膨润土对结晶紫的吸附

用分光光度、显微电泳和ｘ－射线衍射等方法研究了膨润土对结晶紫的吸附；实验表明，钙型膨润土在吸收结晶紫溶液时，加入钠盐可明显改善吸附效果。     

膨润土对亚甲基蓝的吸附性能研究

为将膨润土作为消化道粘膜保护剂提供依据，本文研究了钠质，钙质膨润土对亚甲基蓝的吸附性能。研究了在20℃下的吸附动力学，测试了肿附速率常数，绘制了20℃下各型膨润土的吸附等温线，并求得其饱和吸附量。结果表明，20℃时钠质膨润土的吸附速率要快于钙质膨润,各型膨润土的吸附行为符合Langmuir方程，钠质膨润土的饱和吸附量qm为86．51mg/g，与粘膜保护剂思密达比较接近，而钙质膨润土吸附能力相对较弱。     

负载稀土型酸活化膨润土的酯化催化活性

负载稀土型酸活化膨润土的酯化催化活性李永绣，冯天泽，胡平贵，何小彬，辜子英，廖荣辉（南昌大学化学系南昌３３００４７）关键词稀土，膨润土，催化酯化可用稀土、膨润土单独作酯化催化剂，但活性不高［１～３］。本文将稀土用离子交换的方法负载到酸活化膨润土中，寻...     

Preparation and swelling properties of hydrolysis-resistant superabsorbent composite based on acrylic acid and sodium bentonite

Abstract

A novel hydrolysis-resistant superabsorbent composite was prepared via the solution polymerization based on acrylic acid (AA) and sodium bentonite (SBT) as monomers, tetraallylammonium bromine (TAAB) as crosslinker and ammonium persulfate (APS) as initiator. The mechanism of polymerization and the structure of the superabsorbent polymer (SAP) were studied by Fourier transform infrared spectroscopy (FTIR), X-ray diffraction (X-ray), and scanning electron microscopy (SEM). The reaction conditions such as different mass ratios of APS to AA, TAAB to AA, SBT to AA, neutralization degree of AA were optimized by orthogonal experiment, and the influence of each reaction condition on the capacity of water absorption at 150?°C was investigated via single-factor controlled experiment. The hydrolysis resistance and swelling kinetics of the SAP were studied in different solutions at 150?°C. Compared to traditional SAPs, the SAP synthesized with TAAB as crosslinker performed a more excellent hydrolysis resistance and water absorbency capacity at high temperatures. The water absorbency in distilled water or 0.1?mol L^?1 NaCl solution could reach 392.6 and 145.2?g g^?1at 150?°C, respectively. The SAP maintaining high swelling capacity in the pH range of 5–9 indicated its wide application values in the acidic or alkaline environment at high temperature. In addition, the SAP exhibited good reusability which could still retain about 73% of its initial water absorbency after reswelling six times at 150?°C.     

Investigations for Modification of Polyacrylamide-Bentonite by Phytic Acid and its Usability in Fe3+, Zn2+ and UO2 2+ Adsorption

Composite of polyacrylamide-bentonite (PAA-B) was prepared by direct polymerisation of PAA in a suspension of bentonite (B). Adsorption and thermodynamic features of phytic acid (Phy) adsorption onto B, PAA and PAA-B, and those of Fe³⁺, Zn²⁺, UO₂ ²⁺ adsorption onto PAA-B and its modification by Phy (PAA-B-Phy) have been investigated. The reusability, storagability, ion selectivity and recoverability of sorbed ions with 1 M HCl have also been considered.The chemical and physical structure of adsorbents has been characterised by means of FT-IR and XRD. All adsorption isotherms for Phy and the ions were L-type of the Giles classification except, the one which is S type for adsorption of Phy onto PAA. The maximum adsorption capacities for the ions adsorbed were in order of UO₂ ²⁺ > Fe³⁺ > Zn²⁺ for PAA-B and Zn²⁺ > Fe³⁺ > UO₂ ²⁺ for PAA-B-Phy. Langmuir equilibrium constants for the adsorption of ions onto PAA-B-Phy were significantly higher than those found for PAA-B; the magnitude of increase for UO₂ ²⁺ was about 100. The thermodynamic parameters indicated that adsorption reactions are spontaneous in terms of adsorption free enthalpy.The chemical structure of PAA-B-Phy was not changed at the end of the studies of reusability and storagability. The composite was selective for UO₂ ²⁺ of the ions of interest.The composite of PAA-B and its modification by Phy have been used for the first time in this investigation. It is proposed that the composites can be practically used in the investigations and applications of adsorption.     

Magnetically modified bentonite as a possible contrast agent in MRI of gastrointestinal tract

A composite of iron oxide nanoparticles and mineral matrix has been studied by XRD, Mössbauer spectroscopy, and TEM. Magnetite and superparamagnetic magnetite have been identified by Mössbauer spectroscopy in the nanocomposite. A relationship between the hyperfine parameters and iron oxide particle size has been confirmed by TEM. The optimal concentration of “magnetite—bentonite” composite, when the MRI signal is fully reduced, was found for using this composite as a negative contrast agent.     

