Chlorate ion mediated rutile to anatase reverse phase transformation in the TiO2 nanosystem

Rutile TiO(2) nanoneedles (8 nm × 100 nm) synthesized at room temperature by anodization in perchloric acid (pH < 1) are shown to undergo an interesting reverse phase transformation to anatase nanoparticles (8 nm) at 300 °C only if the chlorate ions are maintained in the ambient medium. When chlorate ions are removed by multiple washing, the rutile phase and the needle morphology are maintained. The mechanism of formation of the ion-stabilized solid and its thermal evolution is discussed.     

High carrier density and capacitance in TiO2 nanotube arrays induced by electrochemical doping

The paper describes the electronic charging and conducting properties of vertically oriented TiO 2 nanotube arrays formed by anodization of Ti foil samples. The resulting films, composed of vertically oriented nanotubes approximately 10 mum long, wall thickness 22 nm, and pore diameter 56 nm, are analyzed using impedance spectroscopy and cyclic voltammetry. Depending on the electrochemical conditions two rather different electronic behaviors are observed. Nanotube array samples in basic medium show behavior analogous to that of nanoparticulate TiO 2 films used in dye-sensitized solar cells: a chemical capacitance and electronic conductivity that increase exponentially with bias potential indicating a displacement of the Fermi level. Nanotube array samples in acidic medium, or samples in a basic medium submitted to a strong negative bias, exhibit a large increase in capacitance and conductivity indicating Fermi level pinning. The contrasting behaviors are ascribed to proton intercalation of the TiO 2. Our results suggest a route for controlling the electronic properties of the ordered metal-oxide nanostructures for their use in applications including supercapacitors, dye-sensitized solar cells, and gas sensing.     

Features of the anatase transformation to rutile

We showed that the transformation of anatase to rutile is accompanied by a set of various chemical reactions in which the anionic and/or cationic impurities in the anatase partitioned in a separate phase (gaseous or condensed) resulting in the rutile titanium dioxide with a low content of impurities.     

Nanoflower arrays of rutile TiO2

Stacks of multilayered rutile TiO(2) nanoflowers can grow on a titanium film through a simple acid vapour oxidation (AVO) method. The growth of this interesting hierarchical architecture is due to the formation of rutile {101} twinned structures and a subtle mismatching between the lattice spacings of the substrate and product.     

Photoluminescence of anatase and rutile TiO2 particles

Nonaqueous reactions between titanium(IV) chloride and alcohols (benzyl alcohol or n-butanol) were used for the synthesis of anatase TiO2 particles, while rutile TiO2 particles were synthesized in aqueous media by acidic hydrolysis of titanium(IV) chloride. The X-ray diffraction measurements proved the exclusive presence of either the anatase or the rutile phase in prepared samples. The photoluminescence of both kinds of particles (anatase and rutile) with several well-resolved peaks extending in the visible spectral region was observed, and the quantum yield at room temperature was found to be 0.25%. Photon energy up-conversion from colloidal anatase and rutile TiO2 particles was observed at low excitation intensities. The energy of up-converted photoluminescence spans the range of emission of normal photoluminescence. The explanation of photon energy up-conversion involves mid-gap energy levels originating from oxygen vacancies.     

Efficient photoelectrodes from anatase TiO2 nanotube arrays decorated with particles/rods/3D microflower rutile crystals for photoelectrochemical water splitting

Journal of Solid State Electrochemistry - Efficient photoanodes are designed of vertically aligned anatase TiO2 nanotube arrays (anatase TNTAs) decorated with different shaped rutile TiO2...     

Electrodeposition of polyaniline in long TiO2 nanotube arrays for high-areal capacitance supercapacitor electrodes

Journal of Solid State Electrochemistry - Anodic TiO2 nanotube arrays (TNTAs) were found to be a suitable scaffold for the loading of other active materials for supercapacitors. The prepared...     

Adsorption of organic molecules on rutile TiO2 and anatase TiO2 single crystal surfaces

The interaction of organic molecules with titanium dioxide surfaces has been the subject of many studies over the last few decades. Numerous surface science techniques have been utilised to understand the often complex nature of these systems. The reasons for studying these systems are hugely diverse given that titanium dioxide has many technological and medical applications. Although surface science experiments investigating the adsorption of organic molecules on titanium dioxide surfaces is not a new area of research, the field continues to change and evolve as new potential applications are discovered and new techniques to study the systems are developed. This tutorial review aims to update previous reviews on the subject. It describes experimental and theoretical work on the adsorption of carboxylic acids, dye molecules, amino acids, alcohols, catechols and nitrogen containing compounds on single crystal TiO(2) surfaces.     

Polypyrrole self-organized nanopore arrays formed by controlled electropolymerization in TiO2 nanotube template

A new concept for formation of nanostructured intrinsically conducting polymers (ICP) is demonstrated. Polypyrrole can be electropolymerized from an ionic-surfactant-solution in TiO(2) nanotube framework to form a geometrical structure of self-organized nanopore arrays. Polymerization is initialized selectively in the space between nanotube walls forming a mechanically stable polymer network with controlled wall thickness from 40 to 10 nm. Such robust polymer nanostructures are very promising for application in electrochemical systems of limited charge carrier diffusion length.     

Inherent electrochemical activity of TiO2 (anatase,rutile) enhances the charge capacity of cathodes of lithium-sulfur batteries

Journal of Solid State Electrochemistry - The addition of nanocrystalline titanium dioxide (P90) to a cathode of Li/S cell enhances its voltammetric charge capacity by 19%, from which only a small...     

