Improvement of GaInNAsSb films fabricated by atomic hydrogen-assisted molecular beam epitaxy

The effect of incorporation of antimony in GaInNAs films grown by atomic hydrogen-assisted molecular beam epitaxy (MBE) has been investigated. We show that the rate of incorporation of N and In forming GaInNAs do not depend on the Sb beam flux. However, the incorporation of Sb is strongly dependent on the Sb/As₂ flux ratio. Introducing a small amount of Sb (<∼1%) significantly improves the photoluminescence (PL) emission efficiency of GaInNAs, but Sb concentration of >1% rapidly degrades the PL intensity, though a large redshift can still be achieved. Therefore, there is an optimum amount of Sb for the growth of low-strained GaInNAs films to improve the overall optical quality.     

Influence of Be on N composition in Be-doped InGaAsN grown by RF plasma-assisted molecular beam epitaxy

Undoped and Be-doped InGaAsN layers were grown on GaAs substrates under the same growth conditions by radio frequency plasma-assisted molecular beam epitaxy. Increased tensile strain (Δa/a=3×10⁻³) was observed for Be-doped InGaAsN layers, compared to undoped InGaAsN layers. The strain is shown to originate from the increase in N composition related to Be incorporation, rather than solely from Be atoms substituting Ga atom sites (Be_Ga). A possible reason is the high Be–N bond strength, which inhibits the loss of N from the growth surface during epitaxial growth, thereby increasing the N composition in the Be-doped InGaAsN layer.     

The transition from As-doped GaN, showing blue emission, to GaNAs alloys in films grown by molecular beam epitaxy

We have studied the transition from As-doped GaN showing strong blue emission (2.6 eV) at room temperature to the formation of GaN_1−xAs_x alloys for films grown by plasma-assisted molecular beam epitaxy. We have demonstrated that with increasing N-to-Ga ratio there is first an increase in the intensity of blue emission at about 2.6 eV and then a transition to the growth of GaN_1−xAs_x alloy films. We present a model based on thermodynamic considerations, which can explain how this might occur.     

Effect of arsenic species on the kinetics of GaAs nanowires growth by molecular beam epitaxy

GaAs nanowires (NWs) are grown on GaAs (1 1 1) B substrates in a molecular beam epitaxy system, by Au-assisted vapor–liquid–solid growth. We compare the characteristics of NWs elaborated with As₂ or As₄ molecules. In a wide range of growth temperatures, As₄ leads to growth rates twice faster than As₂. The shape of the NWs also depends on the arsenic species: with As₄, regular rods can be obtained, while pencil-like shape results from growth with As₂. From the analysis of the incoming fluxes, which contributes to the NWs formation, we conclude that the diffusion length of Ga adatoms along the NW sidewalls is smaller under As₂ flux as compared to that under As₄ flux. It follows that As₂ flux is favourable to the formation of radial heterostructures, whereas As₄ flux is preferable to maintain pure axial growth.     

Growth of EuTe islands on SnTe by molecular beam epitaxy

Semiconductor magnetic quantum dots are very promising structures, with novel properties that find multiple applications in spintronic devices. EuTe is a wide gap semiconductor with NaCl structure, and strong magnetic moments S=7/2 at the half filled 4f⁷ electronic levels. On the other hand, SnTe is a narrow gap semiconductor with the same crystal structure and 4% lattice mismatch with EuTe. In this work, we investigate the molecular beam epitaxial growth of EuTe on SnTe after the critical thickness for island formation is surpassed, as a previous step to the growth of organized magnetic quantum dots. The topology and strain state of EuTe islands were studied as a function of growth temperature and EuTe nominal layer thickness. Reflection high energy electron diffraction (RHEED) was used in-situ to monitor surface morphology and strain state. RHEED results were complemented and enriched with atomic force microscopy and grazing incidence X-ray diffraction measurements made at the XRD2 beamline of the Brazilian Synchrotron. EuTe islands of increasing height and diameter are obtained when the EuTe nominal thickness increases, with higher aspect ratio for the islands grown at lower temperatures. As the islands grow, a relaxation toward the EuTe bulk lattice parameter was observed. The relaxation process was partially reverted by the growth of the SnTe cap layer, vital to protect the EuTe islands from oxidation. A simple model is outlined to describe the distortions caused by the EuTe islands on the SnTe buffer and cap layers. The SnTe cap layers formed interesting plateau structures with easily controlled wall height, that could find applications as a template for future nanostructures growth.     

