电化学发光淬灭法测定SOD

在硼酸缓冲溶液（pH6．7）中性介质中,O2和H2O2均对鲁米诺的电化学发光（ECL）有敏化作用,而超氧化物歧化酶（SOD）对此敏化的电化学发光具有淬灭作用,SOD的浓度与两种发光体系的ECL光强成线性关系,可用于SOD的测定,为SOD的测定提供了一种灵敏、可靠的测定方法。     

中性微乳液介质增敏鲁米诺电化学发光研究

磷酸盐缓冲的中性溴化十六烷基三甲基铵-正戊醇-正庚烷微乳液介质体系对鲁米诺的电化学发光有显著的增敏作用,本文对此增敏作用进行了研究,并在此介质体系中采用电化学发光淬灭法测定了生物活性分子褪黑素,此法可用于测定脑白金胶囊中的褪黑素。     

电化学发光法测定盐酸普鲁卡因

基于盐酸普鲁卡因对鲁米诺在中性介质中铂电极上电化学发光的催化增敏作用 ,建立了测定盐酸普鲁卡因电化学发光新方法。电化学发光强度与盐酸普鲁卡因质量浓度在 4 .0× 1 0 -7～6 .0× 1 0 -6g mL范围内有良好的线性关系 ,检测限为 2 .0× 1 0 -7g mL,相对标准偏差为 4 .4 %。该方法已用于针剂中盐酸普鲁卡因的测定     

电化学发光法测定铁

基于Fe(o Phen)33 对鲁米诺电化学发光体系的电还原发光信号的增敏作用,建立了一种测定铁离子的电化学发光新方法。在最佳的实验条件下,该方法测定铁(Ⅲ)的线性范围为4.1×10-7～4.1×10-6mol/L,检出限为1.8×10-7mol/L,相对标准偏差小于5%。     

电化学发光传感器研究进展

本文简要介绍了电化学发光传感器近几年取得的重要研究成果。内容主要包括联吡啶钌电化学发光传感器、鲁米诺电化学发光生物传感器及电化学发光的微型化发展。引用参考文献42篇。     

褪黑素的电化学氧化行为及伏安法测定

采用电化学方法研究了褪黑素在金电极上的不可逆氧化行为.结果表明：其伏安过程为受弱吸附和扩散共同控制的过程,氧化反应电荷转移数为2.采用伏安法对褪黑素进行测定,方法的检出限可达10^-10ml/L数量级.方法可用于脑白金胶囊中褪黑素含量的测定.     

流动注射电化学发光法测定半胱氨酸和谷胱甘肽

采用流动注射分析技术研究了半胱氨酸和谷胱甘肽对鲁米诺微弱电化学发光的增敏行为。对影响电化学发光的各因素进行了试验和探讨 ,提出了可能的反应机理 ,并建立一种电化学发光测定半胱氨酸和谷胱甘肽的新方法。半胱氨酸和谷胱甘肽的浓度在 1 .0× 1 0 - 6 mol/L～ 5 .0× 1 0 - 5 mol/L和 1 .0× 1 0 - 6mol/L～ 2 .0× 1 0 - 5 mol/L之间呈良好的线性关系 ,相关系数分别为 0 .993和0 998,检出限分别为 0 .67μmol/L和 0 .72 μmol/L。对 1 .0× 1 0 - 5mol/L的半胱氨酸和谷胱甘肽进行 1 1次平行测定 ,相对标准偏差分别为 4.5 %和 3.7%。     

鲁米诺/氨基磺酸电化学发光及其多巴胺检测应用

在本文中,我们首次观察到氨基磺酸可以显著增强鲁米诺电化学发光,而且鲁米诺电化学发光的强度随着氨基磺酸浓度在0.1 μmol·L-1至500 μmol·L-1范围增加而线性增加.同时,我们观察到多巴胺可以显著猝灭鲁米诺-氨基磺酸电化学发光.基于该猝灭现象,我们建立了多巴胺的电化学发光分析方法,该方法的线性范围为0.5至2...     

光导纤维电化学发光葡萄糖传感器的研究

以碳糊为固定化载体 ,将葡萄糖氧化酶固定在碳糊电极上 ,制成了光导纤维电化学发光葡萄糖生物传感器。葡萄糖的酶催化反应、鲁米诺的电化学氧化和化学发光反应在电极表面同时发生 ,因此该传感器的信号响应在 1 0 s内达到发光强度峰值。葡萄糖浓度在 1 .0× 1 0 -5～ 2 .0× 1 0 -2 mol/L范围内与发光强度呈线性关系 ,检出限为 6.4× 1 0 -6mol/L,可应用于市售饮料中葡萄糖的测定     

