Turbulent periodic flow and heat transfer in a rectangular channel with detached V-baffles

This paper presents a numerical analysis of turbulent periodic flow and heat transfer in a rectangular channel with detached V-baffles. The computations are based on the finite volume method with the SIMPLE algorithm for handling the pressure–velocity coupling and using the QUICK scheme for the convection terms. Air is used as the test fluid with the air flow rate in terms of Reynolds numbers ranging from 3000 to 20,000. The effects of different detached-clearance ratios (c/H, CR) of 0.0, 0.05, 0.1, 0.15, and 0.2, baffles-pitch to square channel-diameter ratio (pitch ratio (p/H), PR) is 1.0, baffles-height to square channel-diameter ratio (blockage ratio (b/H), BR) is 0.10, and attack angle (α) is 45? on heat transfer, friction factor and thermal enhancement factor are investigated numerically. It is found that a pair of counter-rotating vortices (P-vortex) caused by the baffles can induce impingement/attachment flows repeatedly on the rectangular channel walls leading to a greater increase in the heat transfer over the test channel. The maximum thermal performance and heat transfer are found to be about 1.5 and 3.3, respectively for CR = 0.05 and Re = 3000, while the highest pressure loss is about 21.5 in the case of CR = 0.2 and Re = 20,000.     

Experimental investigation of heat transfer from different pin fin in a rectangular channel

In this study, the effect of both hexagonal pin fins (HPFs) and cylindrical pin fins (CPFs) into the rectangular channel on heat transfer augmentation, Nusselt number and friction factor were experimentally investigated. In planning of the experiments, different Reynolds number, pin fin array, pin fin geometry and the ratio of the distance between pin fin spacing (s) to the pin fin hydraulic diameter (s/D_h) were chosen as the design parameters. Air was used as the fluid. The Reynolds number, based on the channel hydraulic diameter of the rectangular channel, was varied from 3188 to 19531. In the experiments, the heating plate was made of stainless steel foil. The foil was electrically heated by means of a high current DC power supply to provide a constantly heated flux surface. The heat transfer results were obtained using the infrared thermal imaging technique. The heat transfer results of the hexagonal pin fins (HPFs) and cylindrical pin fins (CPFs) are compared with those of a smooth plate. Best heat transfer performance was obtained with the hexagonal pin fins. The maximum thermal performance factor ((?), was obtained as Re = 3188, staggered array, s/D_h = 0, ? = 2.28.     

Liquid crystal heat transfer measurements in a rectangular channel with solid and slit rib

An experimental investigation on the heat transfer effectiveness of solid and slit ribs mounted on the bottom surface of a rectangular channel has been carried out at Reynolds numbers of 13400, 22600, 32100 and 40800. The rib height to hydraulic diameter ratio (e/D _h)set during experiment is equal to 0.0624. The surface Nusselt number results from transient liquid crystal thermography are presented. The heat transfer enhancement performance analysis has been carried out using entropy generation principle. The slit rib is superior to solid rib from both heat transfer augmentation and pressure penalty point of view. The performance of the slit rib is a function of the open area ratio (β) and the location of the slit (b) from the bottom test surface. The optimum open area ratio is 20% and the slit located symmetrically from the top and bottom surface of the rib is the optimum location of the slit. The heat transfer augmentation of the slit rib (β=20%) is 61% in comparison to 40% for the solid rib at Re=32100 and the pressure penalty for the slit rib is 7% lower than the solid rib. The entropy generation for the slit rib is 33% less than that of the solid rib.     

Light-induced heat and mass transfer in a single-component gas in a capillary

A theoretical analysis is presented of light-induced heat and mass transfer in a single-component gas in a capillary tube at arbitrary Knudsen numbers. Surface and collisional mechanisms of transfer are analyzed, due to differences in accommodation coefficient and collision cross section between excited-and ground-state particles, respectively. Analytical expressions for kinetic coefficients characterizing the gas drift and heat transfer in a capillary tube are obtained in the limits of low and high Knudsen numbers. Numerical computations are performed for intermediate Knudsen numbers. Both drift and heat fluxes are determined as functions of the light beam frequency. In the case of an inhomogeneously broadened absorption line, the light-induced fluxes are found to depend not only on the sign, but also on the amount, of light beam detuning from the absorption line center frequency.     

