Characterization of the passive films on electrodeposited Fe-Ni-Cr alloys in borate solution at pH 8.4

The corrosion properties of the passive layers formed on iron-nickel-chromium electrodeposits of Fe₂₉Ni₅₁Cr₂₀ were investigated in 0.3 M borate solution at a‘ pH of 8.4. On the basis of measurements by cyclic voltammetry, chronopotentiometry and electrochemical impedance spectroscopy, a low passive dissolution/corrosion rate was identified for the electrodeposited Fe-Ni-Cr alloys due to the nature of the established corrosion layer. The stability of this passive layer was further enhanced after corrosion under oxidizing conditions. Mössbauer spectroscopic measurements confirmed the existence of a thin passive layer on the amorphous electrodeposits.      

Effect of oxidation of nitride coatings on corrosion properties of Ti-6Al-4V alloy in 0.9% NaCl at 40°C

The corrosion properties of Ti-6Al-4V alloy with oxidized thermodiffusion nitride coatings were investigated in isotonic 0.9% solution of NaCl at temperature of 40°C. It was shown that modification of nitride coatings by oxygen leads to a deterioration of the protective properties of nitrided surface of Ti-6Al-4V alloy. The protective properties of the alloy with nitride coatings modified by oxygen are determined by the composition of formed surface oxynitride film.      

Fabrication of superhydrophobic surface of stearic acid grafted zinc by using an aqueous plasma etching technique

A stable superhydrophobic surface of stearic acid grafted zinc was fabricated with two steps, that is, the zinc surface was firstly treated with glow discharge electrolysis plasma (GDEP) and then followed by a grafted reaction of stearic acid onto the treated zinc surface. Results indicated that the wettability of zinc substrate changed from superhydrophily to superhyphodrobicity with a water contact angle (CA) up to 158° and a water sliding angle (SA) less than 5°. The surface morphology and composition were characterized by scanning electron microscopy (SEM) and X-ray diffraction (XRD), respectively.      

The first synthesis of 3-deoxyoripavine and its utilization in the preparation of 10-deoxyaporphines and cyprodime

The synthesis of 3-deoxyoripavine (7) was realized as a novel and promising intermediate towards the synthesis of the important class of dopaminergic and/or serotonergic 10-deoxyaporphines and the special pharmacological tool µ opioid antagonist cyprodime. Generally, the preparation of these valuable biologically active compounds was achieved in remarkable yields.      

Mechanochemical synthesis of thenoyltrifluoroacetone-1,10-phenanthroline europium complex

The paper considers the possibilities for mechanochemical synthesis of rare earth complexes. The complex Eu(TTA)₃·phen (HTTA — 2-thenoyltrifluoroacetone, phen — 1,10-phenanthroline) is synthesized by mechanical treatment of a mixture of EuCl₃.6H₂O, HTTA, phen and NaOH in planetary ball mill Pulverisette 7 for 30 min at 800 min^?1. The non reacted starting reagents and reaction side products are separated by treating activated mixture with water-ethanol solution following a procedure proposed in the literature. The elemental composition, X-ray diffraction pattern, IR spectra, optical properties (excitation and emission spectra, luminescence lifetime) and morphology of the mechanochemically synthesized complex are compared with those of the complex prepared from solution by the conventional method. The results confirm close similarity in the molecular structure and identity of the elemental composition, X-ray diffractograms and fluorescence properties of the compounds prepared by both methods.      

Copper(I) π-complexes with allyl derivatives of heterocyclic compounds: structural survey of their crystal engineering

In this review an exhaustive crystallochemical analysis of copper(I) π-complexes with allyl derivatives of heterocyclic compounds has been performed. Structural genesis of inorganic constituents starting from the simplest units to the most complicated aggregates was considered taking into account the specific role of Cu-(C=C) interaction, the construction of the organic ligands, the basicity and nucleophilic activity of their heteroatoms, as well as olefin Cu(I) π-complex preparation route.      

Effect of hydrothermal treatment on the structure of an aluminosilicate polymer

The effect of hydrothermal treatment on the structure of an aluminosilicate polymer prepared by a polycondensation reaction between silicate and hydroxoaluminate in alkaline aqueous solution was studied. The structural changes were investigated using X-ray diffraction analysis, Fourier-transform infrared spectroscopy, scanning electron microscopy imaging and thermogravimetric analysis. The results indicated that the amorphous aluminosilicate polymer transformed into a crystalline product during the hydrothermal treatment at 145°C. The crystalline phase was identified as a mineral of the zeolite group, most likely phillipsite. This transformation required an alkaline environment during the hydrothermal treatment.      

