The nucleation of calcium phosphate from solution

Dicalcium phosphate was precipitated from homogeneous solution in the pH range 5–6 by using the hydrolysis of cyanate to control the precipitation process. Turbidimetric determination of the onset of precipitation enabled the critical supersaturation to be determined. In this region the average critical supersaturation ratio was found to be 2.3.     

Micromechanical testing of individual collagen fibrils

A novel method based on AFM was used to attach individual collagen fibrils between a glass surface and the AFM tip, to allow force spectroscopy studies of these. The fibrils were deposited on glass substrates that are partly coated with Teflon AF. A modified AFM tip was used to accurately deposit epoxy glue droplets on either end of the collagen fibril that cross the glass-Teflon AF interface, as to such attach it with one end to the glass and the other end to the AFM tip. Single collagen fibrils have been mechanically tested in ambient conditions and were found to behave reversibly up to stresses of 90 MPa. Within this regime a Young's modulus of 2-7 GPa was obtained. In aqueous media, the collagen fibrils could be tested reversibly up to about 15 MPa, revealing Young's moduli ranging from 0.2 to at most 0.8 GPa.     

Homogeneous nucleation of calcium hydroxide

The rate of nucleation of calcium hydroxide in carefully purified supersaturated solution was observed to be about 10(3) particles, cm(-3). sec(-1), in solutions with activity products a(ca)a(OH)(2) around 4 x 10(-5). These data correspond to a homogeneous nucleus containing about 55Ca(OH)(2) units, and a nucleus-solution interfacial tension of 65 erg cm (2).     

Association of collagen with calcium phosphate promoted osteogenic responses of osteoblast-like MG63 cells

In this investigation, the effects of the association of the collagen (COLL) molecules with the calcium phosphate (CaP) film were examined with respect to both the physicochemical properties of the CaP films and the osteoblast responses, such as the adhesion, proliferation, differentiation, and mineralization. The COLL pre-adsorbed CaP film (CaPA) exhibited significant changes in the surface morphology compared to the COLL incorporated CaP film (CaPC). The adhesions of the osteoblast-like MG63 cells were similar on the CaPC or CaPA films. However, the proliferation of the MG63 cells on CaPC was comparable to CaP but considerably different than CaPA. The differentiation of the MG63 cells was greatly improved on CaPC and CaPA compared to CaP and more pronounced on CaPA. The presence of COLL within or on the CaP films significantly modulated the expression of the phenotypic genes, including osteopontin (OPN), alkaline phosphatase (ALP), and the transforming growth factor-β (TGF-β). The expression patterns of these genes elucidated that COLL that was present within or on the CaP film supported the osteoblast proliferation and differentiation. These positive effects were stronger for CaPA than CaPC. The bone-like nodules formed on all of the specimens. However, the mineralization of CaPC and CaPA was significantly higher than CaP, indicating that the association of CaP with COLL promoted the mineral deposition. Therefore, the association of the COLL molecules with the CaP film induced positive effects on the biomineralization. Overall, the incorporation of COLL efficiently enhanced the osteoblast responses of CaP. This system can be utilized in a drug delivery system using calcium phosphate. Although the incorporation effects were slightly higher for the osteoblast responses of CaPA than CaPC, CaPC can be used when the longer drug release times are desirable.     

The binding of CNA35 contrast agents to collagen fibrils

CryoTEM demonstrates that a CNA35-bearing liposomal MRI contrast agent selectively binds to poorly assembled collagen type I as opposed to well-assembled collagen fibrils, whereas monomeric CNA35 binds to all forms of collagen. It is shown that upon conjugation to liposomes and micelles CNA35 loses its ability to dissociate ordered collagen fibrils and thereby to create its own binding sites.     

Molecular distribution within collagen gel columns

Purified collagen columns with collagen concentrations of 5 and 10% were constructed by modification of the procedure for the 1% gel as described by Shaw and Schy. The resulting columns were calibrated by elution of various tracers, and the observations compared with those of the 1% collagen gel column. The data were fitted to the Ogston gel model as formulated by Laurent and Killander, but the model was found to be not fully applicable. The thermodynamic treatment of Hjertén was applied to the data with more satisfactory agreement.     

