随机振动数值仿真中基础激励的自动反馈识别

利用ANSYS的APDL(ANSYS Parametric Design Language)语言的强大功能,结合工程实际问题,实现了随机振动试验数值仿真计算中基础输入功率谱的自动反馈识别．反馈过程中使用多个表格来存储基础输入谱,突破了基础输入谱只能用50个以内的数据点来描述的限制,故可以一次性完成基础输入谱的反馈识别,大大提高计算效率与精度．     

微载荷含油轴承摩擦性能研究Ⅰ.摩擦试验机设计

研制了1种针对径向轴承的微载荷摩擦试验机,介绍了其工作原理及结构,即利用外加载荷抵消浮动测试架重量以施加微小载荷,并利用激光位置传感器(PSD传感器)实现无接触位移测量;同时测量了摩擦副的转动角度并计算出摩擦系数;采用摩擦转角测量法和外加力矩平衡摩擦法测量微载荷下的摩擦性能,以测量时间末端位置作为位置基准,通过极限偏载平衡进行载荷标定.结果表明:微载荷摩擦试验机可应用于径向轴承在微小载荷下的摩擦力测量;可以通过在较大范围内设置结构参数来研究径向轴承的摩擦特性;并可利用数据采集技术研究速度和载荷连续变化条件下的摩擦性能.     

Lactic acid bacteria in dairy food: Surface characterization and interactions with food matrix components

This review gives an overview of the importance of interactions occurring in dairy matrices between Lactic Acid Bacteria and milk components. Dairy products are important sources of biological active compounds of particular relevance to human health. These compounds include immunoglobulins, whey proteins and peptides, polar lipids, and lactic acid bacteria including probiotics. A better understanding of interactions between bioactive components and their delivery matrix may successfully improve their transport to their target site of action. Pioneering research on probiotic lactic acid bacteria has mainly focused on their host effects. However, very little is known about their interaction with dairy ingredients. Such knowledge could contribute to designing new and more efficient dairy food, and to better understand relationships between milk constituents. The purpose of this review is first to provide an overview of the current knowledge about the biomolecules produced on bacterial surface and the composition of the dairy matter. In order to understand how bacteria interact with dairy molecules, adhesion mechanisms are subsequently reviewed with a special focus on the environmental conditions affecting bacterial adhesion. Methods dedicated to investigate the bacterial surface and to decipher interactions between bacteria and abiotic dairy components are also detailed. Finally, relevant industrial implications of these interactions are presented and discussed.     

单元和多元取代纳米氢氧化镍晶相及其结构稳定性研究

以硝酸镍为镍源,硫酸钴、硫酸铜、硫酸铝为掺杂原料,采用超声波辅助沉淀法分别制备了单元和多元取代纳米氢氧化镍。用X射线衍射（XRD）、傅里叶变换红外光谱（FTIR）、激光粒度仪（PSD）及电子显微镜（TEM、SEM）对样品晶相结构、形貌、粒度分布等进行了表征,研究了单元或多元取代对产物晶相及其结构稳定性的影响。结果表明,样品均为纳米级Ni（OH）₂,随着掺杂元素种类的增多,其一次粒子变得细小,团聚加重,二次粒子粒径增大。样品中α-Ni（OH）₂比例随取代元素增多而增大。相对于Co单元和Co/Cu双元取代,Co/Cu/Al三元取代的样品其晶相结构更稳定,在碱液中浸泡3周后仍为纯α-Ni（OH）₂。在相同掺杂比例下,Cu取代比Co取代更有利于α-Ni（OH）₂的生成,但Co取代的样品结构稳定性优于Cu取代的样品。     

Dosimetric characterization of the Exradin W1 plastic scintillator detector through comparison with an in-house developed scintillator system

