脉冲电场屏蔽效能测试系统及测试方法

 自主研制了一套小型脉冲电场屏蔽效能测试系统，该系统由脉冲电场发射设备和脉冲电场测试设备构成。脉冲电场发射设备的天线口面前60 cm处可产生峰值达7.5 kV/m的脉冲电场，测试设备的动态测试范围达97 dB。系统采用光纤测量设备，在测量工作中能有效抑制强电磁场干扰。采用Matlab编写自动测量及数据处理程序，实现了数据采集与处理自动化。实验测量了金属桥架、控制柜、屏蔽帐篷、导电水泥混凝土房的脉冲电场屏蔽效能，其脉冲电场峰值衰减量分别为52,64,66,30 dB。实验表明可用脉冲电场的峰值衰减量来评估屏蔽体的脉冲电场屏蔽效能。     

Negative luminescence from mid-wave infrared HgCdTe diode arrays

A self-referencing, optical modulation technique was used to measure the negative luminescence efficiencies of an array of mid-wave infrared HgCdTe photodiodes with cutoff wavelength 4.6 μm as a function of sample temperature. The internal efficiency at a wavelength of 4 μm was 93% at 295 K, and nearly independent of temperature in the 240–300 K range. This corresponds to an apparent temperature reduction >50 K at room temperature and >30 K at 240 K. Moreover, the reverse-bias saturation current density was only 0.13 A/cm². The measured transmission and emission spectra were simulated using empirical HgCdTe absorption formulas from the literature.     

激光陀螺磁灵敏度特性研究

分析、计算了激光陀螺的磁灵敏度特性，并进行了磁灵敏度试验.试验结果及分析表明：在腔体加工准确度不变的情况下，采用合理的设计可以大大降低激光陀螺在某些方向上的磁灵敏度，同时磁试验结果对于设计激光陀螺的磁屏蔽结构具有一定的实用价值.     

Experimental Evaluation of Strain Shielding in Distal Femur in Revision TKA

Theoretical concerns about the use of cemented and press-fit stems in revision total knee arthroplasty (TKA) include stress shielding with adverse effects on prosthesis fixation. Radiological studies have showed distal femoral bone resorption after revision TKA. The revision with use of stems can place abnormal stresses. These stresses can promote the effect of bone stress shielding and may contribute to bone loss. Experimental quantification of strain shielding in the distal synthetic femur following TKA is the main purpose of the present study. Three different constructs of TKA were assessed. The first construct included a stemless femoral component. The other two included a press-fit and a cemented femoral stem. Cortical bone strains were measured experimentally with tri-axial strain gauges in synthetic femurs before and after in-vitro knee surgery. The difference between principal strains of implanted and intact femur was calculated for each strain gauge position. This study indicates that the use of stems in distal femur changes the distribution and magnitude of bone strains. The press-fit stem provoked relevant bone area (stem length) subjected to strain shielding and also originated the highest reduction of strains in the distal region, which can potentially induce bone resorption. The stemless implanted femur produced minor bone strain changes relatively to the intact femur. The use of distal femur stems increases initial stability in the bone, but the observed reduction of strains in this region, relative to the intact femur, provokes strain shielding that can induce bone resorption and may compromise the long term implant stability.     

Studies on the Plasma Shielding of 1.06μm Laser on the Aluminum Target

ＳｔｕｄｉｅｓｏｎｔｈｅＰｌａｓｍａＳｈｉｅｌｄｉｎｇｏｆ１．０６μｍＬａｓｅｒｏｎｔｈｅＡｌｕｍｉｎｕｍＴａｒｇｅｔＬＵＪｉａｎ；ＮＩＸｉａｏｗｕ；ＨＥＡｎｚｈｉ（ＤｅｐａｒｔｍｅｎｔｏｆＡｐｐｌｉｅｄＰｈｙｓｉｃｓ，ＮａｎｊｉｎｇｏｆＳｃｉｅｎｃ...     

Manifestation of diamagnetic chemical shifts of proton NMR signals by an anisotropic shielding effect of nitrate anions

A remarkable upfield shift of the py_α protons of complexed 2,2′-bipyridine in [cis-Pd(bpy)(NO₃)₂] is observed which is considered to originate from the anisotropic influence of suitably positioned coordinated nitrate anions around the Pd(II) centre of the molecule. A typical complexation-induced downfield shift is observed for the NH₂ protons in [cis-Pd(en)(NO₃)₂] where ‘en’ stands for ethylenediamine.     

Ab initio study of the NMR shielding constants and spin-spin coupling constants in cyclopropene

Summary Ab initio calculations of parameters which characterize the NMR spectrum are presented for the cyclopropene molecule. The London orbitals CHF (or GIAO-CHF, Gauge-Independent Atomic Orbital Coupled Hartree-Fock) results for the shielding constants are in good agreement with the experimental data, accurately determined, and with otherab initio values. The calculations of the NMR spin-spin coupling constants have been performed using the Multiconfiguration Time-Dependent Hartree-Fock (MC TDHF) approach. Different basis sets and MC SCF wavefunctions were used to estimate the accuracy of the results. Good agreement is obtained with the coupling constants estimated using the available experimental data.Dedicated to Professor Werner Kutzelnigg on the occasion of his 60th birthday     

Electromagnetic interference shielding and radiation absorption in thin polypyrrole films

Results of permittivity measurements, electromagnetic interference shielding effectiveness, and heat generation due to microwave absorption in conducting polymer coated textiles are reported and discussed. The intrinsically conducting polymer, polypyrrole, doped with anthraquinone-2-sulfonic acid (AQSA) or para-toluene-2-sulfonic acid (pTSA) was applied on textile substrates and the resulting materials were investigated in the frequency range 1-18 GHz. The 0.54 mm thick conducting textile/polypyrrole composites absorbed up to 49.5% of the incident 30-35 W microwave radiation. A thermography station was used to monitor the temperature of these composites during the irradiation process, where absorption was confirmed via visible heat losses. Samples with lower conductivity showed larger temperature increases caused by microwave absorption compared to samples with higher conductivity. A sample with an average sheet resistivity of 150 Ω/sq. showed a maximum temperature increase of 5.27 °C, whilst a sample with a lower resistivity (105 Ω/sq.) rose by 3.85 °C.     

纳米镍-铁合金/膨胀石墨复合材料的制备、表征及其电磁屏蔽性能

The composites with nano-particles of Ni-Fe alloys dispersed on the nano-layers of expanded graphite (EG) were prepared by the impregnation of EG with ethanol solutions of nickel and iron acetates， followed by drying and reduction in H₂. The square nano-particles of Ni-Fe alloys with particle sizes of mainly 20～40 nm were found to be well spread on the layers of EG. The alloy nano-particles exhibited high shielding effectiveness (SE) for electromagnetic radiations at low frequencies due to their high magnetic conductivity. Since EG is electronically conductive and displayed high SE at high frequencies， the composites exhibited good SE at wide range of frequencies. The electric and magnetic conductivities of the composites could be monitored through regulating the loadings of alloy nano-particles on EG， and it was found that the composites with 20%～40% of the alloys exhibited good SE. Specifically， the composite 27%Ni-3%Fe-EG showed the excellent SE from 66 to 110 dB at the frequencies from 300 kHz to 1.5 GHz.