QEPAS系统中石英音叉模态仿真计算与研究

对石英音叉增强型光声光谱(QEPAS)系统中常用的石英音叉进行了有限元模态计算，获得石英音叉前6阶振型与模态频率，认知了第4阶对称摆动振型为有效振动，利用单因素法分析了石英音叉的音臂长度l₁、音臂宽度w₁、音臂厚度t、音臂切角θ、音臂圆孔直径d及音臂圆孔高度h对低阶有效共振频率(Fre)的影响，敏感度依次为： l₁> w₁>d>θ>t>h，考虑实际设计情形，筛选出了l₁，w₁，d与h四个石英音叉设计变量，采用Box-Behnken实验设计方案与RSM(response surface methodology)方法，以Fre为函数目标，建立l₁，w₁，d与h的二次回归响应面模型，得到了参数之间的交互作用，利用Design-Expert软件对响应面模型进行设计参数反求，结果表明，在15 000 Hz≤Fre≤25 000 Hz计算区域内误差较小，基本满足QEPAS系统的计算需求，所提出的研究与设计方法具有一定通用性，可为QEPAS系统中石英音叉结构参数设计提供参考。     

滤片-XRD探测系统响应时间测量

 研究了软X射线能谱仪探测道系统(系统包括X射线二极管（XRD）、SUJ-50-10电缆和不同频带示波器)的响应时间。实验利用上海激光联合实验室的20TW激光器激光(激光能量约20J，脉冲宽度约1ps)打金箔靶产生的X光，用XRD探测系统测量，记录示波器有TK684C，TK694C和WM8500等。将实验数据进行了线性拟合和比对分析。滤片XRD探测系统的响应时间随偏压升高而加快，随传输电缆长度的增加而变慢，因此测量快信号过程时，应提高探测器偏压，缩短传输电缆，选择宽频带高采样率示波器，以便减少系统的响应时间，减小信号失真程度。     

惯性约束中子测温的误差研究

综合分析了ＩＣＦ（惯性约束）中子测温系统的误差与其参数的关系，这些参数包括靶核温度，探测的中子数、靶到探测器的距离、探测器的响应函数以及闪烁体厚度等，考虑到中子与探测器的相互作用，探测器的响应与靶的烧蚀过程，在此基础上提出了新的统计误差计算方法，该方法对于改善中子测温的相对误差并应用于闪烁体的设计具有重要意义。     

Approximate and Exact Small Signal Analysis for Single-Mode Fiber Near Zero Dispersion Wavelength with Higher Order Dispersion

This article presents the comparison of approximate and exact small-signal theories for analyzing the influence of the higher-order dispersion terms on dispersive optical communication systems operating near zero dispersion wavelength for linear single-mode fiber. For the approximate theory, the generalized conversion matrix has been reported and gives the transfer function of intensity and phase from the fiber input to fiber output for a laser source including the influence of any higher-order dispersion term. In addition, expressions for the small-signal frequency response and the relative intensity noise (RIN) response of an ultrafast laser diode including noises are derived. However, it is observed that the approximation assumed for the second-order dispersion term for the approximate analysis is not valid. From the approximate theory, the exact generalized conversion matrix and exact expressions for small-signal frequency response and relative intensity noise (RIN) are obtained. We show that for the exact theory, the second-order dispersion term has no effect on intensity and frequency response even at large modulating frequencies and large propagation distances contrary to the approximate theory as reported by other authors. But we show that third-order dispersion term certainly has some minute impact on the frequency and RIN response for long distance links at high modulating frequencies.     

Studies on recoil proton tracks in NTA films with the T(d,n)He reaction

Recoil proton tracks in nuclear emulsion are counted by scanning them using strip, square or circular field of view of optical microscope. In this paper, the overestimate due to the edge effects in counting recoil proton tracks at different neutron energies produced from the T(d,n)⁴He reaction has been determined by measuring the true track density in NTA film. The overestimate has also been calculated using the measured value of the mean projected track length (L) in the film. The percentage of measured overestimates has been compared with those obtained by calculation and the results agree reasonably well. Fading effect in NTA film has been studied and found to be 22% more in the summer than in the winter season. A great reduction in fading rate could be achieved if the films are desiccated and sealed in highly pure dry nitrogen maintained at an over-pressure of 1000 Pa to reduce water vapour ingress. After the edge effect correction, the sensitivity of NTA film has been calculated from (1.72±0.08)×10⁻³ tracksn⁻¹ to (1.97±0.16)×10⁻³ tracksn⁻¹ in the neutron energy ranges from 15.91 to 18.88 MeV. The response was found to be from 0.24±0.02 trackscm⁻² permSv to 0.26±0.01 trackscm⁻² permSv in the same energy range.     

