X射线荧光光谱法测定萤石中CaF2、CaCO3、S、Fe及SiO2

X射线荧光光谱法分析是目前快速分析方法之一,精密度受基体效应、均匀性、元素间干扰等影响。采用粉末压片法制备样品,用X射线荧光光谱法直接测定F、Ca元素,得出CaF_2及CaCO_3含量,并同时分析萤石中S、Fe、SiO_2的含量。精密度实验表明,待测元素的相对标准偏差均低于0.66%(RSD,n=10),能满足萤石中各元素的检测要求。     

A Review of Instrumental Approaches for Studying Historical Inks

In the last 10 years researchers have adapted a number of instrumental techniques for studying various aspects of historical inks that have been used in historical documents. In this paper, the applications of atomic spectroscopy such as GFAAS, ICP-MS, XRF, PIXE, and XANES are described for identifying and quantifying metals that are found in historical inks. Applications of vibrational spectroscopy, primarily Raman and near/mid-IR spectroscopy, are described for detecting organic and inorganic compounds in ink and paper.     

Green synthesis of bio-ethyl acetate over Egyptian natural red clay as a highly active,selective, and eco-friendly catalyst

The present work focused on the utilization of Egyptian red clay (ERC) without any treatment as a highly efficient, selective, and eco-friendly catalyst for synthesis of bio-ethyl acetate in the gas phase. The best conditions used in conventional fixed bed reactor were 130 cm³/min total flow rate of air with 1.6 and 2.1 vol% bio-ethanol and bio-acetic acid, respectively, 1 g clay catalyst calcined at 300 and 225°C reaction temperature. Under these conditions, the conversions to ester achieved were about 80 and 98% after 5 and 30 min, respectively, from the initial admission of the reactants into the reactor. The amount and type of surface acidity were identified by isopropanol reaction and chemisorption of basic probes. The results demonstrated that the majority of intermediate strength of BrØnsted acid sites are the key role for the dehydration reaction toward ester formation. The virgin and annealed clay solids were characterized using X-ray fluorescence (XRF), thermogravimetry (TG) and differential thermal analysis (DTA), Fourier transform infrared (FTIR), X-ray diffraction (XRD), and N₂ sorption.     

粉末压片-X射线荧光光谱法与红外吸收光谱法联合测定萤石中各组分

采用粉末直接压片法,用X-射线荧光光谱法[1]测得萤石中Ca总量,Fe2O3,P,SiO2,K2O的含量,再用红外吸收光谱法测得样品中碳含量,换算得到CaCO3中的钙含量,进一步求得萤石中CaF2含量。此方法简便、准确。用9个标准物质制定了工作曲线,并进行了自测,另用该系列中5号样品(GBW07254)进行准确度和精密度测试,结果令人满意。     

X-ray Peltier cooled detectors for X-ray fluorescence analysis

The recent results on development of X-ray Si(Li), Si-planar and CdTe p-i-n detectors cooled by Peltier coolers for fabrication of laboratory and portable XRF analysers for different applications are discussed.

Low detection limits of XRF analysers are provided by increasing of detectors sensitive surface; improvement of their spectrometrical characteristics; decreasing of front-end-electronics noise level; Peltier coolers and vacuum chambers cooling modes optimization.

Solution of all mentioned tasks allowed to develop Peltier cooled detectors with the following performances:

Full-size image

Advantages and disadvantages of all types of detectors for X-ray fluorescence analysis are compared. Spectra are presented. Application of different XRF analysers based on developed detectors in medicine, environmental science, industry, cryminalistics and history of art are demonstrated.     

三门峡虢季墓遗址盐害分析与调查

针对三门峡虢季墓遗址部分区域存在起甲、泛白、疱疹等由可溶盐引起的病害,在其遗址不同部位取样进行土遗址本体含盐分析.取样区域包括虢季墓、梁姬墓和近代墓遗址.采用X射线荧光光谱(XRF)和离子色谱(IC)分析所取样品的可溶盐成分、含量及可溶盐成盐元素在土遗址中的成盐规律.采用电子能谱(XPS)和X射线衍射(XRD)分析样品的物相组成及盐分状态,扫描电子显微镜/能谱(SEM/EDS)进一步考察含盐土质的颗粒组成、微观形貌等.结果表明:虢季墓取样区域所含盐分主要为Na_2SO_4、CaCO_3和少量的其他盐分如CaCl_2、KNO_3和NaCl等.靠近地面部位所取样品盐分含量高于其他部位,盐害表现更为明显.梁姬墓取样区域总盐分含量略高于虢季墓与近代墓,硝酸盐含量较高.而近代墓遗址可溶盐盐分含量略低,盐害不明显.在不同取样点可溶盐含量有所差异,但在邻近区域,其成盐具有一定规律性,这一点对于遗址基体中盐害的深入研究与防治具有重要意义.     

非金属矿二级标样配制及其粉末样品的XRF分析方法

针对X射线荧光光谱法(XRF)压片法分析中非金属矿标样不能满足实际工作需要的情况,以四川峨边五渡钾长石矿为例,研究了如何根据非金属矿一级标样配制系列二级标样,以及如何根据二级标样对非金属矿粉末样品进行XRF压片法分析的方法。在采用X射线衍射分析(XRD)和化学分析法研究钾长石矿和一级标样矿物岩石学特征基础上,根据二级标样与待测样品的矿物岩石学特征相同相似原理,确定了非金属矿二级标样配制的基本方法和要求,即二者的矿物种类相同、矿物含量和化学成分相似,并适应待测样品成分的波动及矿物加工的需要,有利于XRF标准工作曲线的绘制;采用实验确定的非金属矿XRF压片法制样条件以及根据二级标样绘制的标准工作曲线,对钾长石矿的SiO2,Al2O3,Fe2O3,TiO2,MgO,CaO,K2O,Na2O等化学成分进行了XRF测试分析,其结果与化学分析法一致,说明本方法准确度较好,能够基本消除矿物效应的影响。     

用于XRF分析的U-Nb合金试样制备方法

用X射线荧光光谱法(XRF)测量U-Nb合金样品时,其试样制备至关重要。本文用XRF测量U-Nb合金试样的制备方法:首先用HNO3+HF溶样,然后加入柠檬酸溶液,依次经过加热、除酸、络合、定容等过程,最后定量移取试液于滤纸片上,在红外灯下烤干,即制成试样片。该方法制备的U-Nb合金试样片具有平整、不变形、易于封装、可长期存放等特点。     

铜铟镓硒太阳能电池多层膜的结构分析

对于溅射后硒化和共蒸发等方法制备的铜铟镓硒（CIGS）太阳能电池薄膜,利用多种分析方法研究了CIGS多层膜的复杂结构等．研究表明：卢瑟福背散射（RBS）在分析CIGS多层膜方面具有其独特优势和可靠的结果;溅射后硒化方法制备的CIGS薄膜中,Ga和In在CIGS薄膜中呈梯度分布,这种Ga表层少而内层多的不均匀分布与Mo层没有必然关系;RBS和俄歇电子能谱分析（AES）均显示CIGS太阳能电池器件多层膜界面处存在扩散,尤其是CdS与CIGS,Mo与CIGS的界面处;X射线荧光（XRF）结果表明,电池效率最高的CIGS层中In,Ga比例为In：Ga=0．7：0.3;X射线衍射（XRD）结果显示：退火后的CIGS／Mo薄膜结晶品质得到了优化．