直排型DF/HF化学激光器气流通道模型实验研究

 为了探寻直排型连续波DF/HF化学激光器的起动特性,建立了一套化学激光器气流通道单喷管小型模型实验装置,通过选用不同的气体（冷气流）作为工作介质和不同的扩压器进行实验,分别研究了工作介质的气动参量对模型起动特性和扩压器喉道最小面积的影响,并与1维定常流理论的计算结果作了比较。最后分析了基区对模型起动特性的影响,比较了两种类型基区的差异。实验结果表明:对于直排型连续波DF/HF化学激光器,采用大比热容比、小相对分子质量的介质作为引射气流,喷管出口和基区之间带有一个向内的圆角,对提高DDCL整体性能是有利的。     

直排型连续波DF/HF化学激光器气流通道模型中氮作引射气的相变问题

为了研究直排型连续波DF/HF化学激光器的启动特性,建立了一套化学激光器气流通道双喷管小型实验模型。以氮和氦作为引射介质,采用两种面积比的引射喷管,进行了启动实验。实验表明,当以氮作为引射介质,采用大面积比的引射喷管进行实验时,实验数据与1维理论计算结果相差很大。分析认为,该次实验中,在引射喷管内剧烈地膨胀后,部分N2已经发生相变,理论计算采用的1维定常流处理法已经不再适用。计算表明,连续波DF/HF化学激光器中的光腔燃料和副稀释剂He不会发生相变,但当以N2作副稀释剂时,副稀释剂喷管面积比不能过大。     

氧碘激光器小信号增时空分布的实验研究

首次利用一台亚音速小型连续波化学氧碘激光器的探测光源。用放大法直接测量超音速化学氧碘激光器的小信号增益系数，测得了小信号增益系数随时间和气流方向的变化。     

氧碘激光器小信号增益时空分布的实验研究

 首次利用一台亚音速小型连续波化学氧碘激光器做探测光源，用放大法直接测量超音速化学氧碘激光器的小信号增益系数，测得了小信号增益系数随时间和气流方向的变化。     

连续波DF/HF化学激光器气膜冷却式喷管流场数值分析

在连续波DF/HF化学激光器主喷管收缩段采用气膜冷却方式,从3维离散小孔注入氦气射流以隔离壁面和主气流。通过对3种气膜孔排布方式下喷管内主气流状态进行数值模拟研究,分析氦气与主气流之间的相互作用,比较了不同方式下主气流氟原子冻结效率及壁面冷却效果。考虑到DF/HF化学激光器主喷管结构尺寸较小,采用适当间隔的单排圆孔注入是现实可行的,并有望达到较好的冷却保护效果,从而提高激光器运转效率。     

直排型DF/HF化学激光器扩压器喉道最佳长度实验研究

 为了研究扩压器喉道长度对直排型连续波DF/HF化学激光器起动特性的影响,建立了一套化学激光器气流通道双喷管小型实验模型。在无二次流的条件下,通过选用喉道长度不同的扩压器进行实验,分别得到对应的起动压力和工作压力,并将起动压力和工作压力的大小作为评价扩压器喉道长度优劣的依据。实验数据显示,对于该特定结构的直排型DF/HF激光器气流通道双喷管实验模型,扩压器喉道最佳长度为等效直径的17倍。     

直排型DF/HF化学激光器双喷管模型启动特性

 建立了一套直排型DF/HF化学激光器气流通道双喷管小型实验装置,通过选择不同副气流总压（模拟燃烧室气流）进行实验,研究了副气流总压对双喷管实验装置启动特性的影响。实验结果表明：随着副气流总压的增大,装置的启动压力降低,盲腔条件下的启动压力明显高于有副气流时的启动压力。因此,先通入燃烧室气流,再开通引射气流,对直排型连续波DF/HF化学激光器的启动是有利的。采用1维处理方法,建立了从引射气流喷管入口、副气流喷管入口到扩压器出口的理论模型,得到了与实验一致的规律。由于1维理论中采用了一些近似处理,实际启动压力比理论数据高20%～31%。     

