Messung von Plattenschwingungen sehr kleiner Amplitude durch Lichtstrommodulation

An optical method detecting extreme small mechanical amplitudes of vibrating plates was developed. The two components of the plane vibration were measured with an uncertaintyΔa<10^?8 cm, the flexural vibration was measured with an uncertaintyΔa<10^?6 rad. The method is based on the modulation of a small light beam by a vibrating boundary (measuring plane vibrations) or on the modulation of a vibrating light beam by a fixed boundary (measuring flexural vibrations). The possible amplitude resolution power was calculated to beΔa<10^?10 cm. Examples of amplitude distributions of thin vibrating quartz plates are given.     

用激光自混合干涉测量扬声器的Q值

用激光自混合干涉方法测量扬声器振动,从扬声器振动引起的自混合干涉信号测量扬声器振动速率.由正弦波激振扬声器测量振速的幅频特性曲线,谐波中包含扬声器谐振频率的方波激振扬声器测量振速衰减曲线,分别按谐振法和衰减法测量得到扬声器的品质因数约13.3和10.2.由于方波激励时扬声器有谐波振动成分,由方波激励获得的衰减曲线测量得...     

在粗糙表面上用液晶空间光调制器进行振动测量

为实现在一段时间内连续实时观测振动物体的全息干涉图形,采用覆盖铝箔的喇叭作为振动物体,利用铝箔原有未经特殊处理表面反射的漫反射光成像,并用光寻址液晶空间光调制器(Liquid crystal-sparial lightmodulator,LC-SLM)作为全息记录载体,来实现振动测量。实验中采用时间平均干涉测量法,得到了不同振动频率下物体的干涉图形。同时在连续改变振动物体的振动频率时,可以清晰地观察到物体振动全息干涉图形的变化过程,即近实时的全息干涉图形。     

Laser heterodyne vibration measuring method

This paper introduces a heterodyne vibration measuring method: a new signal processing device with a microprocessor has been designed. The most important advantages of this method are that the vibrating amplitude and frequency of the object can be measured simultaneously, with a measuring accuracy of 1% and 0.5% respectively. Better heterodyne signals can be seen by using glass microspheres as scatterers. By using their strong backward scattering, the vibrations in non-optic axis directions can be measured. This method can be used for measurements in which the vibrating body cannot be loaded or is at a long distance.     

2-D激光多普勒振动测试仪的研究

本文阐述了一种2-D多普勒振动测试仪的基本测试原理和方法,分析了影响测量精度的要素,并就信号处理电路进行了设计.该仪器能同时非接触地测量振动体两个方向振动的频率和幅度,测量范围大、精度高.     

基于双色条纹投影的薄膜振动模式分析

结构光投影和条纹时间平均分析技术已被用于振动模式分析中,但由于投影单色正弦条纹时振动薄膜变形条纹傅里叶谱中零频涵盖范围较大,会限制滤波窗的选取范围,从而影响模式的最终重建结果。为提高振动模式重建的准确性,提出了一种利用π相移正弦条纹投影进行薄膜振动模式分析和振幅重建的方法,通过处理两个通道的条纹分量达到消除零频的目的。给出了该方法的理论分析,完成了相应的计算机模拟,分析了影响测量精度的因素。通过与投影单色正弦条纹的振动模式重建结果对比,表明该方法有较高的重建精度。不同激励频率下的实际薄膜振动实验结果也证明了该方法正确可行。     

Experimental determination of damping of plate vibrations in a viscous fluid

A method of determining the aerodynamic-drag coefficient of flat vibrating plates from the vibrogram of free damping vibrations of cantilever-fixed duralumin samples has been developed. From the results of our experiments, simple approximating formulas determining the decrement of damping vibrations and the aerodynamic-drag coefficient through the dimensionless vibration amplitude and the Stokes parameter are proposed. The approach developed in this study for determining the aerodynamic-drag coefficient of a vibrating plate can be a useful alternative to purely hydrodynamic methods of finding the drag of vibrating solids.     