半胱氨酸对鲁米诺电化学发光的增敏作用

在pH 7.0~13.0溶液中,半胱氨酸对鲁米诺的电化学发光有敏化作用,电化学发光强度随溶液中半胱氨酸浓度线性增强。在pH 8.0时其线性范围为2.0×10-8~4.5×10-5mol/L。本法的重现性和稳定性较好,为半胱氨酸的测定提供了一种新的方法。     

Determination of nitrite based on its quenching effect on anodic electrochemiluminescence of CdSe quantum dots

A novel method for electrochemiluminescent (ECL) detection of nitrite was proposed based on its quenching effect on anodic ECL emission of CdSe quantum dots (QDs). The ECL emission could be greatly enhanced by sulfite and dissolved oxygen in a neutral system and occurred at a relatively low potential in comparison with traditional anodic ECL emitter, leading to high sensitivity and good selectivity. The quenching mechanism followed an “electrochemical oxidation inhibition” process, which was completely different from those of some analytes on the ECL emission of QDs. The coincidence of photoluminescence and ECL spectra of the QDs indicated that the ECL emission resulted from the redox process of QDs core and the sulfite acted as a coreactant. The nitrite quenched ECL emission could be analyzed according to the treatment of Stern-Volmer equation with a linear range from 1 μM to 0.5 mM for detection of nitrite. This work presented a new efficient ECL methodology for quencher-related detection.     

Determination of melatonin in biological samples by capillary electrophoresis

The determination of melatonin (MLT) in physiological samples was investigated using capillary electrophoresis (CE). Mouse blood was collected in tubes containing EDTA, centrifuged at 1500 g for 20 min at 4°C, and stored at −20°C. Plasma samples were extracted with dichloroethane, centrifuged and the aqueous phase was discarded. Then the organic phase was evaporated to dryness. The residue was dissolved in deionized water and filtered with a microfilter (0.22 μm). Separations were carried out using a CE system equipped with a fused silica capillary [80 cm (effective length 52 cm)×75 μm I.D.] and an ultraviolet–visible detector (200 nm), and programmed to provide 25 mM 2-(N-morpholino)ethanesulfonic acid (pH 5.7). Injection was performed hydrostatically by elevating the sample by 10 cm at the cathodic side of the capillary. The calibration curve, reproducibility, recovery and limit of detection were examined, and validation of the method was performed. The result showed that MLT in blood could be easily determined with the new method.     

流动注射电化学发光分析法测定氨苄西林

基于氨苄西林对鲁米诺在铂电极上弱的电氧化发光信号的强增敏作用与流动注射技术的结合,建立了一种测定氨苄西林的电化学发光分析新方法。该法测定氨苄西林的检出限为5.0×10-8g mL,线性范围为8.0×10-8～5.0×10-5g mL,相对标准偏差为2.0%(n=11)。已成功地用于样品中氨苄西林的测定。     

流动注射化学发光法测定褪黑素

在强碱性介质中,铁氰化钾可直接氧化褪黑素产生化学发光。基于此,建立了一种测定褪黑素的流动注射化学发光分析方法。线性范围为1.9×10-6~2.3×10-4g/mL,检出限为5×10-7g/mL,该法已用于药物中褪黑素的测定。     

示波极谱法测定保健药品中的褪黑激素

褪黑激素与HNO3在室温下发生硝基化反应生成褪黑激素的硝基化合物,加NH3·H2O终止反应并用甲酸 甲酸钠缓冲液控制反应液pH3,在原点电位-0.20V(vs.SCE),测量-0.50V处的二阶导数峰高。方法检出限为1μg/L,线性范围为1μg/L～200μg/L,相对标准偏差为2.6%～8.0%,加标回收率为92 0%～110 0%,测定结果与高效液相色谱法进行比较,无显著性差异。     

Determination of melatonin in commercial preparations by micellar electrokinetic chromatography and spectrofluorimetry

Melatonin was determined in pharmaceutical preparations by means of two simple and reliable analytical methods based on micellar electrokinetic chromatography (MEKC) and spectrofluorimetry. The fluorescence emission values were measured at λ=350 nm when exciting at λ=275 nm. The MEKC analysis was achieved using a system consisting of 40 mM SDS in phosphate buffer (20 mM, pH 7.5). The extraction of melatonin from the tablets was achieved by means of a simple one-step dissolution with methanol/water. Both methods were applied for the determination of melatonin in commercial formulations and galenic preparations. The MEKC procedure allows the quantitative determination of melatonin in all pharmaceutical preparations tested. On the contrary, the spectrofluorimetric method is not suitable for tablets which also contain tryptophan; this interference can be eliminated by a suitable liquid-liquid extraction procedure. The results obtained with the two methods are in good agreement and satisfactory in terms of precision and accuracy.