Enantioselective Michael additions of aldehydes to nitroalkenes catalyzed with ionically tagged organocatalyst

Enantioselective organocatalytic Michael additions affords useful building blocks for many biologically and medicinally relevant compounds. Ionically-tagged diphenylprolinol silyl ether efficiently catalyzes several Michael additions of aldehydes to nitroalkenes in ionic liquids. The Michael additions work well in ionic liquids; yields up to 95% and enantioselectivities up to 95% ee were achieved. Furthermore, in some cases, the catalytic system was reusable.      

Physico-chemical properties investigation of softwood surface after treatment with organic anhydride

Wood originating from a softwood species was subjected to chemical treatment by reaction with succinic anhydride in N, N-dimethylformamide at different concentration values. Fourier transform infrared spectroscopy and X-ray photoelectron spectroscopy analysis were used to study changes that occurred on a softwood surface. The extent of chemical treatment on softwood was evaluated by determining the weight percent gain values. Thermal properties of modified softwood and the water absorption were also evaluated. The chemical treatment with succinic anhydride influenced the thermal stability of the softwood samples with increasing anhydride concentration levels.      

Application of positron spectroscopy for investigation of threshold space of oil-gas rocks

This article considers the possibility of applying the positron annihilation spectroscopy method for investigating the pore space of rocks from oil-gas and methane-coal deposits. The diagnostics of the structure was performed using the method of spectrometry of angular correlation of annihilation rays (ACAR). Using the samples of porous silicon, the authors have shown the applicability of the ACAR method for determination of the average dimensions of spherical and cylindrical nanosized objects and their concentration      

Three–step method to determine the eutectic composition of binary and ternary mixtures

A three-step method to determine the eutectic composition of a binary or ternary mixture is introduced. The method consists in creating a temperature–composition diagram, validating the predicted eutectic composition via differential scanning calorimetry and subsequent T-History measurements. To test the three-step method, we use two novel eutectic phase change materials based on \(\mathrm{Zn}(\hbox {NO}_3)_2\cdot 6\mathrm{H}_{2}{\mathrm O}\) and \(\mathrm{NH}_4\mathrm{NO}_3\)   respectively \(\mathrm{Mn}(\hbox {NO}_3)_2\cdot 6\mathrm{H}_{2}{\hbox {O}}\) and \(\mathrm{NH}_4\mathrm{NO}_3\) with equilibrium liquidus temperatures of 12.4 and 3.9  \(\,^{\circ }\mathrm {C}\) respectively with corresponding melting enthalpies of 135 J \(\mathrm{g}^{-1}\) (237 J \(\mathrm{cm}^{-3}\) ) respectively 133 J \(\mathrm{g}^{-1}\) (225 J \(\mathrm{cm}^{-3}\) ). We find eutectic compositions of 75/25 mass% for \(\mathrm{Zn}(\hbox {NO}_3)_2\cdot \mathrm{6H}_{2}{\mathrm{O}}\) and \(\mathrm{NH}_4\mathrm{NO}_3\) and 73/27 mass% for \(\mathrm{Mn}(\hbox {NO}_3)_2\cdot 6\mathrm{H}_{2}{\mathrm{O}}\) and \(\mathrm{NH}_4\mathrm{NO}_3\) . Considering a temperature range of 15 K around the phase change, a maximum storage capacity of about 172 J \(\mathrm{g}^{-1}\) (302 J \(\mathrm{cm}^{-3}\) ) respectively 162 J \(\mathrm{g}^{-1}\) (274 J \(\mathrm{cm}^{-3}\) ) was determined for \(\mathrm{Zn}(\hbox {NO}_3)_2\cdot \mathrm{6H}_{2}{\mathrm{O}}\) and \(\mathrm{NH}_4\mathrm{NO}_3\) respectively \(\mathrm{Mn}(\hbox {NO}_3)_2\cdot \mathrm{6H}_{2}{\mathrm{O}}\) and \(\mathrm{NH}_4\mathrm{NO}_3\) .     