Vibration Analysis by Phase Shifting Digital Holography

Phase-shifting digital holography has been used for the study of vibrating objects. The time-averaged complex amplitude of Fresnel diffracted field due to a vibrating object was obtained by using a three-step phase-shifting algorithm. Taking the inverse Fresnel transform of the complex amplitude resulted in an image of the object superimposed with Bessel fringes. The Bessel fringes are contour map of the vibration amplitude. By sinusoidally modulating the phase of the reference beam at the vibration frequency, the brightest fringe could be shifted to points of interest, thus extending the measurable range of vibration amplitude.     

叶轮机械叶片流体激振安全性的全功能分析

本文提出了对叶轮机械叶片流体激振安全性实行全功能数值分析的新概念和方法。实现气动力学和弹性力学的弱耦合计算,由弹性力学方法确定三维振型,用振荡流体力学方法确定三维条件下的三维振荡流场,确定在各种振幅条件下的非定常气动力作功与阻尼功,引入气动功等于阻尼功条件下的平衡振幅概念。根据平衡振幅确定叶片流体激振的动应力,并进行寿命评估。这种全功能分析将使叶轮机械流体激振的安全性分析更加符合工程实际的需要,也能够解释大量的流体激振破坏不属于瞬时突然破坏,而是一种疲劳破坏。     

INTERACTION BETWEEN A LIQUID LAYER AND VIBRATING PLATES: APPLICATION TO THE DISPLACEMENT OF LIQUID DROPLETS

Various experiments have been performed to study the interaction of a liquid layer and vibrating plates. A liquid layer deposited on a vibrating plate exhibits a deformation of the surface with a high amplitude of vibration (larger than 1 μm at 30kHz). Furthermore, a water droplet placed on the vibrating plate moves towards an antinode of vibration. These non-linear phenomena are explained by the action of acoustic radiation pressure. An application to the displacement of droplets is presented.     

Vibration measurement by vibrating-plate holograms

If a hologram of a vibrating object is recorded on a photographic plate which vibrates synchronously with the object, the reconstructed image produces equi-amplitude fringes of the object vibration, the amplitude of which is reduced by a constant determined from the amplitude of the plate vibration. This phenomenon can be used as a method to extend the measurable range of vibration amplitudes, and some experimental results are shown.     

Analysis and experimental concepts of the vibrating wire alignment technique

The vibrating wire alignment technique is a method which, by measuring the spatial distribution of a magnetic field, can achieve very high alignment accuracy. The vibrating wire alignment technique can be applied to fiducializing magnets and the alignment of accelerator straight section components, and it is a necessary supplement to conventional alignment methods. This article gives a systematic summary of the vibrating wire alignment technique, including vibrating wire model analysis, system frequency calculation, wire sag calculation, and the relation between wire amplitude and magnetic induction intensity. On the basis of this analysis, this article outlines two existing alignment methods, one based on magnetic field measurement and the other on amplitude and phase measurements. Finally, some basic experimental issues are discussed.     

Measurement of Sectional Profile of a Cylinder using a Sinusoidally Vibrating Light with Sinusoidal Intensity

A method for accurately measuring a sectional profile of a cylinder is proposed in which a sinusoidally vibrating sinusoidal grating is used to generate a sinusoidally vibrating sinusoidal intensity distribution. A light coming from the top point of the cylinder surface is extracted with an optical system to make an image of this point. A sectional profile of the cylinder is measured by detecting a phase of a time-varying signal contained in the image intensity at a position where the amplitude of the signal is maximum. Detection of the amplitude and the phase is carried out easily and exactly.     

双光路电子散斑振动测量系统

本文给出了一种双光路电子散斑振动测量系统,该系统结合了普通ESPI离面振动测量光路和退敏感光路,既能对较大振幅范围的振动进行定性观测,又能实现全场自动定量分析,同时避免了相位去包裹处理.系统具有较高的抗干扰能力,可以应用于实际工程中复杂非连续结构的振动特性分析.     