Modeling of bovine type-I collagen fibrils: interaction with pickling and retanning agents

Bovine Type I collagen was investigated, building on a large scale computer model of a collagen fibril in water, and focusing on two stages of the leather manufacturing process. The effects of different salts (NaCl, CaCl(2), and Na(2)SO(4)) on the swelling behavior of collagen at low pH (the pickling process) were studied. The salts suppress the swelling of the fibrils at low pH and we find specific stabilizing influences for CaCl(2) and Na(2)SO(4), due to weak Ca(2+)/Cl(-) and strong SO(4) (2-)/lysine/arginine interactions, respectively. Using state-of-the-art sampling techniques, such as the metadynamics algorithm, to allow an efficient exploration of configuration space, we were able to investigate the effect of polyacrylate and poly(methyl acrylate) - two polymeric retanning agents - on the fibril. Both polymers interact with the ammonium groups on the surface, but polyacrylate shows significantly stronger interactions. We suggest that it is this stronger interaction that contributes to the reduced suitability of PAA as a tanning agent.     

Mineralization of biomimetically carboxymethylated collagen fibrils in a model dual membrane diffusion system

In the present work, we show for the first time, that N^?-carboxymethyllysine is the major product of the in vitro non-enzymatic glycation reaction between fibrillar collagen and glucuronic acid. Dual diffusion membrane system was effectively used for oriented crystal growth of octacalcium phosphate/hydroxyapatite on the biomimetically carboxymethylated collagen fibrils. We hypothesize that the function of biomimetically carboxymethylated collagen is to increase the local concentration of corresponding ions in such a way that a critical nucleus of ions can be formed, leading to the formation of the mineral under specific micro-environment conditions achieved by using diffusion membrane system.     

Formation of octacalcium phosphate by heterogeneous nucleation on a titania surface

Biocompatibility of the surfaces of titanium dental implants can be improved by covering them with calcium phosphate crystals, which makes the surface bioreactive. Possibly the most effective bioreactive foreign material that improves osteointegration and adsorption/binding of extracellular proteins and structural proteins is crystalline octacalcium phosphate {2×[Ca₄H(PO₄)₃·2.5H₂O] or Ca₈(HPO₄)₂(PO₄)₄·5H₂O, OCP}. In this work the building up of OCP crystals on the surface of TiO₂ anatase is examined in the process of heterogeneous nucleation from constant-composition solutions of CaCl₂ and KH₂PO₄ at constant pH (pH 6.8) and ionic strength (I=0.05 M), in dense titania suspensions. Constant relative supersaturation with regard to the calcium phosphate formation was maintained by the controlled addition of the reagent solutions, according to the desired speed of crystallization. The surface saturation value of calcium ion adsorption was measured by detecting the pH decrease during CaCl₂ addition in a separate experiment. The OCP crystallization was also conducted on the surface of an evaporated titanium layer, and on titanium metal disks. The surface of the disks was modified by the laser ablation method in order to increase the oxide layer thickness. Calcium phosphate crystals formed on the surface of the modified titanium disks, but not in an appreciable amount on the surface of the evaporated titanium layer.     

Kinetics of calcium phosphate reduction by carbon

A fundamental study was made on the reduction of calcium phosphate by carbon. The mechanism of reduction was presented on applying different additions. Both silica and alumina increased the extent of reduction but with variable rates. The activation energies were calculated on the basis of first-order reactions. The phases formed during reduction were investigated by X-ray analysis.     

Thermoluminescence of bone equivalent calcium phosphate ceramics

TL-glow curves of calcium phosphate ceramic powders prepared either from natural or synthetic phosphates have been investigated. The TL-samples from synthetic phosphates, particularly those having Ca/P ratio=2.8, show higher TL-sensitivity, about 1/10 times that of LiF TLD-100 powders, with glow curves having maxima (peaks) around 110, 175 and 325 °C. The TL-response of all phosphate ceramic samples showed a dependence on -dose, well described by a power function in a range from about 1 to 10⁴ Gy, which is useful for therapeutic and radiation processing levels. For regeneration of irradiated TL-samples, annealing around 350 °C for 20 min was found suitable. A low Ca/P ratio can be recommended for high dose measurements, while higher ratio gives greater TL-sensitivity, hence allowing measurement of lower -doses.     