超音速氮稀释连续波HF化学激光器小信号增益测量

 以氮为稀释剂的电激励连续波HF/DF化学激光器可以使用低温吸附泵代替传统的机械真空泵和洗消装置,大幅度降低激光器的系统体积和重量。使用小信号增益测量系统对某超音速氮稀释电激励连续波HF化学激光器的增益分布进行了测量。得到了在4种不同激光功率下P₁(4),P₁(6), P₂(4)～P₂(6)谱线的增益系数分布曲线。测得P2(4)为最强增益谱线,最大值为0.1 cm^-1;最强增益位置与最佳光轴位置相符;超音速气流使增益区延伸达2.5 cm。     

连续波氧碘化学激光器小信号增益的测量

描述了利用脉冲光解碘原子激光器作为探测激光器测量连续波氧碘化学激光器小信号增益的方法与装置,给出了增益的测量结果,对实验结果和误差作了简单讨论。     

连续波氧碘化学激光器的新进展

介绍了连续波氧碘化学激光器的原理及发展过程，分析了氧碘激光器的主要关键技术，报道了新进展，提出了该激光器今后的发展趋势     

Guided-Wave Two-Dimensional Acousto-Optic Scanner Using Proton-Exchanged Lithium Niobate Waveguide

Two-dimensional scanning of a 0.6328 mum guided-light beam has been realized using noncolinear acousto-optic (AO) coplanar Bragg diffraction together with colinear AO guided-mode to substrate radiation-mode conversion in a Z-cut Xpropagation LiNbO3 proton-exchanged (PE) waveguide. The two surface acoustic (SAW) waves utilized are at the center frequencies of 500 and 200 MHz, propagating in the Y and X axes, respectively. Two-dimensional scanning of approximately 720 resolvable light beam spots, namely, 18 40 (horizontal vertical) scanning, has been demonstrated using a light beam of 1.0 mm aperture. The total number of resolvable beam spots can be greatly increased from 720 by simply utilizing SAW transducers of larger bandwidth and a light beam of greater aperture. It should also be possible to significantly increase the diffraction efficiency from 3 % by optimizing the parameters of the PE waveguide and the SAWs.     

Effect ofγ-radiation on the spectral luminescence characteristics of impure cadmium tungstate crystals

Results of a study of the effect of γ-radiation on the spectral luminescence properties of cadmium tungstate crystals doped with silver, bismuth, and molybdenum cations are presented. Spectral characteristics of the nondnnnoped crystals are briefly described. Absorption and photo and X-ray luminescence spectra of the crystals taken before and after exposure to γ-radiation (5.5·10⁴ Gy) are compared. It is found that the spectral characteristics of the crystals doped with silver, bismuth, and molybdenum cations do not change markedly after the exposure. The relation between the type of impurity-induced defects, individual characteristics of the impurity cations, and the character of the effect of γ-radiation on the spectral luminescence properties of impure crystals is analyzed (preliminarily). Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No. 1, pp. 55–60, January–February, 1997.     

Femtosecond Transform-Limited Pulse Generation by Compensating for the Linear Chirp of SPM Spectra in Dispersion Shifted Fibers

A simple technique of pulse compression, based on the linear chirp compensation of self-phase modulation (SPM) spectra in dispersion shifted fibers, is demonstrated. The optimization procedure is carried out, for a short span of a single-mode fiber, using a parabolic law, which describes the behavior of the squared output pulse width versus the pump peak power in the case of Gaussian pulses. The experimental results give a minimum pulse duration of 233 fs, which is in good agreement with the model. Shorter and coherent pulses, down to 90 fs, have been obtained by inserting an interference filter at the optical output.     

