Behavioral studies of gain and saturation energy density in a N2 laser with corona preionization

By the use of an oscillator-amplifier (OSC-AMP) TE N₂ laser system, both operating with corona preionizers, the laser parameters (small-signal gain g ₀ and saturation energy density E _s) have been measured at different N₂ gas pressure and for different states of the AMP preionizer. The details of our measurements are presented. In addition, the effect of He buffer gas on the laser parameters has also been investigated; it was found that both laser parameters remain almost constant up to 150 Torr of He gas pressure, indicating that He mainly affects the discharge uniformity. Finally, with the variation of the N₂ laser gain values in the literature, we found that the g ₀-N₂-laser parameter depends strongly on the length of the laser channel. Based on the most recent measurements, a graph showing this dependency is introduced.     

Polarization-dependent gain and saturation energy density in a TE N2-laser amplifier

The polarization-dependent gain, g₀, and saturation energy density, E_s, in a TE N₂-laser amplifier were measured, using an oscillator-amplifier laser system for different amplifier electrode gap separations, d_AMP, of 7, 9 and 4 mm and gas pressure of p = 77, 60, and 165 Torr, respectively. It was realized that for the amplifier with the gap separation of 7 and 9 mm, where the pd_AMP-value has its optimum-value of 54 Torr cm, the gain-coefficient for the input beam with the polarization parallel to the discharge electrodes (P-polarized beam) is slightly higher than the case when the beam polarization is perpendicular to the discharge electrodes (S-polarized beam). In this case, the depolarization ratio for d_AMP = 7 mm is the range of ∼0.998 to ∼0.962 as the input voltage increases from 12 to 15.5 kV, having a minimum of 0.937 around 14 kV. For the E_s-parameter, the reversed order is true. Also, it was found that the saturation energy densities for three states of polarization are linearly related to the output energy densities, having different slopes of 0.11, 0.14, and 0.17 for R (randomly), P- and S-polarization, respectively. The present measurement supports qualitatively the prediction of polarization-inhomogeneity model for the stimulated emission cross-section, showing that randomly oriented dipoles exhibit slightly larger gain on the direction of the electric field.     

Miniature high-repetition-rate TEA CO2 laser with surface-wire-corona preionization

In this article, an experimental study of a miniature, sealed-off, high-repetition-rate transversely excited atmospheric-pressure (TEA) CO₂ laser with a kind of surface-wire-corona preionization (SWCP) is described. We have utilized an SWCP consisting of SiO₂ dielectric tube and a fine wire strained and attached to the dielectric surface. A BN ceramic material, which has an extremely low coefficient of thermal expansion of about 5 × 10⁻⁷/°C was employed as a supporter of the resonator. A measurement on emission spectra of SWCP has been reported. By applying SWCP to the TEA CO₂ laser, efficient laser operation at an overall efficiency of 9.8% with an output energy of 150 mJ has been achieved from a small discharge volume of 25 cm³ with an active length of 230 mm. At the pulse repetition frequency of 60 Hz, the TEM₀₀ mode of laser beam with pulse width of 60 ns was obtained.     

Phase conjugation in the gain saturation of a flashlamp pumped dye laser

Tunable phase conjugation in the gain saturation of a fashlamp pumped dye laser has been demonstrated. The phase conjugation obtained has been tuned from 590 nm to 610 nm.     

Anomalous laser energy absorption associated with resonance saturation

Laser energy absorption measurements have been undertaken in an experiment involving the transmission of a pulse of laser radiation through sodium vapour. The wavelength of the laser was tuned to overlap the 589 nm resonance transition of the sodium atoms. Although simple radiation transport appears to account for the attenuation of the laser beam at low values of incident laser irradiance, anomalously large absorption has been observed at high values of incident laser energy. We suggest that this anomalous absorption of laser energy can be regarded as evidence of superlastic electron heating and subsequent ionization.     

预电离脉冲群开关技术高功率脉冲CO2激光器

采用独特的电极结构和预电离脉冲群开关放电技术,实现了5kW量级平均功率横流CO2激光器脉冲激光输出.     

Influence of end reflectivity on gain saturation in a planar distributed feedback laser

An approximate method for the analysis of planar-waveguide distributed-feedback lasers is extended to include a nonvanishing reflectivity at the ends of the structure. An index grating structure with parasitic losses is investigated. An expression for the small-signal gain coefficient ^0MN as a function of the output power P ^MNout normalized to the saturation power P ^s , coupling coefficient K, complex reflectivity R of end reflectors, and waveguide parameters is presented.     

Synchronization effect on the small-signal gain and saturation intensity of a CuBr laser

A pair of copper bromide laser in an oscillator–amplifier configuration was used to investigate the small signal gain and saturation intensity as amplifying parameters, versus delay time of triggering between lasers. The maximum amplifying parameters and output power of 0.07 cm^?1, 43 μJ cm^?2, and 9 W were measured, respectively at optimum delay time of about 10 ns. The amplifying parameters and measured output power of laser versus delay times between intervals of 6–43 ns, shows some local maxima and minima. The output power extracted from the amplifier exceeds that achieved with the same device as the oscillator by more than 60%.     

Near diffraction limit output and gain saturation of soft X-ray laser

By using of travelling wave amplification, we have got a soft x-ray laser with near diffraction limit output and gain saturation in the experiment of four series coupling targets with reflector.     

Near diffraction limit output and gain saturation of soft X-ray laser

Abstract: By using of travelling wave amplification, we have got a soft x-ray laser with near diffraction limit output and gain saturation in the experiment of four series coupling targets with reflector.     

