Photonic crystal channel drop filter based on ring-shaped defects for DWDM systems

This paper presents a novel configuration of channel drop filters based on two-dimensional photonic crystal slabs in silicon-on-insulator platforms. The structure is composed of two photonic crystal line-defect waveguides as input and output ports, along with an L3 cavity with ring-shaped border holes. The effects of structural parameters and fabrication errors on resonance frequency and drop efficiency are investigated. Band structure and propagation of electromagnetic field through device are calculated by plane wave expansion and finite-difference time-domain methods. The results show that the quality factor and line-width of output signal are ~5690 and 0.27 nm, respectively, indicating that the proposed filter can be properly used in dense wavelength division multiplexing systems with 0.8 nm channel spacing.     

Theory and experiment for atomic optical filter based on optical anisotropy in rubidium

An atomic optical filter based on optical anisotropy induced by another left-circularly polarized pump field is theoretically and experimentally investigated in the 5S_1/2–5P_3/2–5D_3/2 ladder-type system of rubidium vapor. The filter displays a single peak transmission of 14.4% with 396 MHz bandwidth narrower than Doppler width. Furthermore, the variation of peak transmission versus pump intensity, pump detuning and cell temperature are also given. The theoretical and experimental results are in good agreement, which can enhance understanding of operation mechanism for this category of filter. The narrow-bandwidth filter is useful for free-space optical systems and laser spectroscopy.     

Optical fiber dispersion properties management for optimized narrowband bandpass microwave photonics slicing filter applications

The analysis of the influence of dispersion properties of the dispersive line used in a microwave photonic slicing filter is presented. We establish a general relation between both chromatic dispersion value and slope, allowing the optimization of the frequency response of the filter. Experimental validations are presented in good agreement with theoretical and numerically simulated results. Narrow bandwidth bandpass filter (<100 MHz) is achieved at the central frequency of 6.48 GHz, corresponding to the limit value in reference to the used broadband light source and fiber dispersion.     

Simulation research of medium-short distance free-space optical communication with optical amplification based on polarization shift keying modulation

Circular polarization shift keying (CPolSK) modulation technique has many advantages such as excellent BER performance and freedom from the alignment of polarization coordinates of the transmitter and the receiver, etc., and it turns out to be a good choice to FSO system. In this paper, a FSO system using CPolSK modulation is studied by simulation; it is found that the communication performance of the system is excellent in most weather condition. Additionally, three ways of optical signal amplification are proposed, and contrastive analysis on performance of corresponding optical amplification systems is carried out by examining SNR、BER and transmission distance with different specific attenuation. The results show that the system with optical amplifier at the transmitter have the optimum performance, and then the system with optical amplifier at the both ends with the same total gain, it is worst for the system with optical amplifier at the receiver. In addition, the safety factor for high emission power induced by optical amplification is also considered in this paper for practical application. The study above may be utilized in the system design for enhancing performance.     

Gain assisted large-scale tunable atomic filter based on double selective optical pump induced dichroism

A gain assisted large-scale tunable optical filter scheme via double selective optical pump induced dichroism is proposed. Theoretical model predicts that the filter provides a huge gain for the weak probe light, furthermore, its tunability can reach over gigahertz while its bandwidth is only several hundred megahertz, which is important for laser communication and lidar systems subjected to large Doppler shift.     

A spurious frequencies suppression method for optical frequency comb based microwave photonic filter

The traditional optical frequency comb (OFC) based microwave photonic filters (MPFs) are rigidly restricted to be operated in a single “Nyquist zone”, as varieties of spurious frequencies signals coexist in the output. Here, a method for spurious frequencies suppression in the OFC‐based MPF is proposed and experimentally demonstrated. The method is achieved by applying group velocity dispersion on the carrier combs to separate the filter transfer functions of the spurious frequencies from that of the input radio frequency signal. It is fairly simple and effective, and has no effect on the filter characteristic. With this method, the filter pass band can be freely tuned without the limitation of the “Nyquist zone”. It can be considered as a step forward for the practical application of the OFC‐based MPF.     

A Kalman filter based synchronization scheme for telescope array receivers in deep-space optical communication links

In this paper, the impact of random synchronization errors on the performance of ground-based telescope array receivers for an inter-planetary optical deep-space communication (ODSC) link is investigated. An adaptive method based on Kalman filters is developed for the synchronization and combination of different telescope signals in the array. An end-to-end simulation platform for ODSC link between Earth and planet Mars is implemented that incorporates pulse-position modulation (PPM), direct-detection array receivers, and photon-counting detectors. The effects of atmospheric turbulence and background noise are also modeled. The performance of array receivers is evaluated in terms of probability of symbol error and achievable data rates. The simulation results show that the Kalman filter-based synchronization scheme keeps the synchronization induced power losses to less than 1 dB. The analysis also shows that in the worst-case operational scenario and presence of random synchronization errors, an array consisting of hundred, 1 m telescopes performs almost similar to a single 10 m telescope. Hence, the degradation in the combined signal due to synchronization errors places a minor limitation on the number of telescopes in a telescope array receiver consisting of up to 100 telescope elements.     