Optimization of the process variables for the synthesis of cardanol-based novolac-type phenolic resin using response surface methodology

Models capable of predicting the maximum extent of conversion (p) of cardanol-based novolac-type phenolic resin, have been developed using response surface methodology to determine the optimum reaction conditions. Three-dimensional response surface and their contour plot were drawn. The maximum extent of conversion (98.93%) was predicted when the cardanol was condensed with formaldehyde (molar ratio 1:0.652) at 119.84 °C for a time period of 3 h with the catalyst (e.g., citric acid) concentration of 1.988% of total volume of cardanol and formaldehyde. The pH of the reaction mixture was maintained at 3.0. These predicted values for optimum process conditions were in good agreement with experimental data.     

Crystal Structure,Electrochemical Properties and Third-order Nonlinear Optical Response of 4-Methyloxy benzaldehyde Thiosemicarbazone and Its Copper(Ⅱ)Complex

Thecurrentsurgeofinterestinthefield0fnon-linearoptics(NL0)isderivedbothfromaquestforafundamentalunderstanding0fthenon-linearprocess,anditSimPortanceinthetechn0logyofphotonics.Amongnon-linearphen0mena,thethird-ordernon-linearophcsoccuPyanimPortantp0sihonbecauseitprovidesthemechanicsforophcalswitching,ophcallogic,andreal-hmeholograPhy"'.0rganicmaterialwithextendednconjugahonsandlargeRdelocalizahonsarewellknownastheimPortantmaterialsofachievinglargethird-ordernonlinearihes3.ForexamPle,thiosen…     

The optimization of silica gel synthesis from chemical bottle waste using response surface methodology

To reduce the amount of hazardous chemical bottle waste in the environment, we report the optimization research of silica extraction in chemical bottle waste into silica gel. Alkali fusion and sol–gel process were utilised to prepare silica gel effectively. The alkali fusion process was carried out by adding sodium hydroxide to produce sodium silicate. Afterwards, silica gel was prepared by the sol–gel method using hydrochloric acid. Box-Behnken Design (BBD) was applied to Optimisation factors the poptimiseactors affecting the silica recovery. The factors that optimised mass ratio, particle size, and temperature. The optimum recovery of silica gel was obtained by SiO₂: NaOH mass ratio of 1:3, the particle size of 63–74 µm, and a temperature of 800 °C. The purity of silica gel optimum is 63.74% characterised using X-ray fluorescence. The structure of silica gel is the appearance of amorphous peaks at 2θ 20-30° characterised using an x-ray diffractogram. The silica gel surface was characterises using scanning electron microscopy-energy dispersive x-ray. It showed an irregular surface and characteristic showed that silica gel had a radius of 15.74 nm and a specific surface area of 297.08 m².     

The extraction,antioxidant and against β-amyloid induced toxicity of polyphenols from Alsophila spinulosa leaves

Alsophila spinulosa is a tree-like fern, and many evidences suggested that plant polyphenols had the potential therapeutic for Alzheimer s disease (AD). Herein, polyphenols (ASP) was isolated from A. spinulosa leaves and its major constituent were isoorientin and vitexin. ASP displayed excellent antioxidant activity and obvious anti-lipid peroxidation capacity in vitro. ASP improved the survival rate of C. elegans under high temperature by enhancing the antioxidant enzymes activities and decreasing the lipid peroxidation level. Moreover, ASP alleviated β-amyloid (Aβ) induced paralysis and reduced Aβ deposition, decreased reactive oxygen species (ROS) accumulation and improved the level of skn-1 mRNA. In addition, ASP decreased the levels of pdk-1 and akt-1 mRNA in P13K/AKT signaling pathway. In conclusion, ASP may be a potential ingredient for the alleviation of AD.