Temperature effects during the growth of InxGa1−xN films through the whole compositional range by plasma-assisted molecular beam epitaxy

Substrate temperature rises of over 200 °C have been observed for growth of InN and In-rich InGaN on GaAs substrates. We present a model to show that it is not the narrow bandgap that is responsible for the large temperature rises observed during growth of InN, but the large bulk background carrier concentration. We also show how the substrate temperature rise during growth increases as a function of increasing indium composition and the effects of controlling the substrate temperature on film quality.     

Anomalous temperature-dependent photoluminescence characteristic of as-grown GaInNAs/GaAs quantum well grown by solid source molecular beam epitaxy

The photoluminescence (PL) mechanisms of as-grown GaInNAs/GaAs quantum well were investigated by temperature-dependent PL measurements. An anomalous two-segmented trend in the PL peak energy vs. temperature curve was observed, which has higher and lower temperature-dependent characteristics at low temperature (5–80 K) and high temperature (above 80 K), respectively. The low and high-temperature segments were fitted with two separate Varshni fitting curves, namely Fit_low and Fit_high, respectively, as the low-temperature PL mechanism is dominated by localized PL transitions while the high-temperature PL mechanism is dominated by the e1–hh1 PL transition. Further investigation of the PL efficiency vs. 1/kT relationship suggests that the main localized state is located at 34 meV below the e1 state. It is also found that the temperature (80 K) at which the PL full-width at half-maximum changes from linear trend to almost constant trend correlates well with the temperature at which the PL peak energy vs. temperature curve changes from Fit_low to Fit_high.     

The incorporation behavior of arsenic and antimony in GaAsSb/GaAs grown by solid source molecular beam epitaxy

GaAsSb ternary epitaxial layers were grown on GaAs (0 0 1) substrate in various Sb₄/As₂ flux ratios by solid source molecular beam epitaxy. The alloy compositions of GaAs_1−ySb_y were inferred using high-resolution X-ray symmetric (0 0 4) and asymmetric (2 2 4) glance exit diffraction. The non-equilibrium thermodynamic model is used to explain the different incorporation behavior between the Sb₄ and As₂ under the assumption that one incident Sb₄ molecule produces one active Sb₂ molecule. It is inferred that the activation energy of Sb₄ dissociation is about 0.46 eV. The calculated results for the incorporation efficiency of group V are in good agreement with the experimental data.     

Alloy phase separation in InAs/InAlAs/InP nanostructure superlattices studied by finite element calculation

The alloy phase separation effect in InAlAs spacer layer of InAs/InAlAs nanostructure superlattices was studied by two-dimensional finite element calculation. The calculation results showed that InAs islands with wide top would prefer to induce “V”-like In-rich InAlAs arms above InAs islands in InAlAs spacer layer, while InAs islands with narrow top would promote the formation of “I”-like In-rich InAlAs arms above InAs islands in InAlAs spacer layer which corresponded well with the experimental results reported in Ref. [9].     

Growth of Eu-doped GaN by gas source molecular beam epitaxy and its optical properties

Eu-doped GaN with various Eu concentrations were grown by gas source molecular beam epitaxy, and their structural and optical properties were investigated. With increasing Eu concentration from 0.1 to 2.2 at%, deterioration of the structural quality was observed by reflection high-energy electron diffraction, atomic force microscopy and X-ray diffraction. Such a deterioration may be caused by an enhancement of island growth and formation of dislocations. On the other hand, room temperature photoluminescence spectra showed red emission at 622 nm due to an intra-atomic f–f transition of Eu³⁺ ion and Fourier transform infrared spectra indicated an absorption peak at about 0.37 eV, which may be due to a deep defect level. The intensity of the red luminescence and the defect-related absorption peak increased with increasing Eu concentration, and a close correlation in the increasing behavior was observed between them. These results suggest that the deep defect level plays an important role in the radiative transition of Eu³⁺ ion in GaN and the optical process for the luminescence at 622 nm was discussed with relation to the defect.     

Structural and photoluminescence characteristics of molecular beam epitaxy-grown vertically aligned In0.33Ga0.67As/GaAs quantum dots

In this paper, we present the results of structural and photoluminescence (PL) studies on vertically aligned, 20-period In_0.33Ga_0.67As/GaAs quantum dot stacks, grown by molecular beam epitaxy (MBE). Two different In_0.33Ga_0.67As/GaAs quantum dot stacks were compared. In one case, the In_0.33Ga_0.67As layer thickness was chosen to be just above its transition thickness, and in the other case, the In_0.33Ga_0.67As layer thickness was chosen to be 30% larger than its transition thickness. The 2D–3D growth mode transition time was determined using reflection high-energy electron diffraction (RHEED). Structural studies were done on these samples using high-resolution X-ray diffraction (HRXRD) and cross-sectional transmission electron microscopy (XTEM). A careful analysis showed that the satellite peaks recorded in X-ray rocking curve show two types of periodicities in one sample. We attribute this additional periodicity to the presence of an aligned vertical stack of quantum dots. We also show that the additional periodicity is not significant in a sample in which the quantum dots are not prominently formed. By analyzing the X-ray rocking curve in conjunction with RHEED and PL, we have estimated the structural parameters of the quantum dot stack. These parameters agree well with those obtained from XTEM measurements.     

