首页 | 本学科首页   官方微博 | 高级检索  
     检索      

金负载量对低温水煤气变换Au/α-Fe2O3催化剂结构和性能的影响
引用本文:华金铭,郑起,林性贻,魏可镁.金负载量对低温水煤气变换Au/α-Fe2O3催化剂结构和性能的影响[J].燃料化学学报,2003,31(6):558-563.
作者姓名:华金铭  郑起  林性贻  魏可镁
作者单位:National Research Center of Chemical Fertilizer Catalysts, Fuzhou University, Fuzhou 350002, China
基金项目:国家自然科学基金(20271012);福建省科技计划项目(2002H026)
摘    要:采用共沉淀法制备了低温水煤气变换Au/α-Fe2O3催化剂。通过正交实验优化催化剂的还原活化条件,考察了金负载量对催化剂性能的影响。采用BET、XRD、UV-VIS、XRF、H2-TPR和O2-TPO等表征手段对催化剂的结构进行分析,并与其催化性能进行关联。结果表明,(1)采用10%-H2/N2还原气将催化剂在150 ℃原位还原9 h,其催化活性最高;(2)金的最佳负载量为8.00%,此时在催化剂制备过程中金的流失量较少,金粒子较小,也有利于抑制催化剂在反应过程中烧结;(3)TPR-TPO结果表明,金的负载量为8.00%时,Au/α-Fe2O3催化剂具有较易被还原、不易被氧化的性质,从而显示出最高催化活性。(4)Au/α-Fe2O3催化剂中的金以单质金(Au0)形式存在;其高活性与Au0-Fe3O4间的协同作用有关。

关 键 词:低温水煤气变换  Au/α-Fe2O3催化剂  金负载量  还原氧化性质  
文章编号:0253-2409(2003)06-0558-06
收稿时间:2002-12-10
修稿时间:2002年12月10

INFLUENCE OF Au LOADING ON THE STRUCTURE AND CATALYTIC PERFORMANCE OF Au/α-Fe2O3 CATALYSTS FOR LOW-TEMPERATURE WATER-GAS SHIFT REACTION
HUA Jin-ming,ZHENG Qi,LIN Xing-yi,WEI Ke-mei.INFLUENCE OF Au LOADING ON THE STRUCTURE AND CATALYTIC PERFORMANCE OF Au/α-Fe2O3 CATALYSTS FOR LOW-TEMPERATURE WATER-GAS SHIFT REACTION[J].Journal of Fuel Chemistry and Technology,2003,31(6):558-563.
Authors:HUA Jin-ming  ZHENG Qi  LIN Xing-yi  WEI Ke-mei
Abstract:In this paper, supported Au/α-Fe2O3 catalyst for low-temperature water-gas shift reaction(WGSR) was prepared through co-precipitation method. The reduction procedure was optimized to activate the category of gold catalysts, which involves rhombization of reduction conditions, i.e. reductive gas composition, reduction temperature, and reduction time, using 8.00%Au/α-Fe2O3 catalyst as sample. It was found that the sample, pre-reduced under 150 ℃ for 9 h in reductive gas flow (10% -H2/N2) , exhibits the higher activity. Then the influence of gold loading on the ultimately WGSR activity of Au/α-Fe2O3 catalyst was investigated due to the precious cost of gold, wherein its loading was controlled through adjusting the atomic ratio Au/Fe. The 8.00% Au/α-Fe2O3 catalyst shows the highest activity. The structure of Au/α-Fe2O3 catalysts with different gold loadings were studied by BET, XRD, XRF, UV-VIS, H2-TPR and O2-TPO characterization techniques. The introduction of gold during co-precipitation may suppress catalyst sintering during WGS reaction. During the preparation, the loss of gold will occur; the loss becomes more serious if the designed gold amount is increased. Moreover it will lead to the aggregation of gold particle, which was revealed by XRD and UV-VIS results. The Au/α-Fe2O3 catalysts with optimal Au loading (8.00%) shows the highest activity owing to the present of moderate Au0 particle and theα-Fe2O3 support holding susceptible reduction but resistant to oxidation, revealed by the TPR-TPO results. Therefore, the high catalytic activity of the investigated catalyst was attributed to the synergism between Au0 and Fe3O4.
Keywords:Au/α-Fe2O3 catalysts  gold loading  red-ox properties  
本文献已被 CNKI 维普 万方数据 等数据库收录!
点击此处可从《燃料化学学报》浏览原始摘要信息
点击此处可从《燃料化学学报》下载免费的PDF全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号