Pressure dependence of small signal gain and saturation intensity of a gold-vapor laser using various buffer gases in gain medium

A pair of gold-vapor laser (627.8 nm) in an oscillator-amplifier configuration was used to investigate the small signal gain, g₀, and saturation intensity, I_s, as amplifying parameters, versus pressure at various types of buffer gas. It was shown that the small signal gain decreases and saturation intensity increases linearly with increasing the pressure. Moreover, the values of these parameters are different using various gas mixtures in gain medium. Both parameters were estimated to be more at helium buffer gas atmosphere than that of neon or their mixed ones.     

TEA CO2激光器预电离结构电极系统的电场研究

 高功率气体激光器的非对称复杂电极系统中,电极参数的变化以及预电离结构的引入将会使所设计的均匀电场发生具体的改变。采用高精度有限元方法,对这类复杂电极系统进行建模并且计算其电场分布,根据分析结果更合理地指导激光器设计。对一种典型的非对称复杂电极系统TEA CO₂激光器,应用该方法并结合了预电离过程,研究了引入预电离器导体和变化电极形状对电极表面的电场强度起伏和放电空间的均匀电场面积产生的影响。结果表明:通过这种预先模拟,合理选择电极构型参数和预电离结构安装位置,可以产生性质较好的均匀电场以及效率较高的激光输出。     

Experimental studies of a XeCl laser having UV preionization perpendicular and parallel to the electrode surfaces

This paper reports on the results of an experimental study of a XeCl laser having two independent preionizators which generated UV radiation into the active medium in the perpendicular and parallel directions to the electrode surfaces. Output energy and other parameters were measured using a single preionizator and two preionizators, changing the power supply polarity and varying the delay time between the preionization and the main discharge. When the preionization system generated photons only in the direction perpendicular to the electrode surfaces, a high discharge current and a high output laser energy were obtained. Besides, the diffusion coefficient of the photo-preionized electrons, played an important role in the laser behaviour, particularly when a consistent delay time between the onset time of the preionization and the main discharge was present.     

Parametric study of plasma active medium and gain saturation region in a Ne-like soft X-ray laser

Plasmas created by the interaction of high power optical laser with a target surface can be used as a source of soft X-ray lasers. Plasma and pump laser characteristics play significant role in achieving high gain coefficient for such plasma based on soft X-ray lasers. In the present work, the plasma active medium parameters for germanium element at a wavelength of 19.6 nm irradiated by a double-pulse pump laser have been studied using MED103 hydrodynamic code. For this purpose, first, the effects of laser intensity, pulse width and delay time of two pulses on the gain coefficient have been investigated and the optimum conditions for the maximum gain extent of Ne-like germanium soft X-ray laser are obtained. Then, in order to calculate the intensity of such high gain lasers in which Linford equation is invalid, we have adopted the general formula of amplified spontaneous emission intensity, which is valid in all range of intensities even at much higher intensities than saturation intensity. Finally, the soft X-ray laser intensities in the saturated areas for different plasma lengths have been calculated. The results show that the output of soft X-ray laser intensity with 294 cm⁻¹ gain coefficient can reach to about several times saturated intensity by applying a 1–2 mm plasma length as the active medium.     

Numerical simulation of corona discharge in N2

A numerical study of a negative corona discharge in nitrogen in a point-plane gap using a Monte Carlo method is presented. The simulation provides a detailed structure of avalanches, propagation of successive avalanches and ion distribution can be discerned. The development of electron avalanches is due to ionization and photoionization in the high-field region, while the quenching of the avalanches is due to the low electric field near the plane electrode. Also the accumulation of electrons and positive ions are displayed in detail. The space charge field distortion is studied.     

高功率横流CO2激光器脉冲预电离过程研究

本文给出了对高功率横流CO_2激光器脉冲预电离过程的理论和实验研究.表明了预电离过程中光电离的重要作用.实验结果表明,脉冲预电离可增大高功率横流CO_2.激光器的pd值(p为放电气压、d为放电间隔),增大放电区注入功率密度.对于提高此类型激光器的放电稳定性和输出激光功率是一种技术简单而有效的手段.     

预电离脉冲群开关技术高功率脉冲CO2激光器

采用独特的电极结构和预电离脉冲群开关放电技术, 实现了5kW 量级平均功率横流CO₂激光器脉冲激光输出. 关键词： 2脉冲激光')" href="#">CO₂脉冲激光 预电离 脉冲群开关     

The small signal gain and the saturation intensity measurement of the nitrogen-ion laser

A series oscillator-amplifier has been fabricated and optimized in order to determine the small signal gain and the saturation intensity of the N₂⁺ amplifying medium. Two plasmas, which are composed of a mixture of helium and nitrogen gases, have been produced under pressures of 2–5 atm by applying an electrical transverse discharge. The time delay between the two plasmas has been controlled by the gas pressure. To optimize the gain, the entrance time of the oscillator's output pulse into the amplifier was synchronized with the maximum population inversion in the amplifier. The gain coefficient () was obtained from 6 to 124, by varying the intensity of the input beam at the optimum pressure. The small signal gain and the saturation intensity have been calculated as 0.04, 0.07, 0.10 cm⁻¹ and 7.77, 13.33, 19.97 (kW cm⁻²) at 1.25, 1.70, 2.20 atm, respectively. The dominant wavelength of the nitrogen-ion laser corresponding to the B²∑_u(v = 0) → X²∑_g(v′ = 1) transition, 427.8 (nm) wavelength, was used in this work.