The role of defects in the dissociative adsorption of CO on Ni(100)

We present a molecular beam study on the dissociative sticking coefficient for CO on a Ni(100) surface. In the range from 1.6 to 20 kcal/mol the observed dissociative sticking coefficient at a surface temperature of 500 K is 0.02 and independent of beam energy. Investigations on a sputter-damaged surface result in a sticking coefficient of 0.40, again independent of beam energy. The observed behavior can be explained by CO dissociation at defect sites.     

Density-functional study of methanol adsorption on the Al(100) surface

The interaction of methanol (CH₃OH) molecules with the Al(100) surface is investigated in the framework of the density-functional theory. Numerical parameters, such as the decrease in the kinetic energy, number of special points used for integration over the Brillouin zone, broadening of the filling function, and number of atomic metal layers, are determined. The density-functional theory calculations with these parameters offer reliable data on the total energy and structural optimization of the system under consideration. The geometric characteristics of a methanol molecule in both isolated and adsorbed states on the metal surface are calculated. It is shown that the electron pseudodensity at the metal surface changes in the presence of an adsorbed molecule. The influence of the orientation of the methanol molecule (with respect to the metal surface and nearest neighbor methanol molecules) on the total energy of the system is analyzed. It is found that the total energy of the system is affected by the metal deformation and the interaction of adsorbed molecules with each other.     

Partially dissociative adsorption of water vapor on the Si(111) (7×7) surface

High-resolution vibrational electron energy-loss spectra have been measured of the Si(111) (7×7) surface exposed to water vapor at 300 K. Direct experimental evidence is given that water adsorption on the Si(111) (7×7) surface is partially dissociative.     

Stereodynamics in dissociative adsorption of NO on Si(111)

We report results of our study on the surface-temperature dependence of the steric effect in the dissociative adsorption of NO on Si(111)-(7x7). Data presented here show that, at an incident energy of 58 meV, the reactive sticking probability for the N-end collision is larger than that for the O-end collision. Furthermore, this steric preference is quite sensitive to the surface temperature and the surface coverage. This study shows that the transient surface trapping into a shallow precursor well plays a key role in the stereodynamics of the dissociative adsorption at the low energy region.     

Effects of surface corrugation on the molecular rotational dependence of H2 dissociative adsorption dynamics on Cu(100)

We investigate and discuss how surface corrugation affects the molecular rotational dependence of H₂ dissociative adsorption dynamics on Cu(100) by performing six-dimensional (6D) quantum dynamics calculations. We calculate the dissociative adsorption probability as a function of the initial rotational state J and the normal energy E_norm of incident molecules, and compare with the dissociative adsorption results obtained by four-dimensional (4D) quantum dynamics calculations where the surface is treated as flat. In our calculation, for the case of normal incidence, the increase in dissociative adsorption probability with increasing E_norm and the non-monotonic behavior of dissociative adsorption probability with respect to J are suppressed on a corrugated surface as compared to that on a flat surface.     

Low temperature XPS and AES studies of O2 adsorption on Al(100)

Adsorption of O₂ on Al(100) at 80 K was studied by means of Auger and XP spectroscopies. At low surface coverages Al_xO_y oxides were formed with x : y ratios from 3 : 1 to 1 : 1, depending on surface coverage. At higher coverages or heating to room temperature the oxide layer transformed to the familiar Al₂O₃.     

Chalcogen adsorption on Ni(100)

The successive stages of the oxidation of Ni(100) have been investigated by angle-resolved uv photoemission. The adsorption spectra are very similar to that measured previously for the same surface saturated with sulphur. Results are interpreted using recent theoretical calculations. It is found that this interpretation can be extended to the other chalcogens adsorbed on Ni(100). When increasing oxygen exposures, photoemission spectra have shown a continuity of the electronic character in the oxidation process.     

Hydrogen adsorption on Ni (100)

The adsorption of hydrogen on the (100) plane of nickel at room temperature has been investigated using the technique of flash desorption spectroscopy. It is shown that no variation in the adsorption enthalpy of 23.1 kcal/mole occurs during the chemical cleaning of the surface by repeated oxidation and reduction. The number of adsorption sites does however increase to 3.3×10¹⁴/cm² during this process. Determination of the partition functions of the adsorbed species and of the activated complex indicates that the hydrogen atoms are localised on specific adsorption sites but that greater liberty exists in the activated complex. Finally the experimental desorption spectra may be described using a model with a repulsive interaction of 400 cal/mole between nearest neighbours.     

Substitutional adsorption of K on Fe(100)

The adsorption of potassium on Fe(100) was studied by time-of-flight forward scattering and recoiling spectroscopy (TOF-SARS), low energy electron diffraction (LEED) and Auger electron spectroscopy (AES). After heating to 650 K of the potassium saturated surface the formation of a p(3 × 3) potassium superstructure was observed by LEED. TOF-SARS experiments ruled out the adsorption of potassium in the on-top, bridge and four-fold hollow site. The only site which is in agreement with all experimental results is the substitutional site where K replaces an Fe atom of the topmost layer of the crystal. This is the first time a substitutional adsorption site has been found on a bcc surface. On an fcc surface such an adsorption site has been found recently for adsorption of sodium and potassium on Al(111).     

