Fabrication of Fluoropolymer Microtubes via RAFT Copolymerization of N,N′‐Methylene Bisacrylamide Gel Fibers and Fluoromonomer

Fluoropolymer microtubes with a smooth surface were fabricated in more than 70 % yield via reversible addition fragmentation chain transfer (RAFT) co‐polymerization of N,N′‐methylene bisacrylamide (MBA) gel fibers as both template and monomer, 2‐(perfluoro‐3‐methylbutyl)ethyl acrylate (R‐3420) as co‐monomer, and pentaerythritol tetraacrylate (PET4A) as cross‐linker. The resulting fluoropolymer microtubes were characterized fully by SEM, TEM, EDS, XPS, and FT‐IR. The influence of the monomer composition on the yields and morphologies of the tubes were investigated in detail. The results indicated that polymer microtubes with a smooth surface were obtained at suitable amounts of R‐3420 and PET4A. Because of the decreased solubility of MBA gel fibers, the wall thickness increased as more R‐3420 was used. In the presence of PET4A, the solution polymerization could be facilitated and more R‐3420 could be attached onto the tubes based on FT‐IR analysis. The water contact angle and swelling ratio measurements both revealed the low hydrophilicity and high lipophilicity of the fluoropolymer microtubes, which made the sample able to absorb toluene selectively in a water/toluene two‐phase system.