Orientation dependent size effects in thermal buckling and post-buckling of nanoplates with cubic anisotropy

In this work, a continuum model is presented for size and orientation dependent thermal buckling and post-buckling of anisotropic nanoplates considering surface and bulk residual stresses. The model with von-Karman nonlinear strains and material cubic anisotropy of single crystals contains two parameters that reflect the orientation effects. Using Ritz method, closed form solutions are given for buckling temperature and post-buckling deflections. Regarding self-instability states of nanoplates and their recovering at higher temperatures, an experiment is discussed based on low pressurized membranes to verify the predictions. For simply supported nanoplates, the size effects are lowest when they are aligned in [100] direction. When the edges get clamped, the orientation dependence is ignorable and the behavior becomes symmetric about [510] axis. The surface residual stress makes drastic increase in buckling temperature of thinner nanoplates for which a minimum thickness is pointed to stay far from material softening at higher temperatures. Deflection of [100]-oriented buckled nanoplates is higher than [110] ones but this reverses at higher temperatures. The results for long nanoplates show that the buckling mode numbers are changed by orientation which is verified by FEM.     

Change of evaporation rate of single monocomponent droplet with temperature using time-resolved phase rainbow refractometry

Droplet evaporation characterization, although of great significance, is still challenging. The recently developed phase rainbow refractometry (PRR) is proposed as an approach to measuring the droplet temperature, size as well as evaporation rate simultaneously, and is applied to a single flowing n-heptane droplet produced by a droplet-on-demand generator. The changes of droplet temperature and evaporation rate after a transient spark heating are reflected in the time-resolved PRR image. Results show that droplet evaporation rate increases with temperature, from ?1.28$\times {10}^{?8}$ m²/s at atmospheric 293 K to a range of (?1.5, ?8)$\times {10}^{?8}$ m²/s when heated to (294, 315) K, agreeing well with the Maxwell and Stefan–Fuchs model predictions. Uncertainty analysis suggests that the main source is the indeterminate gradient inside droplet, resulting in an underestimation of droplet temperature and evaporation rate. With the demonstration on simultaneous measurements of droplet refractive index as well as droplet transient and local evaporation rate in this work, PRR is a promising tool to investigate single droplet evaporation in real engine conditions.     

The role of variable surface charge and surface complexation in the adsorption of humic acid on magnetite

The ionic strength dependence of humic acid (HA) adsorption on magnetite (Fe₃O₄) was investigated at pH 5, 8 and 9, where variable charged magnetite is positive, neutral and negative, respectively. The adsorption studies revealed that HA has high affinity to magnetite surface especially at lower pH, where interacting partners have opposite charges. However, in spite of electrostatic repulsion at pH 9 notable amounts of humate are adsorbed. Increasing ionic strength enhances HA adsorption at each pH due to charge screening. The dominant interaction is probably a ligand-exchange reaction, nevertheless the Coulombic contribution to the organic matter accumulation on oxide surface is also significant under acidic condition. The results from size exclusion chromatography demonstrate that the smaller size HA fractions enriched with functional groups are adsorbed preferentially on the surface of magnetite at pH 8 in dilute NaCl solution.     

Size exclusion chromatographic determination of hydroxypropyl methyl cellulose and polyethylene glycol 400 in an ophthalmic solution

Summary Hydroxypropyl methyl cellulose (HPMC) and polyethylene glycol 400 (PEG 400) content in HypoTears™ Daily Dose ophthalmic solution are determined simultaneously by size exclusion chromatography. The retention times of HPMC and PEG 400 are 10.6 and 15.4 minutes, respectively. The method requires minimal sample pretreatment and is accurate and reproducible. The peak area response from a refractive index detector versus HPMC and PEG 400 concentration is linear over the range of 50–150 % of their label claims of 2.5 mg/mL and 10 mg/mL, respectively. The mean absolute recoveries of HPMC and PEG 400 at their label claim using the described method are 98.9±1.3 % and 100.4±1.2 % (mean±SD, n=12), respectively.     

