Non-destructive elemental analysis of large meteorite samples by prompt gamma-ray neutron activation analysis with the internal mono-standard method

Prompt gamma-ray neutron activation analysis (PGNAA) using the internal mono-standard method was tested for its applicability to analyzing large solid samples including irregularly shaped meteorite samples. For evaluating the accuracy and precision of the method, large quantities of the Geological Survey of Japan standardized rock powders (JB-1a, JG-1a, and JP-1) were analyzed and 12 elements (B, Na, Mg, Al, Cl, K, Ca, Ti, Mn, Fe, Sm, and Gd) were determined by using Si as an internal standard element. Analytical results were mostly in agreement with literature values within 10 %. The precision of the method was also shown to be within 10 % (1σ) for most of these elements. The analytical procedure was then applied to four stony meteorites (Allende, Kimble County, Leedey, Lake Labyrinth) and four iron meteorites (Canyon Diablo, Toluca (Mexico), Toluca (Xiquipilco), Squaw Creek) consisting of large chunks or single slabs. For stony meteorites, major elements (Mg, Al, Si, S, Ca, and Ni), minor elements (Na and Mn) and trace element (B, Cl, K, Ti, Co, and Sm) were determined with adequate accuracy. For iron meteorites, results for the Co and Ni mass fractions determined are all consistent with corresponding literature values. After the analysis, it was confirmed that the residual radioactivity remaining in the sample after PGNAA was very low and decreased down to the background level. This study shows that PGNAA with the internal mono-standard method is highly practical for determining the elemental composition of large, irregularly shaped solid samples including meteorites.     

Chemical characterization of graphite by instrumental neutron activation analysis

Nuclear and commercial grade graphite samples were analysed by instrumental neutron activation analysis (INAA) using high flux reactor neutrons. Eleven elements (Na, K, As, Sc, Fe, Cr, Co, Zn, La, Ce, and Sm) were determined in eight samples of graphite (two nuclear grade and six commercial grade) by irradiating at a neutron flux of 3?×?10¹³ cm^?2 s^?1 in CIRUS reactor and assaying the activity by high-resolution gamma ray spectrometry using 40% relative efficiency HPGe detector coupled to an MCA. Concentrations of elements were determined by relative method of INAA. Results of both types of graphites as well as detection limits achieved by INAA method are discussed in the paper.     

Chemical characterization of Yapese clays and ceramics by instrumental neutron activation analysis

Chemical-characterization data from INAA provided information for understanding procurement of clays and production of ceramics in the Yapese past. By integrating mineralogical and chemical composition studies, we suggest clay-source zone distinctions for the different Yapese ceramic wares. This revised version was published online in July 2006 with corrections to the Cover Date.     

Chemical characterization of gas- and oil-bearing shales by instrumental neutron activation analysis

The concentration of As, Ba, Ca, Co, Cr, Cs, Dy, Eu, Fe, Ga, Hf, K, La, Lu, Mn, Mo, Na, Ni, Rb, Sb, Sc, Se, Sm, Sr, Ta, Tb, Th, U, Yb, and Zn were determined by instrumental neutron activation analysis in block shale samples of the New Albany Group (Devonian-Mississippian) in the in the Illinois Basin. Uranium content of the samples was as high as 75 ppm and interfered in the determination of samarium, molybdenum, barium and cerium. In the determination of selenium a correction was made for interference from tantalum. U, As, Co, Mo, Ni and Sb as well as Cu, V and pyritic sulphur which were determined by other methods, were found to correlate positively with the organic carbon content of the samples.     

Elemental characterization of mineral supplements by neutron activation analysis

Instrumental neutron activation analysis (INAA) was applied to assess element concentrations in eleven samples of mineral supplements/multivitamins acquired in drugstores and pharmacies in São Paulo city, SP, Brazil. Concentrations of Ca, Co, Cr, Cu, Fe, K, Na, Se and Zn were determined. A comparison was made between the results obtained with the labels of the mineral supplents. Certified reference materials, NIST SRM1400 Bone Ash and NIST SRM 1633b Coal Fly Ash were analyzed for quality control of the analytical results.     

Multi-element characterization of high-purity titanium dioxide by neutron activation analysis

A radiochemical neutron activation analysis method for the determination of 34 elements in titanium dioxide has been developed. For the assay of indicator radionuclides with short and with long half-lives, the radiochemical separation was performed by anion exchange on a Dowex 1 × 8 column and by combination of cation and anion exchange on a Dowex 50W × 8 and a Dowex 1 × 8 column from HF- and HF/NH₄F-medium, respectively. With both separation modes, a selective removal of the matrix-produced radionuclides ⁴⁶Sc, ⁴⁷Sc and ⁴⁸Sc was achieved. A selective extraction of copper with dithizone from 15 mol/L HF enabled counting the intensive but unspecific 511-keV rays of ⁶⁴Cu for the determination of Cu. The limits of detection achieved were between 0.004 ng/g for Sm and 0.8 μg/g for Sn (via ¹²⁵Sb). The elements La, Mn and Th were determined by instrumental neutron activation analysis only. These techniques were applied to the analysis of two titanium dioxide samples of different purity grade. The results and limits of detection are compared with those of other methods.     

Determination of zinc in clay and pottery materials by instrumental neutron activation analysis

The problems of determination of zinc in clay, ceramics and soils via ⁶⁵Zn using INAA are discussed. The applicability of different approaches for solving the influence of ⁴⁶Sc and ¹⁵²Eu by gamma-spectrometry on the line of ⁶⁵Zn at 1115.5 keV are experimentally evaluated. The application of the correction program ANGES for the calculation of the net peak area is demonstrated. All discussed approaches are checked by analyses of 10 SRM"s: Ohio Red Clay, Lefkandi brick, IAEA-SRM-Soil-1, IAEA-SRM-Soil-5, IAEA-SRM-Soil-7, IAEA-SRM-SL-3, GBW-08303, GBW-07406, NIST-SRM-2709 and BCR-SRM-520.     