Length-controlled synthesis of oriented single-crystal rutile TiO2 nanowire arrays

A free-standing, large area, oriented single-crystal rutile TiO(2) nanowire arrays with a controlled length in the range of 10-80 μm are prepared via a facile one-step synthesis. The growth process is studied systematically in an appropriate amount of H(2)O(2) and HCl solution under hydrothermal conditions. The length of the nanowires can be easily tuned by varying the experimental parameters, including reaction temperature and reaction time. High-resolution transmission electron microscopy demonstrated that the nanowires have single-crystal structure. Furthermore, the photoluminescence characteristics and photocatalytic properties of oriented single-crystal rutile TiO(2) nanowires was discussed in this paper, respectively. It is found that the increased reaction temperature is helpful to photocatalytic reactivity and photoluminescence properties.     

Surface photovoltage phase spectroscopy study of the photo-induced charge carrier properties of TiO2 nanotube arrays

By using the surface photovoltage(SPV) technique based on a lock-in amplifier,surface states located 3.1 eV below the conduction band of TiO 2 have been detected in TiO 2 nanotube arrays prepared by anodization of titanium foil in fluoride-based ethylene glycol solution.The photo-induced charge transportation behavior of TiO 2 nanotube arrays was also studied by qualitatively analyzing their SPV phase spectra measured under different external bias.When a negative bias was applied,carriers excited from surface states have the same transportation properties as those excited from the valence band;in contrast,when a positive bias was applied,these two kinds of photo-excited carriers exhibit different transportation behavior.     

Robust free standing flow-through TiO2 nanotube membranes of pure anatase

We report the fabrication of defect-free crystalline TiO₂ nanotube (NT) membranes that maintain a full anatase phase composition up to an annealing temperature of 950 °C. Key is the use of a lactic acid electrolyte for the growth of the anodic nanotube layers. These nanotube layers are mechanically sufficiently robust to fabricate, by chemical etching, lift-off and annealing, both-end-open membranes that feature no morphological damage over their entire surface area and thickness. We illustrate the beneficial use of the pure anatase membranes for a flow-through photocatalytic application, i.e., the photodegradation of Acid Orange 7. However, it is anticipated that these pure anatase membranes will also have a wide range of uses in photo(electrochemical) applications of TiO₂.     

Fabrication of multi-sectional TiO 2 nanotube arrays by anodization

We report a facile method to grow multi-sectional TiO₂ nanotube arrays consisting of alternating bamboo-shaped and smooth-walled nanotube sections by anodization. Two key factors are necessary for obtaining these morphologies. First, in order to avoid possible disruptions between the conjoint sections of the nanotube, the distribution of hydrogen ions is suggested not to be fiercely disturbed when switching from the first to the second stage. Second, to avoid the disruption of the nanotube at the joint which results from the disparity in diameters between sections, the direct current voltage is set to be the maximum of the square wave voltage. These newly developed TiO₂ nanotube arrays are expected to have potential applications in solar cells, drug release and delivery systems.     

Relation between morphology and conductivity in TiO2 nanotube arrays: an electrochemical impedance spectrometric investigation

Two types of TiO₂ nanotubular arrays were obtained by anodisation of a titanium foil, in two different solutions containing fluoride ions. For the first type which has rough tube walls, impedance measurements in the dark showed the presence of a localised surface state which was related to adsorbed molecular water. Under UV illumination, this adsorbed molecular water was photo-dissociated. Moreover, an increase of 2 orders of magnitude for the limiting capacitance of the space charge layer was observed, simultaneously with the disappearance of the localised state and with a 100-time increase of the carrier density associated with hydrogen insertion. The second type of layer was characterised by smoother tube walls, a high doping level (10²⁰?cm^?3) in the dark, a lack of localised states and no long-lasting photo-induced effect. In this case, the width of the space charge layer became rapidly higher than the half-thickness of the tube walls, when the applied potential increased. Therefore, the walls were progressively depleted under anodic polarisation, passing from a situation where the tubes were totally active in the cathodic range towards a situation where the contribution of the tube walls could be neglected.     

Preparation and photoactivity of nanostructured anatase, rutile and brookite TiO2 thin films

Photoactive films consisting of pure anatase, brookite or rutile TiO2 were prepared by dip coating from water dispersions obtained by using TiCl4 as the precursor under similar mild experimental conditions.     

Green synthesis and dye-sensitized solar cell application of rutile and anatase TiO2 nanorods

Journal of Solid State Electrochemistry - Nanorods (NRs) of TiO2 have biogenically been&nbsp;prepared, i.e., from the extract of Phellinus linteus mushroom. The presence of mixed anatase and...     

Preparation of self-supporting hierarchical nanostructured anatase/rutile composite TiO(2) film

Via the combination of an electrospinning method with a hydrothermal reaction, a large-scale cedar-like hierarchical nanostructured TiO(2) film with an anatase/rutile composite phase was fabricated.     

金红石相二氧化钛纳米晶的光催化活性

以苯酚光催化氧化和铬酸根光催化还原反庆为模型反应,研究不同粒径的金红石相二氧化钛纳米晶的光催化性活性。用XRD,TEM和BET等表明超细金红石相二氧化钛的粒径为7～8nm,UV-vis谱表明其吸收带边界蓝移11nm。在上述反应中,具有量子尺寸效应的金红石相二氧化钛(7nm)均表现出很高的催化活性,催化活性随粒径增大而迅速下降。7.2nm金红石相二氧化钛的光催化活性与6.8nm的锐钛矿相二氧化钛相当。