Pre-fibrillation of pulps to manufacture cellulose nanofiber-reinforced high-density polyethylene using the dry pulp direct kneading method

The dry pulp direct kneading method is an industrially viable, low-energy process for manufacturing cellulose nanofiber (CNF)-reinforced polymer composites, where the chemically modified pulps are nanofibrillated and uniformly dispersed in the polymer matrix during melt compounding. In the present study, cellulose fibers of various sizes ranging from surface-fibrillated pulps (20 μm in width) to fine CNFs (20 nm in width) were prepared from softwood bleached kraft pulps using a refiner and a high-pressure homogenizer. These cellulose fibers were modified with alkenyl succinic anhydride and dried. The dried fibers were used as a feed material for melt compounding in the dry pulp direct kneading method to fabricate CNF-reinforced high-density polyethylene (HDPE). When surface-fibrillated pulps were employed as a feed material, the pulps were nanofibrillated and dispersed uniformly in the HDPE matrix during melt compounding. The resulting composites had much better properties—i.e., much higher tensile modulus and strength values, and much lower coefficient of thermal expansion values—than the composites produced using pulps without pre-fibrillation. However, when CNFs were used as a feed material, they were shortened and agglomerated during melt compounding, and the properties of the composites consequently deteriorated. The study concludes that surface-fibrillated pulp, which can be produced cost-effectively using a refiner on an industrial scale, is more suitable as a feed material than CNFs for melt compounding in the dry pulp direct kneading method. This finding enables the elimination of a preliminary step in the preparation of CNFs from pulps, which is a time-consuming and energy-intensive process.

Graphical abstract