| Abstract: | Rotational viscosimeters are widely used to determine liquid viscosity. The technique for processing the experimental data is based fundamentally on the analytic solution of the problem of isothermal flow of a viscous liquid between two rotating cylinders.If in the course of the experiment the heat released due to the internal friction leads to significant heating, then the processing of the experimental results using the equations obtained on the assumption of isothermocity of the flow may lead to large errors. The dissipative heating may be reduced by reducing the angular velocity of rotation of the cylinder; however extensive reduction of the angular velocity is not desirable, since this leads to an increase of the measurement relative error. In addition, there is the possibility of conducting the experiments with a wide variation of the angular velocities in order to identify the structural-rheological peculiarities of the liquid. In the latter case we must be able to separate the purely thermal effects from the influence of the rheological factors. All these questions are discussed in detail in 1]. The authors of 1] obtained the solution of the problem of nonisothermal flow of a Newtonian fluid between two rotating cylinders and gave a technique for processing the experimental data which takes account of the dissipative heating of the fluid. The present paper pursues the same objective for a visco-plastic fluid.An attempt to solve the problem of nonisothermal flow of a viscoplastic fluid was made by Dzhafarov in 2], where the problem was solved in two versions. In the first version it was considered that the viscosity varies hyperbolically with the temperature and the gap between the cylinders is small in comparison with the radius of the inner cylinder. As a result of the linearization of the equations of motion and heat balance, it turned out that in fact the problem of Couette flow of a viscoplastic fluid was solved rather than the original problem. In this case, naturally, such a characteristic of the flow of a viscoplastic fluid in an annular gap as the possibility of the formation of an elastic zone was not covered. In the second version the problem was solved under the assumption that the viscosity is independent of the temperature and the angular velocity is small.In the present study the problem is solved without the limitations discussed above on the angular velocity, the fluid visoosity, and the gap between the cylinders. In this case we consider two types of temperature boundary conditions: a) constant temperatures are specified on the surfaces of the cylinders, which in the general case may be different; and b) a constant temperature is given on the surface of the outer cylinder and the inner cylinder is thermally insulated. |