New commercial dosimetry systems need careful characterization and can benefit from the comparison with similar, in-house developed solutions. A comparison between such two dosimetry systems, both based on fibre-coupled organic plastic scintillator detectors, is presented. One system is the Exradin W1, fully commercialized by Standard Imaging, while the other system is the non-commercial ME40 system, developed by DTU Nutech with the aim of fundamental dosimetric research. Both systems employ plastic scintillator detectors that can be considered similar in design, calibrated using the same method, but differing primarily in the signal detection hardware. The two systems were compared with respect to essential dosimetric properties, with the purpose of testing their performance under conditions less well discussed in the literature. A Farmer ionization chamber was used as the primary reference of the comparison. The study demonstrated that the Cerenkov light ratio calibration coefficient of both systems was not constant, but changed systematically with photon beam quality to a maximum difference of 1.1%. Calibration with respect to stem effect correction should therefore be performed for every investigated beam quality when using plastic scintillator detectors. Both systems were found to be dose rate independent, even for the highest instantaneous dose rate evaluated (1.5 mGy per pulse). Low-dose measurements revealed large uncertainties for both systems, although the ME40 system handled short beam deliveries under reference conditions with accuracy and precision within 0.4%. Changes in response due to field size dependence were investigated and found to be as large as 3.3% for the W1 and 5.4% for the ME40, biasing output factor measurements in large fields. Great caution is therefore advised if using either system for measurements in large fields or under circumstances where the fibre irradiation geometry is unfavourable. Measurements of reference dose to water yielded differences up to 1.5% when compared with the Farmer ionization chamber for all investigated beam qualities.     

ASE Noise-Reduced Optical Receiver Based on MZI Diversity Scheme

A novel method is proposed that reduces the bit error rate (BER) in an optically amplified system by using a Mach–Zender interferometer coherence manipulation at the receiver. Exact analysis is presented, which shows that the signal-to-noise ratio can be improved by 3 dB. Resulting BER improvements are presented.     

激光标高测量振动抑制及非线性补偿研究

采用软硬件滤波技术来消除振动和空气扰动的影响,通过现场仪器标定技术来增强测量系统的适应性,非线性补偿技术、温度控制等技术的实施,使得研制出的发电机组标高测量系统具有测量动态范围大、测量精度高、实时快速、现场适应性好等特点.     

Study of ion desorption induced by a resonant core-level excitation of condensed H2O using Auger electron photo-ion coincidence (AEPICO) spectroscopy combined with synchrotron radiation

Ion desorption induced by a resonant excitation of O 1s of condensed amorphous H₂O has been studied by total ion and total electron yield spectroscopy, nonderivative Auger electron spectroscopy (AES) and Auger electron photo-ion coincidence (AEPICO) spectroscopy. The spectrum of total ion yield divided by total electron yield exhibits a characteristic threshold peak at hν = 533.4 eV, which is assigned to the 4a₁ ← O 1s resonant transition. The AES at the 4a₁ ← O 1s resonance is interpreted as being composed of the spectator-AES of the surface H₂O, and the normal-AES of the bulk H₂O, where the 4a₁ electron is delocalized before Auger transitions. H⁺ is found to be the only ion species in AEPICO spectra measured at the 4a₁ ← O 1s resonance and at the O 1s ionization (hν = 560 eV). The electron kinetic energy dependence of the AEPICO yield (AEPICO yield spectrum) at the 4a₁ ← O 1s resonance is found to be greatly different from that at the O 1s ionization. The peak positions of the AEPICO yield spectrum at the 4a₁ ← O 1s resonance are found to correspond to those of the spectator-AES of the surface H₂O, which is extracted from the AES at the 4a₁ ← O 1s resonance. Furthermore, the AEPICO yield is greatly enhanced at the 4a₁ ← O 1s resonance as compared with that at the O 1s ionization. On the basis of these results, a spectator-Auger-stimulated ion desorption mechanism and/or ultra-fast ion desorption mechanism are concluded to be responsible for the H⁺ desorption at the 4a₁ ← O 1s resonance. The enhancement of the H⁺ yield is ascribed to the O---H anti-bonding character of the 4a₁ orbital.     

TR4终端高性能探测器系统

描述了兰州中能重离子加速器TR4终端装备的高性能探测器系统的结构性能.各类探测器都达到了很好的性能指标.Si多叠层望远镜,Z/△Z～50,△E/E～0.3%.IC+PSD+SPD+CsI(T1)对数密度望远镜,Z/△Z～44.5,△x～1.7mm.棉球面反射镜结构开始时间探测器装置,△t～140Ps.重离子飞行时间谱仪,A/△A～86,Z/△Z～48,△E/E～0.78%,△t～286ps.9单元和36单元CsI(T1)轻粒子小角度关联探测器阵列,Si+CsI(T1)轻粒子望远镜也达到了很好的性能指标.简述了小角度关联等实验结果.     

PSD用于稳像仪稳像精度测试方法探讨

介绍位置灵敏探测器用于测试稳仪稳像精度的方法，给出了测试系统的组成和工作原理。