排序方式: 共有69条查询结果,搜索用时 62 毫秒
1.
低温送风是一种新型的送风方式,其送风温度较低,因而具有比常规送风更强的除湿能力。以办公室作为研究对象,建立三维数值模型,对房间内的温湿度分布和空气流动进行数值仿真计算,比较常规送风和低温送风条件下办公室内温湿度的差异。对比数值计算结果,发现两种送风方式在相同制冷量下,房间的温度分布差异不大,但低温送风具有更强的除湿能力,其相对湿度要比常规送风低10%左右,人员的热舒适性更好。此外,从制冷机组出来的冷风和回风按一定比例回合之后,混合风的温度上升,相对湿度下降,可以有效避免送风口附近区域的凝露现象。 相似文献
2.
空调在制冷和制热时,都会使房间内的湿度降低,较低的相对湿度对室内空气质量、室内人员健康及空调能耗等有着直接或间接的影响。综述了低湿度的相关影响,并对有关加湿技术在空调中的应用现状进行分析,指出现有空调加湿中存在的一些问题,为有关加湿空调的研究提供一些依据。并提出了一种应用于家用柜式空调器中的超声波雾化加湿装置。 相似文献
3.
采用能见度仪和温度脉动仪在我国东南沿海典型地区进行能见度和相对湿度测量实验,利用能见度与消光系数和波长的关系,分析了在雾霾和晴好两种天气条件下相对湿度对沿海气溶胶系统消光系数的影响。研究结果表明:对于波长为1.06μm的激光,该地区两种天气下气溶胶粒子的潮解点均为80%左右;当相对湿度在80%~90%时,随着相对湿度增大,两种天气下消光系数相对干粒子时的增长率基本相同,吸湿增长因子主要介于1~2;当相对湿度大于90%时,二者相对增长差别很大,晴好天气下吸湿增长因子增大了两个量级,远大于雾霾天气。 相似文献
4.
The effects of temperature and relative humidity on the hydrolytic degradation of poly(p-dioxanone)(PPDO) were investigated. The hydrolytic degradation behaviors were monitored by tracing the changes of water absorption, mechanical and crystalline properties, molecular weight and its distribution, surface morphologies, as well as infrared absorption peaks and hydrogen chemical shifts during the degradation. It is found that the water absorption increases whilst the intrinsic viscosity, tensile strength and elongation at break decrease as the temperature or relative humidity increases. With degradation time growing, the molecular weight drops and its distribution broadens. The crystallinity of PPDO has a tendency to increase at first and then to decrease, while the crystalline structure is not significantly changed. At the same time, some cracks are observed on the surface and keep growing and deepening. All results show that temperature plays more significant roles than relative humidity during the degradation. The analyses of Fourier transform infrared spectroscopy and hydrogen nuclear magnetic resonance spectroscopy reveal that the degradation of PPDO is a predominant hydrolysis of ester linkages. 相似文献
5.
6.
7.
A doubly cladding single-mode fiber humidity sensor is fabricated by agarose. The sensor has an insertion loss of -0.08 dB and a power change of -17.83 dB. The responses of the sensor to a relative humidity (RH) range form 30% to 100% at a temperature range form 25 to 34 ~C are validated. The experiments demonstrate that the absorbability of agarose gel to moisture decreases with increasing RH in measured gas. We propose a calibration method that uses lookup tables and construct a corresponding calibration matrix. Using the sensor, we conduct real-time monitoring of RH in fresh concrete during its hardening nrocess. 相似文献
8.
9.
为获得实际温、湿度环境中冲击波参数计算模型,计算了考虑温、湿度的理想气体状态方程参数,利用SPEED软件,针对典型状态空气中球形装药爆炸过程进行数值模拟,得到了温、湿度对爆炸冲击波参数的影响规律。结果表明,温度和相对湿度对冲击波超压的影响较小,而正压作用时间和冲量随温度和相对湿度的升高均呈线性递减关系,在高温高湿和寒冷干燥条件下,冲击波正压作用时间和冲量相差分别达21.8%和18.4%。以经典工程计算模型为基础,通过引入含有温度、湿度和对比距离的修正因子,建立了考虑环境温、湿度的球形装药爆炸冲击波参数的计算模型。采用该模型计算得到的不同药量球形TNT爆炸冲击波参数与数值仿真结果吻合较好,可对装药在实际环境中威力评估提供参考。 相似文献
10.
《低温与超导》2017,(12)
本文对风冷式冷藏保温箱送风过程进行实验研究,采用热源法测试冷藏保温箱漏热系数,冷藏保温箱内和门封四周的温度变化,建立降温时间模型,计算冷藏保温箱最佳送风量。结果表明:冷藏保温箱从环境温度降到0℃的时间,计算与实验结果的最大误差为6.93%,平均误差为5.77%;从2℃降到0℃时间的最大误差为6.15%,平均误差为5.28%,其计算模型精度较高。冷藏保温箱降温时间随送风量的增加而减短,且降温时间的减小幅度越来越小,综合考虑降温时间和初投资,送风量选择0.021m~3/s比较合适;由于门封四周密封不均匀,门封测点12#处温度最低,环境温度为10、20、30℃时,其结露临界相对湿度分别为64.4%、64.9%、52.1%,阴雨天气门封结露的可能性较大。 相似文献