首页 | 本学科首页   官方微博 | 高级检索  
     检索      

以类水滑石为前驱体的Cu/Zn/Al/(Zr)/(Y)催化剂制备及其催化CO_2加氢合成甲醇的性能
引用本文:高鹏,李枫,赵宁,王慧,魏伟,孙予罕.以类水滑石为前驱体的Cu/Zn/Al/(Zr)/(Y)催化剂制备及其催化CO_2加氢合成甲醇的性能[J].物理化学学报,2014,30(6):1155-1162.
作者姓名:高鹏  李枫  赵宁  王慧  魏伟  孙予罕
作者单位:1.Center for Greenhouse Gas and Environmental Engineering, Shanghai Advanced Research Institute, Chinese Academy of Sciences, Shanghai 201203, P. R. China;2.State Key Laboratory of Coal Conversion, Institute of Coal Chemistry, Chinese Academy of Sciences, Taiyuan 030001, P. R. China;3.Chinese Academy of Sciences Key Laboratory of Low-Carbon Conversion Science and Engineering, Shanghai Advanced Research Institute, Chinese Academy of Sciences, Shanghai 201203, P. R. China
基金项目:科技部国家科技支撑计划(2013BAC11B02)和中国科学院战略性先导科技专项(XDA05010109,XDA05010110,XDA05010204)资助项目
摘    要:采用共沉淀法合成了Cu:Zn:Al:Zr:Y原子比分别为2:1:1:0:0、2:1:0.8:0.2:0、2:1:0.8:0:0.2和2:1:0.8:0.1:0.1的Cu/Zn/Al/(Zr)/(Y)类水滑石化合物.将前驱体材料在空气中500°C焙烧后得到复合金属氧化物,并将其用于CO2加氢合成甲醇反应.采用X射线衍射(XRD)、热重(TG)分析、N2吸附、氧化亚氮(N2O)反应吸附、氢气程序升温还原(H2-TPR)和H2/CO2程序升温脱附(H2/CO2-TPD)技术对所制备的样品进行表征.结果表明,Zr和Y的引入使得催化剂BET比表面积大幅增加,金属铜的比表面积和分散度均按以下顺序依次增加:Cu/Zn/AlCu/Zn/Al/ZrCu/Zn/Al/YCu/Zn/Al/Zr/Y,然而,强碱位数目占总碱位数目的比例的变化顺序为:Cu/Zn/AlCu/Zn/Al/YCu/Zn/Al/Zr/YCu/Zn/Al/Zr.活性评价结果揭示CO2转化率取决于金属铜的比表面积,甲醇选择性则随强碱位比例的增加而线性增加.因而,Zr和Y的引入有利于甲醇的合成,Cu/Zn/Al/Zr/Y催化剂上的甲醇收率最高.

关 键 词:类水滑石前驱体  助剂  Cu/Zn/Al催化剂  二氧化碳加氢  甲醇  
收稿时间:2014-02-10
修稿时间:2014-04-02

Preparation of Cu/Zn/Al/(Zr)/(Y) Catalysts from Hydrotalcite-Like Precursors and Their Catalytic Performance for the Hydrogenation of CO2 to Methanol
GAO Peng,LI Feng,ZHAO Ning,WANG Hui,WEI Wei,SUN Yu-Han.Preparation of Cu/Zn/Al/(Zr)/(Y) Catalysts from Hydrotalcite-Like Precursors and Their Catalytic Performance for the Hydrogenation of CO2 to Methanol[J].Acta Physico-Chimica Sinica,2014,30(6):1155-1162.
Authors:GAO Peng  LI Feng  ZHAO Ning  WANG Hui  WEI Wei  SUN Yu-Han
Institution:1.Center for Greenhouse Gas and Environmental Engineering, Shanghai Advanced Research Institute, Chinese Academy of Sciences, Shanghai 201203, P. R. China;2.State Key Laboratory of Coal Conversion, Institute of Coal Chemistry, Chinese Academy of Sciences, Taiyuan 030001, P. R. China;3.Chinese Academy of Sciences Key Laboratory of Low-Carbon Conversion Science and Engineering, Shanghai Advanced Research Institute, Chinese Academy of Sciences, Shanghai 201203, P. R. China
Abstract:Cu/Zn/Al/(Zr)/(Y) hydrotalcite-like compounds with Cu:Zn:Al:Zr:Y atomic ratios of 2:1:1:0:0, 2:1: 0.8:0.2:0, 2:1:0.8:0:0.2, and 2:1:0.8:0.1:0.1 were prepared using the coprecipitation method. The mixed oxides were then obtained by the calcination of the precursors at 500 ℃ in air, and subsequently evaluated in terms of their catalytic performance for the synthesis of methanol from the hydrogenation of CO2. The asprepared samples were characterized by X-ray diffraction (XRD), thermogravimetric (TG) analysis, N2 adsorption, reactive N2O adsorption, H2 temperature-programmed reduction (H2-TPR), and H2/CO2 temperature-programmed desorption (H2/CO2 TPD) techniques. The results of these analyses showed that the BET specific surface area increased significantly with the introduction of Zr and Y, which was related to the amount of H2O and CO2 evolved from the precursors during calcination. The Cu specific surface area and Cu dispersion properties increased in the order of Cu/Zn/Al2 revealed that the CO2 conversion was dependent on the Cu specific surface area, and the CH3OH selectivity increased linearly as the proportion of strongly basic sites increased. The introduction of Zr and Y therefore favored the production of methanol and the maximum CH3OH yield was obtained over the Cu/Zn/Al/Zr/Y catalyst.
Keywords:Hydrotalcite-like precursor  Modifier  Cu/Zn/Al catalyst  2 hydrogenation'  ')  CO2 hydrogenation" target="_blank">">CO2 hydrogenation  Methanol
本文献已被 CNKI 等数据库收录!
点击此处可从《物理化学学报》浏览原始摘要信息
点击此处可从《物理化学学报》下载免费的PDF全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号