Averaging scheme for atomic resolution off-axis electron holograms

All micrographs are limited by shot-noise, which is intrinsic to the detection process of electrons. For beam insensitive specimen this limitation can in principle easily be circumvented by prolonged exposure times. However, in the high-resolution regime several instrumental instabilities limit the applicable exposure time. Particularly in the case of off-axis holography the holograms are highly sensitive to the position and voltage of the electron-optical biprism. We present a novel reconstruction algorithm to average series of off-axis holograms while compensating for specimen drift, biprism drift, drift of biprism voltage, and drift of defocus, which all might cause problematic changes from exposure to exposure. We show an application of the algorithm utilizing also the possibilities of double biprism holography, which results in a high quality exit-wave reconstruction with 75 pm resolution at a very high signal-to-noise ratio.     

Accurate mass determination,quantification and determination of detection limits in liquid chromatography–high-resolution time-of-flight mass spectrometry: Challenges and practical solutions

Uniform guidelines for the data processing and validation of qualitative and quantitative multi-residue analysis using full-spectrum high-resolution mass spectrometry are scarce.     

High-resolution laser ablation-inductively coupled plasma-mass spectrometry imaging of cisplatin-induced nephrotoxic side effects

Two-dimensional elemental mapping (bioimaging) via laser ablation-inductively coupled plasma-mass spectrometry (LA-ICP-MS) was performed on 5 μm thick formalin-fixed, paraffin-embedded kidney tissue sections from Cynomolgus monkeys administered with increasing pharmacological doses of cisplatin. Laterally resolved pixels of 1 μm were achieved, enabling elemental analysis on a (sub-)cellular level. Zones of high Pt response were observed in the renal cortex, where proximal tubules are present, the epithelium of which is responsible for partial reabsorption of cisplatin. Histopathological evaluation, of hematoxylin and eosin-stained serial sections, adjacent to the sections probed via LA-ICP-MS, revealed minimal to mild cisplatin-related lesions (<100 μm) in the renal cortex. Necrotic proximal tubules with sloughed epithelial cells in their lumen could be linked directly to the areas with the highest accumulation of cisplatin, indicating a direct link between cellular concentration and toxicity, thereby providing more insight into the mechanisms through which renal damage occurs.     

15N216O在1650-3450 cm-1的高分辨红外光谱

采用傅里叶变换红外光谱仪记录了富含¹⁵N₂¹⁶O同位素的一氧化二氮样品在1650-3450 cm^-1波段的高分辨振转光谱,得到了该同位素分子超过7300吸收谱线位置的实验值,经分析实验精确度好于5.0×10^-4 cm^-1. 基于有效哈密顿量模型预测和带带转动分析,确定了所有吸收线的归属;获得了29个新吸收带的振转光谱参数,并优化了其他44个吸收带的光谱参数值. 并且发现有效哈     

Studies on the growth and characterization of tris (glycine) calcium(ΙΙ) dichloride—a nonlinear optical crystal

A systematic characterization of a novel nonlinear optical material tris (glycine) calcium(ΙΙ) dichloride (TGCC) is performed. The solubility and metastable zone width of TGCC were studied. TGCC single crystal of dimensions 34×23×5 mm³ was grown by the slow evaporation technique. Single crystal X-ray diffraction studies reveal that the crystal belongs to orthorhombic system. Energy dispersive X-ray analysis confirms the presence of elements in the crystal. Structural perfection of the as-grown single crystal was studied through multicrystal X-ray diffraction analysis. The thermal characteristics of TGCC were analyzed by thermogravimetric and differential thermal analysis and differential scanning calorimetry. The transmittance of TGCC crystal has been used to calculate the optical band gap of the crystal. Chemical etching studies of TGCC crystal was carried out. The dielectric and mechanical behavior of the crystals were analyzed. The second harmonic conversion property of TGCC was identified by the Kurtz and Perry powder technique and was observed to be higher than that of KDP.     

The ν12 band of C2D4

The Fourier transform infrared (FTIR) absorption spectrum of the ν₁₂ fundamental band of ethylene-d₄ (C₂D₄) was recorded in the 1017-1137 cm⁻¹ region with an unapodized resolution of 0.0063 cm⁻¹. Upper state (v₁₂ = 1) rovibrational constants consisting of three rotational and five quartic constants were improved by assigning and fitting 2103 infrared transitions using Watson’s A-reduced Hamiltonian in the I^r representation. The band centre of the A-type ν₁₂ band is found to be 1076.98480 ± 0.00002 cm⁻¹. The present analysis covering a wider wavenumber range and higher J and K_c values yielded upper state constants including the band centre which are more accurate than previously reported. The rms deviation of the upper state fit is 0.00045 cm⁻¹. Improved ground state rovibrational constants were also determined from the fit of 1247 ground state combination differences (GSCD) from the presently-assigned infrared transitions of the ν₁₂ band of C₂D₄. The rms deviation of the GSCD fit is 0.00049 cm⁻¹. In the rovibrational analysis, local frequency perturbations were not detected even at high J and K_a values. The calculated inertial defect Δ₁₂ is 0.32551 ± 0.00001 μŲ. The line intensities of the individual transitions in the ν₁₂ band were measured and the band strength of 39.8 ± 2.0 cm⁻² atm⁻¹ was derived for the ν₁₂ band of C₂D₄.     