Study of archaeological ceramics by total-reflection X-ray fluorescence spectrometry: Semi-quantitative approach

Total-reflection X-ray fluorescence spectrometry has been compared with Instrumental Neutron Activation Analysis in order to test its potential application to the study of archaeological ceramics in the archaeometric field. Two direct solid non-chemical sample preparation procedures have been checked: solid sedimentation and solid chemical homogenization. For sedimentation procedure, total-reflection X-ray fluorescence allows the analysis of the elemental composition with respect to the size fraction but not the average evaluation of the composition. For solid chemical homogenization procedure, total-reflection X-ray fluorescence provides precise (from 0.8% to 27% of coefficient of variation) and accurate results (from 91% to 110% of recovery) for 15 elements (Cr, Hf, Ni, Rb, Al, Ba, Ca, K, Mn, Ti, V, Cu, Ga, Y and Fe) with an easy sample preparation process of the solid clay and without previous chemical treatment. The influence of the particle sizes has been checked by total-reflection X-ray fluorescence sample angle scans and anomalous behaviors have been found for three additional detected elements: As, Sr and Zn, which can be attributed to interference effects of the mineral grain sizes of their associated chemical phases in the total-reflection X-ray fluorescence interference region. The solid chemical homogenization procedure produces data useful for archaeological interpretation, which is briefly illustrated by a case-study. Finally, the decantation procedure data can be also useful for size chemical speciation and, consequently, for alternative environmental total-reflection X-ray fluorescence applications.     

Studies on pre-hump and main fractions of cellulose-2,5-acetate in acetone

Technical cellulose-2.5-acetates (CA 2.5) were characterized regarding their carbohydrate composition in comparison to the raw material. The association of the CA 2.5 samples in acetone was studied by size exclusion chromatography (SEC) using various acetone grades and styrene divinylbenzene copolymer columns. In HPLC grade acetone with and without addition of 1% water up to three different pre-humps eluted in front of the main fraction of the polymer. The evaluation of the main peak by light scattering measurements resulted in high molar masses indicating that for these technical CA 2.5 samples even the main fraction is not dissolved without association. No pre-humps or association phenomena were observed after addition of 1 ppm LiBr to HPLC grade acetone or with p.a. grade acetone. In addition pre-hump enriched and pre-hump free fractions were isolated by fractionated precipitation. The carbohydrate composition of these fractions was determined and correlated with their association pattern in SEC investigations.     

回归估计样本容量的确定

本文就回归估计量回归系数已知和未知两种情况，给出确定样本容量的方法．     

A study of low level selenium determination by hydride generation atomic fluorescence spectrometry in water soluble protein and peptide fractions

Development of a method for very low level selenium determination in water soluble protein and peptide fractions, obtained after various separation procedures, is presented. A hydride generation atomic fluorescence spectrometry (HG-AFS) detection system was optimised and the influence of Cu(II), Sb(V), As(III) and HNO₃ interferences in the measurement of Se by HG-AFS was investigated. A destruction procedure using HNO₃ and H₂O₂ was also optimised and the average recovery of the digestion of a solution of selenomethioneine was 92 ± 4% (n=14). Combination of this digestion with the detection system gave reliable results. Accuracy was tested by comparison with two independent methods. A very low detection limit (DL) of 0.2 ng/g of measuring solution was achieved. The whole procedure from weighing to measuring was performed in the same Teflon tube. The addition of HNO₃ to the fractions before long term storage at -20°C was necessary to prevent adsorption on the test tubes.Selenium was measured in water soluble protein and peptide fractions obtained after extraction, and Sephadex G-75 chromatography performed on liver samples from: i) hens exposed to As₂O₃, ii) hens fed with a high fat feed and iii) the certified reference material dogfish liver (CRM DOLT-2). Because of the very low DL we were able to observe the Se distribution in chromatographic fractions of samples of organisms which were not exposed to excess amounts of Se. The presence of selenium associated with metallothioneins was observed.