H2在Al12X (X=Al, Ni, Cu)团簇表面解离吸附的第一性原理研究

以Ni和Cu原子中心替换的二十面体Al12X(X=Ni、Cu)团簇为基体、采用密度泛函理论系统计算研究了H原子及H2分子在团簇表面的吸附,并对比了纯Al13团簇对H及H2的吸附,结果表明：相对于纯Al13中H原子的桥位吸附、掺杂团簇Al12X(X=Ni、Cu)中H原子均吸附于团簇顶位;无论是吸附H原子还是H2分子,Al12Ni的几何结构均发生大的畸变;相较H2在纯Al13团簇表面的解离吸附,H2在掺杂团簇Al12X(X=Ni、Cu)表面的解离反应过程中反应能均增大、势垒均降低,这表明掺杂团簇Al12X(X=Ni、Cu)相较纯Al13团簇更有利于H2解离吸附的发生。     

Oxygen adsorption on clean Mo (100) surfaces

Oxygen adsorption on clean Mo (100) surfaces has been studied by LEED, AES, work function changes and energy loss spectroscopy. At room temperature, the oxygen uptake as determined by AES is linear up to one third of the saturation value. Data obtained with CO adsorption have been used to determine the oxygen coverage. With increasing oxygen exposure LEED shows three stages: a c (2 × 2) phase growing simultaneously with a (6 × 2) structure, a stage with (110) microfacets covered by two-dimensional structures and finally a p (3×1) structure together with a p (1×1) structure, probably due to an oxide phase. Even in the low temperature range (370–500 K) remarkable effects are observed: adsorption at 370 K produces a disordered c (4×4) structure which is followed by a (√5 × √5)?R 26° 33 structure. The same occurs when the inital c (2 × 2) structure formed at 295 K is heated above 370 K. Measurements of the work function indicate a minimum at the end of the c (2×2) structure, then a rapid increase and at saturation a value of about 1.5 V above that of the clean surface. Energy loss spectroscopy measurements point to an increase of the surface plasmon energy during the faceting stage. New transitions are observed which are due to new electronic levels induced by the adsorption. They are comparable with photoemission results on W and Mo.     

Carbon monoxide adsorption kinetics on molybdenum (100)

In an ultrahigh vacuum system (10^?10 torr) LEED, Auger spectroscopy, flash desorption and work-function measurements have been used to follow the kinetics of adsorption of carbon monoxide on the (100) face of a molybdenum single crystal. At room tempeiature CO adsorbs into three β states β₁, β₂, β₃, which are associated with different work-function changes: the phase β₃ is found to correspond to a decrease of work-function whereas the phases β₁ and β₂ correspond to an increase. The total change of surface potential is about 0.50 eV at saturation. An ordered C (2×2) structure is found for the β₂ + β₃ phases, and is associated at their maximum coverage (about half a monolayer) with a work-function change of + 0.070 eV with respect to the clean surface. At completion of the monolayer a P (1×1) structure is observed.     

Oxygen adsorption on stepped Pd(100) surfaces

We use scanning tunneling microscopy (STM) and high-resolution core-level spectroscopy (XPS) measurements to study the initial oxidation of vicinal Pd(100) surfaces exhibiting close-packed (111) steps. The XPS data analysis is supported by detailed surface-core level shift calculations based on density-functional theory. Both STM images and the XPS spectra are found to be perfectly consistent with a characteristic zigzag O decoration of the Pd steps predicted by a preceding cluster-expansion based theoretical study [Y. Zhang and K. Reuter, Chem. Phys. Lett. 465, 303 (2008)]. Continued oxygen uptake leads to the additional stabilization of a p(2 × 2)-O overlayer on the Pd(100) terraces, and ultimately to step bunching with the resulting large Pd(100) terraces covered by the PdO(101) surface oxide.     

CO adsorption on alkali-metal covered Ni(100)

The effect of preadsorbed alkali metal atoms Na, K and Cs on CO adsorption on Ni(100) has been studied using Auger spectroscopy and thermal desorption. It was found that the presence of alkali metals causes an appearance of several more tightly bound states in the CO thermal desorption spectra. The observed difference in carbon and oxygen Auger peak line shape on a bare and alkali modified Ni(100) is indicative that the presence of alkali adatoms induces CO decomposition on the Ni(100) surface. The fraction of dissociated CO increases with the amount of alkali adatoms present. At the same overlayer coverage the dissociation probability increases in the sequence Na, K, Cs. A comparison of the strength of the promoting effect on CO dissociation with the changes in the surface electron density in the presence of alkali adatoms has shown that at low overlayer coverages the electronic factor plays a major role in explaining the action of the surface modificators.     

Alkali adsorption on the Al(001) surface

The chemisorption of Na on the Al(001) surface has been studied by 2D bandstructure calculations on slab models using a density functional STO-LCAO method. Two slab models of three and five layers of substrate atoms have been used. Overlayers of the structuresp(2×2),c(2×2) andp(1×1), representing coverages of a quarter, a half and a full atomic monolayer of sodium atoms, respectively, have been investigated. The electronic structure of the adatoms and the charge transfer to the substrate are discussed. Satisfactory agreement with experiment is obtained for the adsorption induced change of the work function, correctly reproducing its monotonic character.     

The energetics of mercury adsorption on Cu(100)

We have investigated the adsorption of mercury overlayers on Cu(100) by atom beam scattering, low energy electron diffraction and angle resolved photoemission. From our data we have calculated the isosteric heats in the adsorbed Hg layer on Cu(100) and compared these with results obtained for mercury on Fe(100), W(100) and Ni(100). We observe changes in the isosteric heat of adsorption that can be associated with the ordering of a c(2 × 2) Hg overlayer phase and the transition from a c(2 × 2) overlayer to a c(4 × 4) overlayer. The isosteric heat of adsorption is 0.50 ± 0.07 eV/atom (48 ± 7 kJ/mol) at zero coverage and reaches a maximum of 0.73 ± 0.04 eV/atom (70 ± 4 kJ/mol). From a combination of ABS and LEED, the structures of the two equilibrium ordered phases of Hg on Cu(100) have been identified, as well as the structures of several non-equilibrium phases.