Development and characterization of a variable turbulence generation system

Experimental turbulent combustion studies require systems that can simulate the turbulence intensities u′/U ₀ ~ 20–30% (Koutmos and McGuirk in Exp Fluids 7(5):344–354, 1989)] and operating conditions of real systems. Furthermore, it is important to have systems where turbulence intensity can be varied independently of mean flow velocity, as quantities such as turbulent flame speed and turbulent flame brush thickness exhibit complex and not yet fully understood dependencies upon both U ₀ and u′. Finally, high pressure operation in a highly pre-heated environment requires systems that can be sealed, withstand high gas temperatures, and have remotely variable turbulence intensity that does not require system shut down and disassembly. This paper describes the development and characterization of a variable turbulence generation system for turbulent combustion studies. The system is capable of a wide range of turbulence intensities (10–30%) and turbulent Reynolds numbers (140–2,200) over a range of flow velocities. An important aspect of this system is the ability to vary the turbulence intensity remotely, without changing the mean flow velocity. This system is similar to the turbulence generators described by Videto and Santavicca (Combust Sci Technol 76(1):159–164, 1991) and Coppola and Gomez (Exp Therm Fluid Sci 33(7):1037–1048, 2009), where variable blockage ratio slots are located upstream of a contoured nozzle. Vortical structures from the slots impinge on the walls of the contoured nozzle to produce fine-scale turbulence. The flow field was characterized for two nozzle diameters using three-component Laser Doppler velocimetry (LDV) and hotwire anemometry for mean flow velocities from 4 to 50 m/s. This paper describes the key design features of the system, as well as the variation of mean and RMS velocity, integral length scales, and spectra with nozzle diameter, flow velocity, and turbulence generator blockage ratio.