Preparation of selectively protected protoescigenin derivatives for synthesis of escin analogs and neoglycoconjugates

Protoescigenin, the main aglycone of horse chestnut saponin mixture known as escin, was selected as substrate for exploratory chemistry towards selective protection, followed by propargyl ether formation and subsequent condensation with azido-monosaccharides, to obtain novel triazole linked conjugates of the triterpene.      

Synthesis and rheology of thermoreversible polyurethane hydrogels

Polyurethanes based on poly(ethylene oxide)-poly(propylene oxide)-poly(ethylene oxide) triblock copolymer, succinic or citric acid, and ethyl ester L-lysine diisocyanate were synthesized and characterized by FT-IR and GPC. Wetting properties were evaluated by contact angle determinations. The critical micelle concentration was determined from surface tension measurements. Their abillity to undergo self-aggregation and temperature induced gelation was investigated through dynamic oscillatory measurements. The gelation point, sol-gel transitions, and gel structure are influenced by polymer structure, composition, molecular weight, concentration, and heating rate.      

The synthesis, structure and physical properties of lanthanide(III) complexes with nicotinic acid

This article reports the synthesis of novel, rare-earth coordination complexes with nicotinic acid. Three compounds with the general formula Ln₂[(C₅H₄NCOO)₆(H₂O)₄] (Ln = Yb, 1; Ln = Gd, 2; Ln = Nd, 3) were prepared from relatively cheap and readily available reactants. Their compositions and structure were characterized by IR spectroscopy and single-crystal X-ray diffraction. The magnetic and thermogravimetric properties were also studied. The complexes consist of centrosymetric, dimeric molecules having all six nicotinato ligands coordinated with the central atom in the bidentate mode. The coordination environment of the Ln³⁺ for all three compounds is 8. Here we describe the crystal structure of Yb and Gd complexes with nicotinic acid.      

Reaction of barbituric acid with organic azides and phosphonium ylides

Amination by organic azides has been carried out to provide aminobarbiturates by fusion of a triazole ring to the 5,6-positions of barbituric acid followed by cleavage and thermal elimination of nitrogen, whereas aza-Wittig reaction gave phosphoranylidene barbituric acid salts.      

Copper-cobalt ferrites as catalysts for methanol decomposition

Copper-cobalt ferrites with composition Cu_1?xCo_xFe₂O₄, where x= 0.2 and 0.8 were prepared by thermal treatment of co-precipitated precursor. The obtained materials were characterized by TG-DSC, XRD, Transmission and Conversion Electron Mössbauer spectroscopy and temperature programmed reduction with hydrogen. The catalytic properties of ferrites were tested in methanol decomposition to CO and hydrogen.      

L-leucinium perchlorate: new molecular complex with nonlinear optical properties. Vibrational, calorimetric and theoretical studies

On the basis of prior X-ray crystallographic results published by J. Janczak and G. Perpetuo, detailed vibrational studies were performed. The FT-IR and Raman spectra at ambient temperature were measured. The NLO properties were determined with the Kurtz-Perry experiment. Theoretical vibrational spectra were calculated. A detailed potential energy distribution (PED) analysis was performed. Assignments of observed bands were made. On the basis of these results, the behaviour of hydrogen bonds in the investigated compound was analysed and discussed. The equilibrium geometry of L-leucinium perchlorate was obtained. The results were compared with experimental X-ray data. The DFT formalism was used in theoretical studies. Detailed TDDFT study of hyperpolarizbility of first and second order for the investigated molecule was performed. Results were compared with experiments. Theoretical population analysis was used to determine the local electron density and local charges in investigated molecule. Differential scanning calorimetric study (DSC) was performed.      

Inactivation of cholinesterases by silver and gold ions in vitro

The main goal of the present study was to investigate the effects of silver and gold ions on cholinesterases (ChEs) activity due to increasing application of these metals in a wide variety of nanomaterials. A chromogenic assay using the substrate o-nitrophenyl acetate/butyrate made it possible to conclude unmistakably that both metals inhibit ChEs. Addition of bovine serum albumin (BSA) indicates that binding of metal ions to albumin could serve to scavenge metals and consequently reduce their amount for reaction with ChEs. The effects of metal ions on ChE should be taken into consideration when using this enzyme as an environmental biomarker.