Evaluation of the geopolymer/nanofiber interfacial bond strength and their effects on Mode-I fracture toughness of geopolymer matrix at high temperature

The present article has reported the effects of several nanofiller’s aspect ratio, length and interfacial strength on Mode-I fracture toughness (K_IC) of geopolymer as the matrix of continuous fibre reinforced composites. These nanofillers have been chosen based on the variations in the surface chemistry and nature of interfacial bonding with geopolymer, which include Carbon, Alumina and Silicon carbide. Geopolymer matrix was subjected to the addition of single volume fraction, 2% of each type of nanofiller with two aspect ratios, designated as nanoparticles and nanofibers. Notched beam flexure tests (SEVNB) of neat and each nanofiller reinforced samples suggest that, while baseline K_IC of neat geopolymer improved with heat treatment, nanofibers with high interfacial bond strength showed maximum capability in further improving K_IC. Among those nanofibers, 2 vol% Silicon Carbide Whisker (SCW) showed the largest improvement in K_IC of geopolymer, which is ~164%. After heat treatment at 650 °C, SCW reinforcement was also found to be effective, with only ~28% lower than the reinforcing performance at 250 °C, while the performance of Alumina Nanofiber reinforced geopolymer notably reduced. SEM and EDS analysis suggested that the inhomogeneity in neat geopolymer and length of nanofibers control the reinforcing capability as well as crack propagation resistance of geopolymer. For instance, minimum length of nanofillers to toughen this geopolymer at 250 °C was required as ~2 μm. The results further suggested that the sample failure occurred due to the dominance of tensile failure of nanofibers over the interfacial separation.