Effect of emitting electrode number on the performance of EHD gas pump in a rectangular channel

Previous studies have shown that electric field in the form of corona wind can be used for gas pumping. It has also been shown that the maximal volume flow rate can be achieved by an optimal design and arrangement of electrode(s) involved. In this study, the number of emitting electrodes has been considered for its effects on the pump performance. To seek the relation between the electrode number and pump performance, an EHD gas pump with three configurations (4, 12, and 28 emitting electrodes) is critically evaluated by experimental measurements and numerical simulations.     

微小型矩形槽道平板热管传热性能的数值模拟

在充分考虑槽道内汽-液界面剪切摩擦力下,建立了微小型矩形槽道平板热管的数学模型,通过迭代计算得出工质质量流量、流体和蒸汽平均流速、汽一液界面弯月面半径及蒸汽和液体压力沿轴向分布规律,最后对热管外壁面温度值的计算结果和实验结果进行了比较,两者数值基本一致,证明了所建数学模型与实际相符,对热管的理论分析具有指导意义。     

On calculation of the heat flux from a spherical particle in a molecular gas

The problem of calculation of the heat flux from a spherical particle in a molecular gas is considered. The results of numerical calculations for the collision integral similar to that in the BGK model are presented under the condition of purely diffuse reflection of gas molecules from the surface of a particle.     

Calculation of the drag and heat transfer from a sphere in the gas flow in a cylindrical channel

A numerical experiment on the simulation of heat transfer from a sphere to a gas flow in a cylindrical channel in the Stokes and transient flow regimes has been described. Radial and axial profiles of the gas temperature and the dependences of drag coefficient C_d of the body and Nusselt number Nu on Reynolds number Re have been calculated and analyzed. The problem of the influence of the early drag crisis for a sphere on its heat transfer to the gas flow has been considered. The estimation of this phenomenon has shown that the early drag crisis of the sphere in a strongly turbulent flow causes a reduction in heat transfer from the sphere to the gas by three to six times (in approximately the same proportion as for its drag coefficient).     

Influence of the gas density on the motion of a free plasma piston in the railgun channel

The influence of the gas density on the acceleration of a plasma armature inside the railgun channel filled with various gases (xenon, air, or helium) under atmospheric pressure is investigated experimentally and theoretically. It is shown that, after the discharge current has reached a steady value, the velocity of the glowing plasma front ceases to grow and remains constant as long as so does the current. The length over which the velocity saturates is equal to a few centimeters, i.e., is much shorter than the railgun channel length. The maximum velocity of the plasma piston meets a predicted limit, which is determined by the drag of the medium and a decrease in the acceleration of the plasma armature when a fraction of the material evaporated from the rails is involved into motion. The plasma composition depends on the electrode material. The velocities measured when the channel is filled with helium (V = 17.5 km/s) or air (V = 9.8 km/s) noticeably exceed the sound speed inside the plasma piston (5–7 km/s).     

Vibrating rectangular plate with a free edge: The effect of a concentrated mass and an internal support

It is shown that use of a polynomial coordinate function and the Rayleigh-Schmidt method constitute a convenient approach for determining the fundamental frequency of vibration of the title system. Experimental results are presented for the case where three edges are rigidly clamped; and it is shown that the values are in good engineering agreement with the analytical predictions.     

Mathematical simulation of heat and mass transfer in a cylindrical channel versus the tangential momentum accommodation coefficient

The process of heat and mass transfer in a long cylindrical channel has been considered in terms of the mirror–diffuse model of the Maxwell boundary condition. The Hazen–Williams equation is used as a basic equation of the process kinetics. A constant temperature gradient is maintained in the channel. The heat and mass fluxes through the cross section of the channel versus the tangential momentum accommodation coefficient have been calculated in a wide range of the Knudsen number. The heat flux profiles have been constructed. A comparison with relevant published data has been carried out.     