Application of k 0-based internal mono-standard PGNAA for compositional characterization of cement samples

The k ₀-based internal mono-standard prompt gamma-ray neutron activation analysis (IM-PGNAA) method was used for compositional analysis of a cement standard provided by the International Atomic Energy Agency as a part of inter-laboratory comparison exercise. The PGNAA was also applied to a local cement sample for comparison purpose. The concentration ratios of elements with respect Ca were determined using the internal mono-standard method. The concentration ratios were then converted to the absolute concentrations by determining concentration of Ca in the cement using relative method. Concentrations of 11 elements were determined in both sample and standard of cement. The results of cement standard are found to be in good agreement with the certified values. The uncertainties on the elemental concentrations were in the range of 5–10 %.     

Collimated scanning for large sample neutron activation analysis of inhomogeneous samples

A technique was developed for the identification of inhomogeneities in activity distribution and the correction of their effect on the interpretation of gamma spectrometry data in Large Sample Neutron Activation Analysis. The method was based on collimated gamma scanning using a germanium detector to obtain the activity pattern in the bulk sample and Monte Carlo simulations in order to correct the experimental data for the effect of the inhomogeneous activity distribution. The method was experimentally evaluated in the case of a large cylindrical reference sample of 2 L in volume containing quartz as matrix material and a known source of radioactivity and an excellent agreement was observed. The discussed technique improves the trueness of quantitative analysis of large samples with inhomogeneous activity distribution.     

A systematic error from count rates in neutron activation analysis of archaeological materials

Errors of the order of a few per cent may occur in trace element measurements because of changes in the Ge(Li) detector resolution caused by count rate; errors appear when photopeak intensities are measured by summing a fixed number of data channels. A simple correction method based on a gaussian approximation is proposed. The problem is discussed in the context of trace element measurements in archaeological material.     

Chemical characterisations of Anatolian obsidians by instrumental and epithermal neutron activation analysis

Obsidian is a volcanic glass which is generally black, sometimes grey, brown, red or green in colour and characterised by a glassy appearance and conchoidal fractures. It is formed by the sudden cooling of the molten, generally acid magma with high water content. Obsidian was widely used for tool-making during prehistoric times. This work concems the chemical characterisation of obsidian occurrences from Northem, Central and Eastem Anatolia by Instrumental and Epithemal Neutron Activation Analysis for obtaining an accurate fingerprint for discrimination of potential natural sources of raw material that would permit tracing the origin of archaeological obsidian artefacts.     

Aerosol and air pollution study by neutron activation analysis

Thermal neutron activation analysis technique was used in air pollution and aerosol elemental content and size distribution investigations. Air pollution samples were collected on Whatman 41 paper filters which were activated along with known quantities of standards in a flux of ～10¹³ n·cm^?2·s^?1. The activity of the samples was measured with a 40 cm³ Ge(Li) detector and analyzed with the computer program JANE, which identified the isotopes and found their quantities by normalization with the standard measurement results. Correlation between the various elements, in particular those belonging to dust from the desert and those considered typical urban air pollution, is investigated.     

Application of INAA to ancient bricks for grouping study using trace elements

The paper presents the chemical composition analysis results of 57 ancient clay bricks obtained from Buddhist sites of two major locations of Andhra Pradesh, India. Samples were analyzed by instrumental neutron activation analysis (INAA) using high flux reactor neutrons and high resolution gamma ray spectrometry. Major, minor and trace concentrations of 23 elements were determined by relative method of NAA. For the grouping/provenance study, statistical cluster analysis was performed using concentrations of 14 selected elements namely Sc, Cr, Fe, Co, Zn, Cs, La, Ce, Eu, Tb, Yb, Lu, Ta and Th. The cluster analysis results indicated two major groups, which are in good agreement with the collection history of samples. Accuracy of the method was evaluated by analyzing two IAEA reference materials, RMs SL-1 and Soil-7.     

Precise determination of iridium by neutron activation analysis coupled with internal standard method

Journal of Radioanalytical and Nuclear Chemistry - Instrumental neutron activation analysis with internal standard correction was applied for precise determine of mg quantities of Ir in high-purity...     

Instrumental neutron activation analysis of pottery for provenience study

A scheme for INAA of pottery is proposed. The combination of 3 irradiations-epithermal and pile (short and long time) and 6 measurements (2 times after each irradiation) enables the determination of Al, As, Au, Ba, Br, Ce, Co, Cr, Cs, Dy, Eu, Fe, Hf, K, La, Lu, Mg, Mn, Na, Nd, Rb, Sb, Sc, Si, Sm, Ta, Tb, Th, Ti, U, V and Yb. The accuracy and precision of the method is evaluated by analysis of standard reference materials (USGS-BCR-1, USGS-W-1, ZGI-TB). The applicability of the method is demonstrated by analysis of 15 sgraffito ceramics from XV–XVIII cc. from Tzarevetz, Veliko Tirnovo (Bulgaria). The results from the clustering of the analytical data are presented and discussed.     

A workflow for neutron activation analysis of archaeological ceramics at the Atominstitut in Vienna,Austria

Journal of Radioanalytical and Nuclear Chemistry - The main focus for neutron activation analysis (NAA) at the Atominstitut in Vienna has moved to the analysis of archaeological ceramics. The...     

Chemical separation techniques for neutron activation analysis as used at the Dow Chemical Co

The chemical separation techniques used at the Dow Chemical Co. are discussed.