Influence of semi-insulating InP substrates on InAlAs epilayers grown by molecular beam epitaxy

Tensile-strained InAlAs layers have been grown by solid-source molecular beam epitaxy on as-grown Fe-doped semi-insulating (SI) InP substrates and undoped SI InP substrates obtained by annealing undoped conductive InP wafers (wafer-annealed InP). The effect of the two substrates on InAlAs epilayers and InAlAs/InP type II heterostructures has been studied by using a variety of characterization techniques. Our calculation data proved that the out-diffusion of Fe atoms in InP substrate may not take place due to their low diffusion coefficient. Double-crystal X-ray diffraction measurements show that the lattice mismatch between the InAlAs layers and the two substrates is different, which is originated from their different Fe concentrations. Furthermore, photoluminescence results indicate that the type II heterostructure grown on the wafer-annealed InP substrate exhibits better optical and interface properties than that grown on the as-grown Fe-doped substrate. We have also given a physically coherent explanation on the basis of these investigations.     

The role of Sb in the molecular beam epitaxy growth of 1.30–1.55 μm wavelength GaInNAs/GaAs quantum well with high indium content

Sb-assisted GaInNAs/GaAs quantum wells (QWs) with high (42.5%) indium content were investigated systematically. Transmission electron microscopy, reflection high-energy electron diffraction and photoluminescence (PL) measurements reveal that Sb acts as a surfactant to suppress three-dimensional growth. The improvement in the 1.55 μm range is much more apparent than that in the 1.3 μm range, which can be attributed to the difference in N composition. The PL intensity and the full-width at half maximum of the 1.55 μm single-QW were comparable with that of the 1.3 μm QWs.     

A structural study of phase transitions within GaN layers grown by low-temperature molecular beam epitaxy

The epitaxial growth of GaN layers on sapphire substrates by molecular beam epitaxy at low temperatures (500°C) has been investigated. Samples exhibited a transition from hexagonal to mixed hexagonal/cubic phase under conditions of increasing Ga flux as determined using a TEM-RHEED technique with complementary SEM and PL observations. Embedded cubic grains adopted two domain variants with additional evidence for twinning.     

Structure and optical properties of self-assembled InAs/GaAs quantum dots with In0.15Ga0.85As underlying layer

A high density of 1.02×10¹¹ cm⁻² of InAs islands with In_0.15Ga_0.85As underlying layer has been achieved on GaAs (1 0 0) substrate by solid source molecular beam epitaxy. Atomic force microscopy and PL spectra show the size evolution of InAs islands. A 1.3 μm photoluminescence (PL) from InAs islands with In_0.15Ga_0.85As underlying layer and InGaAs strain-reduced layer has been obtained. Our results provide important information for optimizing the epitaxial structures of 1.3 μm wavelength quantum dots devices.     

Arsenic cross-contamination in GaSb/InAs superlattices

We have investigated the cross-contamination of As in GaSb/InAs superlattices. We demonstrate a method of varying the lattice constant of the superlattice. By controlling the As background pressure in the growth chamber, the strain can be controlled to about 0.01%, corresponding to As cross-incorporation variations of about ±1%. The distribution of As is investigated by X-ray diffraction and cross-sectional scanning tunneling microscopy, and the critical thickness is obtained.     

AlGaN photodetectors grown on Si(1 1 1) by molecular beam epitaxy

The fabrication and characterisation of Al_xGa_1−xN (0x0.35) photodetectors grown on Si(1 1 1) by molecular beam epitaxy are described. For low Al contents (<10%), photoconductors show high responsivities (10A/W), a non-linear dependence on optical power and persistent photoconductivity (PPC). For higher Al contents the PPC decreases and the photocurrent becomes linear with optical power. Schottky photodiodes present zero-bias responsivities from 12 to 5 mA/W (x=0−0.35), a UV/visible contrast higher than 10³, and a time response of 20 ns, in the same order of magnitude as for devices on sapphire substrate. GaN-based p–n ultraviolet photodiodes on Si(1 1 1) are reported for the first time.