首页 | 本学科首页   官方微博 | 高级检索  
     

ZnO薄膜的分子束外延生长及性能
引用本文:周映雪,俞根才,吴志浩,张新夷. ZnO薄膜的分子束外延生长及性能[J]. 发光学报, 2004, 25(3): 287-290
作者姓名:周映雪  俞根才  吴志浩  张新夷
作者单位:复旦大学,物理系,应用表面物理国家重点实验室,上海,200433;复旦大学,同步辐射研究中心,上海,200433;复旦大学,物理系,应用表面物理国家重点实验室,上海,200433;复旦大学,同步辐射研究中心,上海,200433
基金项目:国家重点基础研究专项 (G2 0 0 1cb3 0 95 0 5 )资助项目
摘    要:利用分子束外延(MBE)和氧等离子体源辅助MBE方法分别在Si(100)、GaAs(100)和蓝宝石Al2O3(0001)衬底上用Zn、ZnS或以一定Zn-O化学计量比作缓冲层,改变衬底生长温度和氧压,并在氧气氛下,进行原位退火处理,得到ZnO薄膜。依据X射线衍射(XRD)图,表明样品的结晶性能尚好,且呈c轴择优取向;实验结果表明在不同衬底上生长的ZnO薄膜,由于晶格失配度不同,其衍射峰也有区别。用原子力显微镜(AFM)观测薄膜的表面形貌,为晶粒尺寸约几十纳米的ZnO纳米晶,且ZnO晶粒呈六边形柱状垂直于衬底的表面。采用掠入射X射线反射率法测膜厚。在360nm激发下,样品的发光光谱是峰值为410,510nm的双峰谱,是与样品表面氧缺陷有关的深能级发光。

关 键 词:氧化锌  分子束外延  X射线衍射  纳米晶  发光
文章编号:1000-7032(2004)03-0287-04
修稿时间:2003-03-20

MBE Preparation and Characterization of ZnO Thin Film
ZHOU Ying xue ,,YU Gen cai ,WU Zhi hao ,ZHANG Xin yi . MBE Preparation and Characterization of ZnO Thin Film[J]. Chinese Journal of Luminescence, 2004, 25(3): 287-290
Authors:ZHOU Ying xue     YU Gen cai   WU Zhi hao   ZHANG Xin yi
Affiliation:ZHOU Ying xue 1,2,YU Gen cai 1,WU Zhi hao 2,ZHANG Xin yi 1,2
Abstract:By using the molecular beam epitaxy (MBE) and plasma assisted MBE with oxygen atmosphere, the ZnO thin films were deposited on Si(100),GaAs(100) and Al 2O 3 (0001) substrates with Zn,ZnS,or Zn O buffers respectively,under different temperatures of beam source and of substrate. The buffer layer is necessary for preparation of ZnO thin film, in order to minimize the effect of mismatch of crystal lattice between substrates and ZnO. In the X ray diffraction spectrum, we can observe peaks specific to ZnO at (100), (002), (101), (102), and (103). There are some shifts of diffraction peaks for ZnO thin film at different substrates. The atomic force microscope images (AFM) show that the ZnO films are composed of small granules with nano size. The thickness of film was found about several nanometers, by using the grazing incidance X ray reflectivity method. Under the excitation of 360 nm, the photoluminescence of ZnO films is a broad spectrum with peaks at 410 and 510 nm. We suggest that the luminescence is due to deep levels related to the oxygen defects at the surface.
Keywords:ZnO  MBE  XRD  photoluminescence
本文献已被 CNKI 维普 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号