Termal decomposition of carbonated calcium phosphate apatites

The thermal stability of AB-type carbonated calcium phosphate apatites prepared by precipitation from aqueous media was studied. The behavior of powders was investigated using temperature programmed XRD, infrared spectroscopy and thermogravimetry. In N₂ atmosphere, two successive peaks of decarbonatation with maxima at about 700 and 950°C occurred. This behavior is explained by different substitution modes for carbonates in the apatite. The decarbonatation peaks were shifted to higher temperature under CO₂ (around 900 and 1150°C). The analysis of the thermal stability allowed further densification of carbonate apatite ceramics without important carbonate loss. This revised version was published online in July 2006 with corrections to the Cover Date.     

Heterogeneous nucleation and growth of calcium carbonate on calcite and quartz

The precipitation of calcium carbonate as a binding salt for the consolidation of loose sand formations is a promising approach. The heterogeneous nucleation and growth of calcite were investigated in supersaturated solutions. The ionic activities in the solutions tested were selected so that they included both supersaturations in which crystal growth took place only following the introduction of seed particles and supersaturations in which precipitation occurred spontaneously past the lapse of induction times. In the latter case the supersaturation conditions were sufficiently low to allow the measurement of induction times preceding the onset of precipitation. The stability domain of the calcium carbonate system was established at pH 8.50, 25 degrees C, measuring the induction times in the range between 30 min and 2 h. The rates of precipitation following the destabilization of the solutions were measured from the pH and/or concentration-time profiles. The induction times were inversely proportional and rates proportional to the solution supersaturation as expected. The high-order dependence of the rates of precipitation on the solution supersaturation suggested a polynuclear growth mechanism. Fitting of the induction time-supersaturation data according to this model yielded a value of 64 mJ/m2 for the surface energy of the calcite nucleus. In the concentration domain corresponding to stable supersaturated solutions, seeded growth experiments at constant supersaturation showed a second-order dependence on the rates of crystal growth of calcite seed crystals. Inoculation of the stable supersaturated solutions with quartz seed crystals failed to induce nucleation. Raising supersaturation to reach the unstable domain showed interesting features: calcite seed crystals yielded crystal growth kinetics compatible with the polynuclear growth model, without any induction time. The presence of quartz seed crystals reduced the induction times and resulted in nucleation in the bulk solution. The kinetic data in the latter case were consistent with the polynuclear growth model and the surface energy for the newly forming embryo was calculated equal to 31.1 mJ/m2, because of the dominantly heterogeneous nature of the process.     

Cooperative ordering of collagen triple helices in the dense state

Extracellular matrixes such as bone, skin, cornea, and tendon have ordered structures comprised for the most part of collagen, an elongated protein of well-defined dimensions and composition. Here we show how the cooperative ordering of collagen triple helices in the dense fluid state is exploited to produce dense ordered collagen matrixes. The spontaneous formation of a birefringent phase occurs at critical concentrations that increase from 50-60 to 80-85 mg/mL as the acetic acid concentration of the solvent increases from 5 to 500 mM. We studied by small-angle X-ray scattering (SAXS) the local liquidlike positional order across the isotropic/anisotropic phase transition by unwinding the cholesteric phase with moderate shearing stress. Interparticle scattering gives rise to a broad interference peak. The average distance between triple helices, dav, is thus estimated and decreases linearly as a function of phi-1/2 from 12.7 +/- 0.9 nm (22.5 mg/mL) to 5.0 +/- 0.6 nm (166.4 mg/mL). Equilibrium concentrations and the order parameter of the nematic phase agree reasonably well with theoretical predictions for semiflexible macromolecules. Striated fibrils with a high degree of alignment were obtained by fine-tuning the delicately balanced electrostatic interactions, which yielded strong elastic gels with a hierarchical organization very similar to that of major biological tissues. Typical Bragg reflections corresponding to the 67 nm period characteristic of collagen fibrils in biological tissues were recorded by SAXS with ordered collagen matrixes reconstituted in vitro.