supercontinuum generationin tapered fibers using femtosecond laser pulses

Drawing single mode fibers over a flame generates tapered fibers with waist diameters of approximately 1–3 micrometers and waist lengths of up to 90?mm. We demonstrate how the profile of such tapered fibers can be determined. We then characterize the white light that is generated in a variety of such fibers, showing its dependence on waist length and waist diameter and demonstrating its dependence on pulse parameters such as pulse duration, spectral position, and pulse power. A comparison with theoretical calculations using a nonlinear Schrödinger equation model including Kerr nonlinearities is given. Furthermore, we show XFROG spectrograms of the pulses propagating through tapered fibers, confirming the model of soliton splitting in the anomalous dispersion regime.     

High-gain Brillouin amplification: an analytical approach

We derive a closed-form approximate analytical formula for the gain of a Brillouin fiber amplifier operating in the depleted pump regime. We take into account the material loss of the medium, which is a strong effect in optical fibers. We validate obtained results numerically and experimentally. The presented analysis can be used to accurately predict the performance of high-gain Brillouin fiber amplifiers.     

Development and Infrared Applications of Chalcogenide Glass Optical Fibers

Chalcogenide glass fibers based on sulphide, selenide, telluride, and their rare earth doped compositions are being actively pursued both at the Naval Research Laboratory in Washington, D.C. (NRL) and worldwide. Great strides have been made in reducing optical losses using improved chem ical purification techniques, but further improvements are needed in both purification and fiberization technology to attain the theoretical optical losses. Despite this, current singlemode and multimode chalcogenide glass fibers are enabling numerous applications. Some of these applications include laser power delivery, chemical sensing, imaging, scanning near field microscopy spectroscopy, fiber infrared (IR) sources lasers, amplifiers, and optical switches. The authors assert that the research and development of chalcogenide glasses will grow in the foreseeable future, especially with respect to improvements the optical quality of the fibers and the performance of the fibers in existing future applications.     

Theoretical study of stimulated Raman scattering in long tapered fiber amplifier

A model that is based on the propagation equation and coupled mode theory is introduced in order to describe stimulated Raman scattering(SRS) effects in long tapered fiber amplifiers.Based on the presented model,fiber amplifiers with uniform and long tapered fibers are theoretically and numerically simulated.It can be drawn from the results of our simulations that the long tapered fiber has the advantage in suppressing SRS when applied in fiber laser amplifiers.Our results can provide guidance in the designing of system configuration in long tapered-fiber-based fiber laser systems.