The pulsating laminar flow in a rectangular channel

The finite difference method is used to solve the task of the developed pulsating laminar flow in a rectangular channel. The optimum of the difference scheme parameters was determined. Data on the amplitude and phase of the longitudinal velocity oscillations, the hydraulic and friction drag coefficients, the shear stress on the wall have been obtained. Using the dimensionless value of the frequency pulsations two characteristic regimes — the quasisteady-state regime and the high-frequency regime have been identified. In the quasi-steady-state regime, the values of all hydrodynamic quantities at each instant of time correspond to the velocity value averaged over the cross section at a given moment of time. It is shown that in the high-frequency regime, the dependences on the dimensionless oscillation frequency of oscillating components of hydrodynamic quantities are identical for rectilinear channels with a different cross-sectional form (round pipe, flat and a rectangular channels). The effect of the aspect ratio of the rectangular channel sides channel on the pulsating flow dynamics has been analyzed.     

Exploration of the Townsend regime by discharge light emission in a gas discharge deviceExploration of the Townsend regime by discharge light emission in a gas discharge deviceExploration of the Townsend regime by discharge light emission in a gas discharge deviceExploration of the Townsend regime by discharge light emission in a gas discharge deviceExploration of the Townsend regime by discharge light emission in a gas discharge device

The Townsend discharge mechanism has been explored in a planar microelectronic gas discharge device （MGDD） with different applied voltages U and interelectrode distance d under various pressures in air. The anode and the cathode of the MGDD are formed by a transparent SnO2 covered glass and a GaAs semiconductor, respectively. In the experiments, the discharge is found to be unstable just below the breakdown voltage Ub, whereas the discharge passes through a homo- geneous stable Townsend mode beyond the breakdown voltage. The measurements are made by an electrical circuit and a CCD camera by recording the currents and light emission （LE） intensities. The intensity profiles, which are converted from the 3D light emission images along the semiconductor diameter, have been analysed for different system parameters. Dif- ferent instantaneous conductivity ~t regimes are found below and beyond the Townsend region. These regimes govern the current and spatio-temporal LE stabilities in the plasma system. It has been proven that the stable LE region increases up to 550 Torr as a function of pressure for small d. If the active area of the semiconductor becomes larger and the interlectrode distance d becomes smaller, the stable LE region stays nearly constant with pressure.     

Observation of the presuperfluid regime in a two-dimensional Bose gas

In complementary images of coordinate-space and momentum-space density in a trapped 2D Bose gas, we observe the emergence of presuperfluid behavior. As phase-space density ρ increases toward degenerate values, we observe a gradual divergence of the compressibility κ from the value predicted by a bare-atom model, κ(ba). κ/κ(ba) grows to 1.7 before ρ reaches the value for which we observe the sudden emergence of a spike at p = 0 in momentum space. Momentum-space images are acquired by means of a 2D focusing technique. Our data represent the first observation of non-mean-field physics in the presuperfluid but degenerate 2D Bose gas.     

Experimental verification of a cross effect between heat and momentum transport in a molecular Knudsen gas

The pressure difference induced by a magnetic field in a heat conducting Knudsen gas is investigated. The effect results from molecular angular momentum polarization produced in molecule-surface collisions. Data obtained for N₂ are well described in terms of gas kinetic theory.     

蒸汽加热竖直矩形窄通道流动沸腾换热的研究

为研究板式换热器内(蒸发-冷凝器)两相换热机理及流型特征,建立单侧蒸汽加热竖直矩形窄通道可视化实验系统,并进行实验研究。结果表明:在窄通道换热中,以核态沸腾换热机理更为活跃,流动沸腾受到抑制,表面换热系数最大值出现在核态沸腾区域;随着入口温度越高,表面换热系数最大点往左迁移,随着质量流量的增大,过冷段增加,沸腾起始点升高,表面换热系数最大点往右移;矩形窄通道主要出现泡状流、合并汽泡流、搅拌流和环状流四种流型;将实验数据与现有流型图进行对比,发现流型转变与质量流量、通道尺寸及加热方式有关。该研究为更好的设计板式换热器提供了理论依据。