Influence of nozzle geometry on polystyrene degradation in convergent flow |
| |
Authors: | T Q Nguyen H -H Kausch |
| |
Institution: | (1) Present address: Polymer Laboratory, Department of Materials Science, Swiss Federal Institute of Technology, 32, Chemin de Bellerive, 1007 Lausanne, Switzerland |
| |
Abstract: | Polymer degradation is readily observed in flows where the extensional component surpasses the rotational component of the velocity gradient. This type of flow is conveniently obtained by pushing a liquid into a convergent channel across an orifice. Kinetics of chain scission is sensitive to subtle modification of the coil conformation, which in turn depends on the details of the pervading flow field. By changing the orifice diameter and the conical angle of the inlet, it is possible to modify the spatial distribution of the velocity gradient, and hence, the residence time of a fluid element in the high strain-rate region. Degradation yields, measured under -conditions in decalin by Gel Permeation Chromatography, showed a strong dependence on the fluid velocity at the orifice, but not on the magnitude of the strain-rate. This result is contrary to the common belief that assumes viscous friction, proportional to the strain-rate, is the determining factor for the scission rate of a bond under stress. Rather, experimental findings tend to indicate that the driving force for chain scission was provided by the energy accumulated in the coil during the flow-induced deformation process. The sharp propensity for mid-chain scission was maintained regardless of the nozzle geometry.Dedicated to Prof. W. R. Pechhold on the occasion of his 60th birthday |
| |
Keywords: | Convergentflow nozzlegeometry mechanochemicaldegradation polystyrene indecalin |
本文献已被 SpringerLink 等数据库收录! |
|