High-resolution infrared spectrum of cyanogen

The high-resolution spectrum of cyanogen (¹⁴N¹²C¹²C¹⁴N) has been measured from 500 to 4900 cm⁻¹. For this isotopomer many combination levels with both degenerate fundamentals, ν₄ and ν₅, have been measured for the first time and the effects of vibrational l-type resonance are observed as well as rotational l-type resonance. The effects of the vibrational resonance coupling ν₂ and 2ν₄ have also been studied. The data have been combined with earlier measurements below 500 cm⁻¹ to give a comprehensive catalog of the vibrational energy levels and the rovibrational constants for the normal isotopomer of cyanogen. A comparison of the term value constants for the three major symmetric isotopomers is given and they are compared with a recent ab initio calculation. The present data were combined with earlier work on the two symmetric isotopomers, ¹³C₂¹⁴N₂ and ¹²C₂¹⁵N₂, to obtain the equilibrium bond lengths, r_CC = 138.109(60) pm and r_CN = 115.976(40) pm.     

Fast sequential multi-element determination of Ca,Mg, K,Cu, Fe,Mn and Zn for foliar diagnosis using high-resolution continuum source flame atomic absorption spectrometry: Feasibility of secondary lines,side pixel registration and least-squares background correction

The fast sequential multi-element determination of Ca, Mg, K, Cu, Fe, Mn and Zn in plant tissues by high-resolution continuum source flame atomic absorption spectrometry is proposed. For this, the main lines for Cu (324.754 nm), Fe (248.327 nm), Mn (279.482 nm) and Zn (213.857 nm) were selected, and the secondary lines for Ca (239.856 nm), Mg (202.582 nm) and K (404.414 nm) were evaluated. The side pixel registration approach was studied to reduce sensitivity and extend the linear working range for Mg by measuring at wings (202.576 nm; 202.577 nm; 202.578 nm; 202.580 nm; 202.585 nm; 202.586 nm; 202.587 nm; 202.588 nm) of the secondary line. The interference caused by NO bands on Zn at 213.857 nm was removed using the least-squares background correction. Using the main lines for Cu, Fe, Mn and Zn, secondary lines for Ca and K, and line wing at 202.588 nm for Mg, and 5 mL min^− 1 sample flow-rate, calibration curves in the 0.1–0.5 mg L^− 1 Cu, 0.5–4.0 mg L^− 1 Fe, 0.5–4.0 mg L^− 1 Mn, 0.2–1.0 mg L^− 1 Zn, 10.0–100.0 mg L^− 1 Ca, 5.0–40.0 mg L^− 1 Mg and 50.0–250.0 mg L^− 1 K ranges were consistently obtained. Accuracy and precision were evaluated after analysis of five plant standard reference materials. Results were in agreement at a 95% confidence level (paired t-test) with certified values. The proposed method was applied to digests of sugar-cane leaves and results were close to those obtained by line-source flame atomic absorption spectrometry. Recoveries of Ca, Mg, K, Cu, Fe, Mn and Zn in the 89–103%, 84–107%, 87–103%, 85–105%, 92–106%, 91–114%, 96–114% intervals, respectively, were obtained. The limits of detection were 0.6 mg L^− 1 Ca, 0.4 mg L^− 1 Mg, 0.4 mg L^− 1 K, 7.7 µg L^− 1 Cu, 7.7 µg L^− 1 Fe, 1.5 µg L^− 1 Mn and 5.9 µg L^− 1 Zn.     

Direct determination of Hg in polymers by solid sampling-graphite furnace atomic absorption spectrometry : A comparison of the performance of line source and continuum source instrumentation

This work explores the potential of solid sampling-graphite furnace atomic absorption spectrometry (SS-GFAAS) for the fast and direct determination of Hg in polymers. Eight certified reference materials with different composition (polyethylene-PE-, polystyrene-PS-, poly vinyl chloride-PVC- and acrylonitrile butadiene styrene-ABS-) were selected for the study, covering a wide Hg content range (from 20 to 1100 μg g^− 1).     

The Coding Complexity of Lévy Processes

We introduce a new coding scheme for general real-valued Lévy processes and control its performance with respect to L _p [0,1]-norm distortion under different complexity constraints. We also establish lower bounds that prove the optimality of our coding scheme in many cases.