A vibrational spectroscopic study of the adsorption of 4,4′-bipyridyl by sepiolite and smectite group clay minerals from Anatolia (Turkey)

The adsorption of 4,4-bipyridyl by natural sepiolite and smectite group clay minerals (bentonite, hectorite and saponite) from Anatolia (Turkey) has been studied using vibrational spectroscopy. Investigation of Fourier-transform infrared and Fourier-transform Raman spectra of adsorbed 4,4-bipyridyl indicate the presence of chemisorbed species. However, any evidence for the generation of anionic species on the surface of the phyllosilicates has not been detected. It is proposed that the adsorbed bipyridyl molecules on sepiolite are centrosymmetric and H-bonded to the surface hydroxyls through both the nitrogen lone pairs as bidentate ligands. The adsorbed bipyridyl molecules on the smectite group clays are coordinated to exchangeable cations both directly and also indirectly through water as monodentate ligands. XRD patterns of the clays studied are also recorded.     

Clays as selective catalysts in organic synthesis

Suitably modified smectite clays can be very selective catalysts for a wide range of organic reactions. While it has long been known that such materials can act as Bronsted and Lewis acids, it has been shown recently that they are also effective Diels-Alder catalysts. A selection of illustrative reactions is given which emphasises their wide range of use, their selectivity, and the ease of work-up after reaction. In each case, mechanistic information is presented, e.g., on the site of reaction (whether interlayer or surface), rate determining steps, etc. The regiochemical consequences of the restricted reaction space are stressed.Based on material presented at the Fourth International Symposium on Inclusion Phenomena and the Third International Symposium on Cyclodextrins, Lancaster, U.K., 20–25 July 1986.     

Thermodynamic and Kinetic Studies for the Adsorption of Fe(III) and Ni(II) Ions From Aqueous Solution Using Natural Bentonite

In this study, the adsorption behavior of natural bentonite with respect to Fe(III) and Ni(II) has been studied in order to consider its application to purity metal finishing wastewaters. During the adsorption process, batch technique is used, and the effects of pH, bentoite amount, temperature, heavy metal concentration, bentonite treatment (calcinations of natural bentonite at 700°C, washing by deionized water to remove the excess salt from bentonite surface), and agitation time on adsorption efficiency are studied. The washed and calcined bentonite samples were labeled by WB and CB, respectively. The pH-dependence of Fe(III) and Ni(II) sorption on the bentonite is significantly more noticeable, indicating a major contribution of surface complexation at the edge sites. It was determined that adsorption of Fe(III) and Ni(II) is well fitted by the second order reaction kinetic. Furthermore, the sorption rate of Fe(III) was higher than the sorption rate of Ni(II). Adsorption of Fe(III) and Ni(II) on NB appeared to follow Langmuir isotherm. In addition, calculated and experimental adsorbed amounts of Fe(III) by the unit NB mass are very higher than Ni(II). The paper also discusses the thermodynamic parameters of the adsorption (the Gibbs free energy, entropy, and enthalpy). Our results demonstrate that the adsorption process was spontaneous and endothermic under natural conditions. Also the adsorption capacity of bentonite for Fe(III) Ni(II) and increases with increased bentonite dose. According to the equilibrium studies, the selectivity sequence can be given as Fe(III) > Ni(II). The adsorbed amount of Fe(III) and Ni(II) on washed bentonite (WB) were very higher compared to NB and CB. Our results show that bentonite could especially WB be considered as a potential adsorbent for Fe(III) and Ni(II) removal from aqueous solutions.     

The synthesis of MCM-41 nanomaterial from Algerian Bentonite: The effect of the mineral phase contents of clay on the structure properties of MCM-41

This study focuses on the MCM-41 material (Mobil Composition of Matter). The MCM-41 nanomaterial presents higher physical properties such as pore sizes, surface areas and pore volumes. This material is usually synthesized by using laboratory reagents as silicate sources and aluminium source. These laboratory reagents are still expensive and toxic for large scale production. The main aim of this work is to resolve this problem and to replace these expensive laboratory reagents by more cost effective ones. The volclay and Algerian bentonite low-cost mass clay materials are used as silicate and acuminate sources separately by adopting an alkaline fusion process to extract both silicon and aluminium (1 kg of silicium and aluminium from volclay and Algerian bentonite cost around 0.03 and 0.01 € whereas the same amount of silicon from ludox and aluminium from sodium aluminates cost around 350 €). The synthesis of MCM-41 from bentonite was carried out by the hydrothermal method using the supernatants of bentonite (in the form of sodium silicate and sodium aluminate). On the basis of the data obtained from powder X-ray diffraction (XRD), transmission electron microscopy (TEM) and N₂ adsorption and desorption, the results revealed that the properties of MCM-41 synthesized from Algerian bentonite and volclay separately depend on both elemental composition and mineral phase contents of the used bentonite. Pure and highly ordered hexagonal mesoporous MCM-41 with uniform pore sizes and a high specific surface area have been successfully synthesized without any phases which exist in natural bentonite. The Algerian bentonite was chosen because of its low cost compared to volclay, another commercial clay source.