Effects of structural defects on the compressive buckling of boron nitride nanotubes

In this paper, we examined the buckling of perfect and defective armchair boron nitride nanotubes with three types of vacancy defects, i.e. B- and N- single vacancy defects and B–N- double vacancy defect, using molecular dynamics simulations. To this end, all systems were modeled with a Tersoff-type potential, which is able to accurately describe covalent bonding of BN systems. We applied external uniaxial compressive forces to the nanotubes in vacuum and derived the critical buckling loads and strains, at room temperature in an NVT-ensemble. Our results showed significant differences between the critical buckling strengths of pristine and defective nanotubes. The resistance to axial buckling decreased with the introduction of one vacancy defect, and the B–N- double vacancy was the most seriously damaged structure, followed by B-vacancy and N-vacancy defects. Furthermore, the B-vacancy was shown to have the most significant effect on the decrease of the critical buckling strain. This can be attributed to the excessive asymmetries and perturbations induced in the structure of the nanotube and the local deformations around the defective site around the B-vacancy, even before loading. Moreover, results show that reduction in the buckling strength of the nanotube due to the presence of more than one B-vacancy defect depends on their distribution. If the two or three defects are close to each other, they act as a single point of weakness and the critical buckling load is only slightly reduced (similar to the existence of only one vacancy defect). However, if the defects are at more distant points, the critical buckling load may experience a higher decrease. Results show that vacancy defects play a critical role in the compressive buckling performance of boron nitride nanotubes and special attention must be paid to the presence of structural defects when designing members against buckling, especially for micro- and nano-electro-mechanical systems. On the other hand, defect engineering is a great means for tailoring the buckling strength of boron nitride nanotubes, in cases where the nanotube is expected to absorb energy through compressive buckling deformation and is not designed against, but for buckling.