Sorting of bending magnets for the SSRF booster

The Shanghai Synchrotron Radiation Facility(SSRF)booster ring,a full energy injector for the storage ring,is deigned to accelerate the electron beam energy from 150MeV to 3.5GeV that demands high extraction efficiency at the extraction energy with low beam loss rate when electrons are ramping.Closed orbit distortion(COD)caused by bending magnet field uniformity errors which affects the machine performance harmfully could be effectively reduced by bending magnet location sorting.Considering the affections of random errors in measurement,both ideal sorting and realistic sorting are studied based on measured bending magnet field uniformity errors and one reasonable combination of bending magnets which can reduce the horizontal COD by a factor of 5is given as the final installation sequence of the booster bending magnets in this paper.     

Measurement of nonlinear coefficient of optical fiber based on small chirped soliton transmission

We measure the waveform and phase curves of short optical pulses before and after transmission over different lengths of fibers by use of the pulse analyzer with the frequency-resolved optical gating (FROG),and numerically simulate pulse evolution under the experimental conditions.The nonlinear coefficient of the fiber is given by comparing the experimental results with the numerical ones.Difference between the experiment and numerical simulation is analyzed.     

Resonance scattering of canonical elastic shells in absorbing fluid medium

Resonance scattering of elastic spherical shell and cylindrical shell while the surrounding fluid medium has absorption is studied. The normal mode solution derived using exact elastic theory and the separation of variables is still applicable. However, the scattering form function has to be modified for the absorbing medium, otherwise the unreasonable result would be obtained. The backscattering form function in the absorbing medium is redefined, and the form function of elastic spherical and cylindrical shell with vacuum or solid matter filled is calculated in various absorption conditions. The results show that the absorption of surrounding fluid leads to notable attenuation of the coincidence resonances in the mid-frequency, but it has a little influence on the low-frequency resonance scattering induced by the filler inside the shell.     

Single-beam self-referenced phase-sensitive surface plasmon resonance sensor with high detection resolution

A versatile and low-cost single-beam self-referenced phase-sensitive surface plasmon resonance(SPR)sensing system with ultra-high resolution performance is presented.The system exhibits a root-mean-square phase fluctuation of ±0.0028.over a period of 45 min.i.e.a resolution of±5.2×10-9 refractive index units.The enhanced performance has been achieved through the incorporation of three design elements:a true single-beam configuration enabling complete self-referencing so that only the phase change associated with SPR gets detected,a differential measurement scheme to eliminate spurious signals not related to the sensor response,and the elimination of retardation drifts by incorporating temperature stabilization in the liquid crystal phase modulato .Our design should bring the detection sensitivity of non-labeling SPR biosensing closer to that achievable by conventional fluorescence-based techniques.     

Influences of SiO2 protective layers and annealing on the laser-induced damage threshold of Ta2O5 films

Ta2O5 films are prepared on BK7 substrates with conventional electron beam evaporation deposition.The effects of SiO2 protective layers and annealing on the laser-induced damage threshold (LIDT) of the films are investigated.The results show that SiO2 protective layers exert little influence on the electric field intensity(EFI)distribution,microstructure and microdefect density but increase the absorption slightly.Annealing iS effective on decreasing the microdefect density and the absorption of the films.Both SiO2 protective layers and annealing are beneficial to the damage resistance of the films and the latter is more effective to improve the LIDT.Moreover,the maximal LIDT of Ta2O5 films is achieved by the combination of SiO2 protective layers and annealing.     

A stereo matching algorithm using multi-peak candidate matches and geometric constraints

Gray cross correlation matching technique is adopted to extract candidate matches with gray cross correla- tion coefficients less than some certain range of maximal correlation coefficient called multi-peak candidate matches. Multi-peak candidates are extracted corresponding to three closest feature points at first. The corresponding multi-peak candidate matches are used to construct the model polygon. Correspondence is determined based on the local geometric relations between the three feature points and the multi-peak candidates. The disparity test and the global consistency checkout are applied to eliminate the remaining ambiguous matches that are not removed by the local geometric relational test. Experimental results show that the proposed algorithm is feasible and accurate.