Notes on use of strict optical orthogonal codes to design unequal channel spacing (UCS) frequency sequences for DWDM systems with reduced FWM crosstalk

A paper [E. Mutafungwa et al., Optics Communications 198 (4) (2001) 339] reported the use of strict optical orthogonal codes (S-OOC’s) to reduce the four-wave mixing (FWM) crosstalk in dense wavelength-division multiplexing (DWDM) systems by using our S-OOC based unequal channel spacing (UCS) scheme and our special frequency sequences constructed, without referring to the original work. Some mistakes and inaccuracies are identified in the published paper regarding interpretation of S-OOC and its associated UCS scheme, which can cause the confusion of understanding the key concepts and principle about the S-OOC based UCS scheme. As a result, in this paper we present the necessary corrections and notes which deal with the major expressions and key concepts of both S-OOC’s and our proposed scheme. In doing so, the mapping of a S-OOC sequence to the UCS frequency set is appropriately interpreted, and the characteristics of S-OOC based UCS schemes are described. Moreover, the correct evaluation of optical bandwidths is presented for DWDM systems using S-OOC based UCS schemes, and the comparison of the repeated-codeword assignments with the overlapping-codeword assignments is also carried out. Furthermore, we discuss the effect of fractional-slot occupation for frequency assignments on the bandwidth expansion of UCS-DWDM systems. These in turn can lead to correctly understanding the principles of S-OOC based UCS schemes and applying them to assign the UCS frequencies to DWDM systems for the reduction of FWM crosstalk.     

基于DVD读取头的光学探头电路设计

随着工业精密测量对于精度和分辨率的要求越来越高,光学探头在工业精密测量中得到了广泛的应用。由于DVD读取头的聚焦误差信号FES(Focus Error Signal)即S曲线的一部分与失焦距离成线性关系,因此稍作改进就可以做光学探头,用来进行微小位移的测量[1]。文中给出了其电路设计,该电路分成两个部分,一个是LD功率自动控制电路,一个是FES获取电路。经过实验测试,利用该电路可以获得良好的S曲线,可实现对微器件(几何尺寸数毫米至数微米,精度参数多为微纳米数量级)的精确测量。该电路设计具有结构简单、抗干扰能力强等突出优点。     

Wide-band nulling system for antenna array based on a photonic microwave filter and optical delay lines

A nulling system for phased array antennas with broad bandwidth and reduced complexity is presented. The system is based on combining the output of an optical beamforming network with an optical transversal filter steered in the angle where a null is desired in a configuration that reduces the number of optoelectronic conversion compared to previous proposals. Preliminary experimental results to show the feasibility of the concept are provided between 2 and 6 GHz, showing null depths of 22, 10 and 19 dB at 2, 5 and 6 GHz, respectively.     

Simple design technique for a triangular FBG filter based on a linearly chirped grating

A novel and simple design technique for triangular spectrum response of fibre Bragg grating (FBG) is presented based on a linear chirped grating. It is shown that this method is fast and can give a straightforward solution to meet a design target. The numerical simulation examples verified the effectiveness of the design method. A general approach to design for multichannel triangular spectral responses for FBG filters is proposed, which provides a solution that achieves a minimum change of refractive index for the fibre.     

Fiber chromatic dispersion measurement based on wavelength-to-time mapping using a femtosecond pulse laser and an optical comb filter

A novel method for the measurement of chromatic dispersion of an optical fiber based on wavelength-to-time mapping using a femtosecond pulse laser (FSPL) and an optical comb filter is proposed and experimentally evaluated. In the proposed approach, the spectrum of an ultrashort optical pulse generated by an FSPL is sliced by an optical comb filter. The spectrum-sliced optical pulse is then coupled into the optical fiber under test. Thanks to the chromatic-dispersion-induced wavelength-to-time mapping in the optical fiber under test, a time-domain waveform similar to the sliced spectrum is generated at the output of the optical fiber, with different frequency components having different time delays. The time delay vs. frequency data are then recorded for the estimation of the chromatic dispersion by using least square fitting. Chromatic dispersions of two types of optical fibers with different lengths are tested. The measured dispersion values agree well with those measured by the conventional modulation phase shift (MPS) method.     

A novel super-FEC code based on concatenated code for high-speed long-haul optical communication systems

The structures of the novel super forward error correction (Super-FEC) code type based on the concatenated code for high-speed long-haul optical communication systems are studied in this paper. The Reed-Solomon (RS) (255, 239) + Bose-Chaudhuri-Hocguenghem (BCH) (1023, 963) concatenated code is presented after the characteristics of the concatenated code and the two Super-FEC code type presented in ITU-T G.975.1 have theoretically been analyzed, the simulation result shows that this novel code type, compared with the RS (255, 239) + convolutional-self-orthogonal-code (CSOC) (k₀/n₀ = 6/7, J = 8) code in ITU-T G.975.1, has a lower redundancy and better error-correction capabilities, and its net coding gain (NCG) at the third iteration is 0.57 dB more than that of RS (255, 239) + CSOC (k₀/n₀ = 6/7, J = 8) code in ITU-T G.975.1 at the third iteration for the bit error rate (BER) of 10⁻¹². Therefore, the novel code type can better be used in long-haul, larger capacity and higher bit-rate optical communication systems. Furthermore, the design and implementation of the novel concatenated code type are also discussed.     

External cavity design of high-power diode laser for polarized helium-3 neutron spin filters based on spin-exchange optical pumping

Polarized neutron spin filters are being developed based on spin-exchange optical pumping. In the present study a high-power diode laser (85 W) was used to excite Rb atoms and the laser linewidth was narrowed using an external cavity. The optics in the external cavity were designed by ray tracing. The ray-trace calculations demonstrated that a doublet lens in front of the laser eliminates aberrations. The maximum spectral peak height in the doublet optics was found to be 25% higher than for a singlet lens.