Fluorescent detection of peptides and amino acids for capillary electrophoresis via on-line derivatization with 4-fluoro-7-nitro-2,1,3-benzoxadiazole

An in-capillary derivatization of amino acids and peptides with 4-fluoro-7-nitro-2,1,3-benzoxadiazole (NBD-F) was developed for their subsequent capillary electrophoretic analysis with laser-induced fluorescence detection (λ _ex=488 nm). The in-capillary derivatization was achieved in zone-passing mode by introducing successive plugs of sample and NBD-F into a fused silica capillary previously equilibrated with an alkaline borate buffer. To prevent NBD-F hydrolysis and to achieve a reliable derivatization, NBD-F was prepared daily in absolute ethanol and a plug of absolute ethanol was introduced between the sample and NBD-F reagent plugs. Various parameters influencing the derivatization efficiency were investigated and the optimum conditions were as follows: background electrolyte (BGE), 20 mM borate buffer (pH 8.8); introduction time, 4 s for sample and 2 s for NBD-F; molar ratio of NBD-F/sample, above 215; temperature, 45 °C for amino acids and 35 °C for peptides; applied voltage, +15 kV. The validation of the in-capillary derivatization method under optimal conditions showed a good linearity between the heights of the derivative peaks and the concentrations of the amino acids. The intra-day relative standard deviations of the migration times and the peak heights were less than 1.3% and 4.6%, respectively. The efficient derivatization and separation of a mixture of valine, alanine, glutamic acid and aspartic acid were achieved using this technique. Peptides such as buccaline and β-protein fragment 1–42 could also be derivatized using the developed in-capillary derivatization procedure. In‑capillary derivatization and separation of amino acids with different concentrations. From the top to bottom the concentrations are 1.11×10⁻⁵ M, 5.55×10⁻⁶ M, 2.78×10⁻⁶ M, 6.95×10⁻⁷ M. for valine; 1.26×10⁻⁵ M, 6.30×10⁻⁶ M, 3.15×10⁻⁶ M, 7.88×10⁻⁷ M for alanine; 3.78×10⁻⁵ M, 1.89×10⁻⁵ M, 9.45×10⁻⁶ M, 2.36×10⁻⁶ M for glutamic acid;, 4.27×10⁻⁵ M, 2.14×10⁻⁵ M, 1.07×10⁻⁵ M, 2.68×10⁻⁶ M for aspartic acid. Experiment conditions: injection order: 4s for sample, 1s for absolute ethanol, and then 2s for 5.24×10⁻² M NBD‑F; BGE: 20 mM borate pH 8.77; Applied voltage: 15 kV.