Nano-structured lead dioxide as a novel stationary phase for solid-phase microextraction

The first study on the high efficiency of nano-structured lead dioxide as a new fiber for solid-phase microextraction (SPME) purposes has been reported. The size of the PbO2 particles was in the range of 34-136 nm. Lead dioxide-based fibers were prepared via electrochemical deposition on a platinum wire. The extraction properties of the fiber to benzene, toluene, ethylbenzene, and xylenes (BTEX) were examined using headspace solid-phase microextraction (HS-SPME) mode coupled to gas chromatography-flame ionization detection (GC-FID). The results obtained proved the suitability of proposed fibers for the sampling of organic compounds from water. The extraction procedure was optimized by selecting the appropriate extraction parameters, including preparation conditions of coating, salt concentration, time and temperature of adsorption and desorption and stirring rate. The calibration graphs were linear in a concentration range of 0.1-100 microg l(-1) (R2 > 0.994) with detection limits below 0.012 microg l(-1) level. Single fiber repeatability and fiber-to-fiber reproducibility were less than 10.0 and 12.5%, respectively. The PbO2 coating was proved to be very stable at relatively high temperatures (up to 300 degrees C) with a high extraction capacity and long lifespan (more than 50 times). Higher chemical resistance and lower cost are among the advantages of PbO2 fibers over commercially available SPME fibers. Good recoveries (81-108%) were obtained when environmental samples were analyzed.