Analysis of composite material interface crack face contact and friction effects using a new node-pairs contact algorithm

A new node-pairs contact algorithm is proposed to deal with a composite material or bi-material interface crack face contact and friction problem(e.g., resistant coating and thermal barrier coatings) subjected to complicated load conditions.To decrease the calculation scale and calculation errors, the local Lagrange multipliers are solved only on a pair of contact nodes using the Jacobi iteration method, and the constraint modification of the tangential multipliers are required. After the calculation of the present node-pairs Lagrange multiplier, it is turned to next contact node-pairs until all node-pairs have finished. Compared with an ordinary contact algorithm, the new local node-pairs contact algorithm is allowed a more precise element on the contact face without the stiffness matrix singularity. The stress intensity factors(SIFs) and the contact region of an infinite plate central crack are calculated and show good agreement with those in the literature. The contact zone near the crack tip as well as its influence on singularity of stress fields are studied. Furthermore, the frictional contacts are also considered and found to have a significant influence on the SIFs. The normalized mode-II stress intensity factors K?IIfor the friction coefficient decrease by 16% when f changes from 1 to 0.     

Measurement of Stress Intensity Factors of a Mixed-Mode Interface Crack by a Speckle Photography

The image-processing system based on a two-dimensional Fourier transform is presented for the analysis of Young’s fringes pattern created from a double-exposure speckle photograph. The fringe spacing and orientation are determined using only one Young’s fringes pattern without any other diffraction halo patterns. The stress-intensity factors of a mixed-mode interface crack were measured by speckle photography. A compact normal and shear specimen with an interface crack was employed. This specimen enables us to carry out the experiment under various kinds of mixed-mode loading. A steel and an epoxy resin were used as dissimilar materials. The displacement along the crack lines at the free surface was measured by speckle photography. The K₁ and K₁₁ values were determined by a least squares method using displacement data along the crack lines. Three-dimensional finite element analysis was carried out on the same specimen. An accuracy of stress intensity factors obtained by the speckle photography was discussed by comparison of results obtained by the finite element analysis.Presented at 1996 International Workshop on Interferometry (IWI ‘96), August 27–29, Saitama, Japan.     

X波段六腔渡越管振荡器的高频特性研究

 从麦克斯韦方程出发，采用时域有限差分法（FDTD）和离散傅里叶变换（DFFT）相结合的方法，通过数值计算得出了六腔开放式谐振腔中前四个谐振频率和场分布，计算出的谐振频率与实验测量结果基本相同。比较了开放腔和封闭腔谐振频率，验证了TEM波吸收边界条件，并在实际编程计算中得以应用。计算结果为六腔渡越管振荡器的机理研究提供了依据。     

Numerical simulation of the EM scattering and Doppler spectrum of a low flying target above dynamic oceanic surface by using the FEM-DDM method

The Doppler (DP) spectrum of a moving target such as a ship, an iceberg or an air-plane above dynamic oceanic surfaces[1—3] is one of the most important subjects for ra-dar oceanic surveillance, target tracking and oceanic remote sensing[4—7]. With the ad-vancement of oceanic remote sensing and radar surveillance, the experimental observa-tion and theoretical modeling of oceanic clutter have been extensively studied, e.g. by using oceanic field measurement, wave tank experiment and some stud…