激光二极管诱导荧光高灵敏检测亚甲基蓝

建立了水中微量亚甲基蓝的高灵敏激光诱导荧光检测方法。利用638 nm/100 mW激光二极管产生激光,激发亚甲基蓝使之产生最大波长为662 nm的荧光,该荧光强度与亚甲基蓝含量成线性关系,亚甲基蓝在1～180μg/L浓度范围内线性关系良好(R~2=0.9998),荧光强度在60 min内基本稳定。使用组装的激光诱导荧光检测系统对亚甲基蓝试样进行测试,结果良好。该法对水样品中痕量亚甲基蓝的测定具有应用价值。     

组分阶梯InGaN势垒对绿光激光二极管光电性能的影响

为探究不同铟(In)组分In_xGa_1-xN势垒对绿光激光二极管光电性能的影响，本文采用SiLENSe(simulator of light emitters based on nitride semiconductors)仿真软件对一系列具有不同In组分In_xGa_1-xN势垒的激光二极管进行研究，结果发现In_xGa_1-xN势垒中In组分最佳值为3%,此时结构的斜率效率最高，内部光学损耗最低，光学限制因子最大，性能最优。在具有In_0.03Ga_0.97N势垒的多量子阱结构基础上，设计了一种组分阶梯(composition step-graded, CSG)InGaN势垒多量子阱结构，提高了激光二极管的斜率效率和电光转换效率，增加了光场限制能力。仿真结果表明，当注入电流为120 mA时，具有CSG InGaN势垒的多量子阱结构，电光转换效率从17.7%提高至19.9%,斜率效率从1.09 mW/mA增加到1.14 mW...     

激光二极管抽运氦气冷却钕玻璃叠片激光放大器热致波前畸变和应力双折射的数值模拟和实验研究

热效应仍是限制激光放大器向高功率、高光束质量进一步发展的瓶颈问题, 高效的热管理是抑制热效应的重要技术途径. 研究了基于激光二极管抽运氦气冷却的钕玻璃叠片激光放大器的热效应. 利用有限元数值模拟的方法, 分析了钕玻璃的温度、应力应变和应力双折射分布, 并计算了热致波前畸变和退偏损耗, 与实验结果符合得较好, 在热沉积为0.7 W/cm³的条件下, 6片钕玻璃总的热致波前畸变为6.77λ , 最大退偏量大于90%.     

基于微蒸发腔制冷的大功率激光二极管制冷组件

利用节流的高压冷却介质在微蒸发腔内相变吸热,设计了一种用于大功率激光二极管制冷的封装组件。该组件采用高热导的无氧铜,用精密线切割、化学腐蚀等技术制作微蒸发腔,再通过自制的焊接设备完成制冷组件的封装。按照大功率激光二极管条的发热模型,理论上对微蒸发腔制冷组件的温度分布进行了数值模拟,结果与60 W激光二极管条的散热实验符合较好,得到制冷剂流量为23 m L/min时的热阻为0.289℃/W。     

Study of diode-pumped Yb:YAG disk lasers at low temperature

A Yb:YAG disk laser with V-shaped stable resonator and active-mirror configuration,end-pumped by a 940-nm InGaAs laser diode array,is demonstrated.Performances and optimization of the disk laser at low temperature over a range of 130-200 K are investigated theoretically and experimentally.Laser output energy of 1.46 J/pulse operating at 10-Hz repetition rate is obtained with the optimum output coupler transmission of 30%,and the corresponding optical-to-optical efficiency is 48.7%.     

High-power diode-end-pumped Tm：YAP and Tm：YLF slab lasers

Diode-end-pumped continuous-wave(CW) Tm:YAP and Tm:YLF slab lasers are demonstrated. The a-cut Tm:YAP and Tm:YLF slabs with doping concentrations of 4 at.-% and 3.5 at.-%,respectively,are pumped by fast-axis collimated laser diodes at room temperature. The maximum CW output powers of 72 and 50.2 W are obtained from Tm:YAP and Tm:YLF,respectively,while the pump power is 220 W,corresponding to the slope efficiencies of 37.9% and 26.6%,respectively.     

High packing density laser diode stack arrays using Al-free active region laser bars with a broad waveguide and discrete copper microchannel-cooled heatsinks

A high packing density laser diode stack array is developed utilizing Al-free active region laser bars with a broad waveguide and discrete copper microchannel-cooled heatsinks. The microchannel cooling technology leads to a 10-bar laser diode stack array having the thermal resistance of 0.199 ℃/W, and enables the device to be operated under continuous-wave （CW） condition at an output power of 1200 W. The thickness of the discrete copper heatsink is only 1.5 mm, which results in a high packing density and a small bar pitch of 1.8 mm.     

激光二极管抽运的高重频高平均功率Nd:YAG激光器

搭建了一台高重复频率、高峰值功率、高平均功率的激光器. 激光器主要包括三部分: 单纵模光纤种子源、激光二极管阵列抽运的Nd:YAG再生放大器和四程放大器. 系统获得了平均功率11 W、重复频率100 Hz、脉冲能量112 mJ、脉宽500 ps–2 ns可调的激光输出, 工作波长1064 nm. 输出光束口径6.8 mm, 1.5倍衍射极限, 近场光强近平顶分布, 能量稳定性为0.72%. 关键词： 激光二极管抽运 高重复频率 高峰值功率 高平均功率     

High-Power Nd：GdVO4 Innoslab Continuous-Wave Laser under Direct 880 nm Pumping

A high-power cw end-pumped laser device is demonstrated with a slab crystal of Nd：GdVO4 operating at 1063nm. Diode laser stacks at 880nm are used to pump Nd：GdVO4 into emitting level 4^F3/2. The 149 W output power is presented when the absorbed pump power is 390 W and the optical-to-optieal conversion efficiency is 38.2%. When the output power is 120 W, the M^2 factors are 2.3 in both directions. Additionally, mode overlap inside the resonator is analyzed to explain the beam quality deterioration.     

基于光电技术的速度测量方法

根据光电鼠标成像定位原理,用红外激光二极管和光电鼠标导航芯片测量物体位移,用单片机定时器测量时间,计算得到物体运动的瞬时速率.该方法实现了对运动的物体进行非接触式测量,并可以获得物体的速度曲线和加速度曲线.