流体低速绕流振动圆柱对流换热数值研究

运用Fluent的动态网格技术,对空气低速绕流振动圆柱的对流换热进行了研究,分析了流动和振动参数对换热的影响。数值计算表明,在本文计算范围内,壁面振动可使换热强化,最大可强化9倍,换热的强化随振幅和频率的增大而增大。场协同分析表明,圆柱振动强化换热的原因在于速度场和温度梯度场之间的协同程度得到了改善。     

Granular Leidenfrost effect in vibrated beds with bumpy surfaces

The effects of subjecting a bed of granular materials to horizontal vibrations by a bumpy oscillating surface have been investigated computationally in this study. The behaviour of the granular bed is determined by the vibration conditions applied which include the vibrating frequency and amplitude as well as the bumpiness of the oscillating surface. Under sufficiently vigorous vibration conditions, the granular Leidenfrost effect whereby the entire granular bed is levitated above the vibrating base by a layer of highly energetic particles may be observed. Granular temperature profiles of systems that exhibit the granular Leidenfrost effect indicate an unequal distribution of energy between particles near the vibrating base and those in the bulk. A bumpy oscillating surface was also observed to be more effective at introducing perturbations and transferring energy into a granular bed. The granular Leidenfrost effect can be induced by the application of larger grain sizes of particles constituting the bumpy vibrating base under vibration conditions that are normally insufficient for the onset of the effect. Lastly, a phase diagram which can be utilized for predicting the behaviours of granular beds that are subjected to oscillations by various types of bumpy surfaces has been constructed based on the simulation results obtained.     

Measurement of vibration with Young's fringe modulated speckle patterns in a photorefractive correlator

A technique has been proposed to analyze small in-plane component of vibrations by measuring the fringe shift, and analysing the correlation output of captured vibrating Young's fringes with a photorefractive correlator. Fringes are formed due to interference between the reconstructed speckled beam recorded for stationary object beam, and vibrated speckled beam transmitting through a BaTiO₃ crystal after introducing a small shift in the diffuser position. The correlation peak intensity is affected due to mismatch of vibrations between two piezo-mirrors in the object beam. High correlation output gives an indication of the frequency matching of known reference and unknown vibrations, thus giving information on the frequency of vibration. Vibration amplitudes of the order of a wavelength of light have been measured by counting the number of fringes passing past a line in the observation plane.     

Horizontal segregation of mono-layer granules coordinated by vertical motion

We experimentally investigate the segregation of a binary mixture of spherical beads confined between two horizontal vertically vibrating plates. The two kinds of beads are of equal diameter and mass but have different restitution coefficients. Segregation occurs in particular ranges of vibration amplitude and frequency. We find that the collisions between beads at an angle to the horizontal plane induce an effective horizontal repulsive force. When one or both bead types bounce up and down in synchronization, the effective repulsive force between the two types of beads is likely to be larger than that found within a single bead type, resulting in the mixture segregating. Non-horizontal collisions also play a role in stabilizing the segregation state by transferring the horizontal kinetic energy back into vertical motion.     

纳米ZnO薄膜的反射及偏振特性研究

用电子束蒸发镀膜法制备了纳米ZnO薄膜．通过测量其X射线衍射谱,计算出纳米ZnO颗粒的平均粒径大小为30nm．实验研究了纳米ZnO薄膜的反射和偏振性质,结果表明：当振动方向平行于入射面的线偏振光（简称P光）入射纳米ZnO薄膜时,不存在严格意义上的布儒斯特角,但对于入射角却存在一个临界角β．当入射角小于β时,反射光的振动面随着入射角的增大向左旋转;当入射角大于β时,振动面转而向右旋转;当振动方向垂直于入射面的线偏振光（简称S光）入射纳米ZnO薄膜时,反射光的振动面始终向左旋转．     

单自由度非线性保守系统作大振幅振动时周期的计算方法

简要介绍了单自由度非线性保守系统作大振幅振动时周期的计算方法,并给出了几个常见典型振动问题的周期公式．