首页 | 本学科首页   官方微博 | 高级检索  
     检索      

聚丙烯酸酯泡沫密度均匀性控制
引用本文:单雯雯,袁保和,徐家云,张林,王燕红.聚丙烯酸酯泡沫密度均匀性控制[J].强激光与粒子束,2010,22(2).
作者姓名:单雯雯  袁保和  徐家云  张林  王燕红
作者单位:1. 华北水利水电学院 数学与信息科学学院, 郑州 450011; 2.中国工程物理研究院 激光聚变研究中心, 四川 绵阳 621900; 3. 四川大学 物理与科学技术学院, 成都 610065
基金项目:国家自然科学基金项目,高温高密度等离子体物理国防科技重点实验室基金项目,中国工程物理研究院基金项目 
摘    要:低密度泡沫材料大多存在一定程度的密度不均匀性,这对其后续使用性能将带来不良影响。简述了ICF靶用聚丙烯酸酯泡沫的制备方法,对其密度不均匀性形成机理进行理论分析。在此基础上,改进其制备工艺,控制泡沫密度分布,并利用β射线检测技术,对制备工艺改进前后直径为mm量级的低密度聚丙烯酸酯泡沫柱进行密度分布表征。研究结果表明:改用聚四氟乙烯代替玻璃模具,有利于制得密度分布均匀的泡沫样品;选用最高的紫外光的能量,能促进自由基均匀分布,从而最终能够提高泡沫的密度均匀性。采用β射线对密度范围为10~100 mg.cm-3的TMPTA泡沫的密度均匀性进行表征,结果表明:随着泡沫密度的降低,密度均匀性越低,对制备工艺要求越高。

关 键 词:丙烯酸酯  泡沫  密度均匀性  β射线
收稿时间:1900-01-01;

Controlling of density uniformity of polyacrylate foams
ShanWenwen,YuanBaohe,XuJiayun,ZhangLin,WangYanhong.Controlling of density uniformity of polyacrylate foams[J].High Power Laser and Particle Beams,2010,22(2).
Authors:ShanWenwen  YuanBaohe  XuJiayun  ZhangLin  WangYanhong
Institution:1. College of Mathematics and Information Science, North China Institute of Water Conservancy and Hydroelectric Power, Zhengzhou 450011, China; 2. School of Physical Science and Technology, Sichuan University, Chengdu 610065, China; 3. Research Center of Laser Fusion, CAEP, P. O. Box 919-987, Mianyang 621900, China
Abstract:The density non-uniformity exsiting in most low-density foams will affect performance of the foams.The trimethylolpropane trimethacrylate(TMPTA) foam targets were prepared and controlling methods of the foams,density uniformity were explored together with its forming mechanism.It has been found that the UV-light with high intensity can improve the distribution uniformity of the free radicals induced by UV photons in the solvents,thus improve the density uniformity of the foams.In addition,container wall wou...
Keywords:acrylate  Foam  density uniformity
本文献已被 CNKI 万方数据 等数据库收录!
点击此处可从《强激光与粒子束》浏览原始摘要信息
点击此处可从《强激光与粒子束》下载免费的PDF全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号