| Abstract: | Crosslinked samples of cis‐1,4‐polybutadiene (BR) were crystallized at low temperatures and then slowly melted. From volume changes and differential scanning calorimetry measurements, the degree of crystallization in the unstrained state was estimated to be about 20%, much lower than for natural rubber (NR). Crystallization and melting were followed in stretched samples by corresponding changes in tensile stress. Crystallization was faster at higher strains, and the melting temperature was raised significantly on stretching but less than for NR, and the decrease in stress on crystallizing was smaller. Measurements of tensile strength were made over a wide temperature range and showed a marked drop with heating to temperatures of 40–60 °C, falling to values of only 1–2 MPa. A similar drop in strength occurred in NR vulcanizates at high temperatures and was attributed to failure to crystallize on stretching (A. G. Thomas & J. M. Whittle, Rubber Chem Technol 1970, 43, 222; A. N. Gent, S. Kawahara & J. Zhao, Rubber Chem Technol 1998, 71, 668). At ambient temperatures, where strain‐induced crystallization occurred, the strength of BR samples was only about one‐half of that of similar NR materials. This was attributed to less strain‐induced crystallinity in BR (verified by X‐ray studies), paralleling the lower amount developed at low temperatures. We speculate that the higher density of molecular entanglements in BR than in NR prevents BR from crystallizing to the same degree as NR. © 2001 John Wiley & Sons, Inc. J Polym Sci B: Polym Phys 39: 811–817, 2001 |
