Concentration-dependent frequency shifts and Raman spectroscopic noncoincidence effect of the C=O stretching mode in dipolar mixtures of acetone/dimethyl sulfoxide. Experimental, theoretical, and simulation results

The nu(C=O) Raman band frequencies of acetone have been analyzed to separate the contributions of the environmental effect and the vibrational coupling to the gas-to-liquid frequency shifts of this band and to elucidate the changes in these two contributions upon dilution in DMSO. We have measured the frequencies of the nu((12)C=O) band in acetone/DMSO binary mixtures, the nu((13)C=O) band of the acetone-(13)C=O present as a natural abundance isotopic impurity in these mixtures, and both the nu((12)C=O) and nu((13)C=O) bands in the acetone-(12)C=O/acetone-(13)C=O isotopic mixtures at infinite dilution. These frequencies are compared with those of the nu((12)C=O) band in the acetone/CCl(4) binary mixtures measured previously. We have found the following three points: (i) The negative environmental contribution for the nu((12)C=O) oscillator of acetone completely surrounded by DMSO is reduced in magnitude by +5.5 cm(-1) and +7.8 cm(-1) upon the complete substitution of DMSO with acetone and CCl(4) molecules, respectively, indicating the progressive reduction of the attractive forces exerted by the environment on the nu((12)C=O) mode of acetone. (ii) In DMSO and other solvents, the contribution of the vibrational coupling to the frequency of the isotropic Raman nu((12)C=O) band of acetone becomes progressively more negative with increasing acetone concentration up to a value of -5.5 cm(-1), while the contribution to the frequency of the anisotropic Raman band remains approximately unchanged. The only difference resides in the curvatures of the concentration dependencies of these contributions which depend on the relative solute/solvent polarity. (iii) The noncoincidence effect (separation between the anisotropic and isotropic Raman band frequencies) of the nu(C=O) mode in the acetone/DMSO mixtures exhibits a downward (concave) curvature, in contrast to that in the acetone/CCl(4) mixtures, which shows an upward (convex) curvature. This result is supported by MD simulations and by theoretical predictions and is interpreted as arising from the reduction and enhancement of the short-range orientational order of acetone in the acetone/DMSO and acetone/CCl(4) mixtures, respectively.