丁烯催化裂解反应中的C-H键型副反应和化学平衡问题

用小型固定床反应器以及氨气程序升温脱附(NH<,3>-TPD)和吡啶吸附红外光谱(Py-IR)研究了醚后碳四液化气中的丁烯在改性纳米ZSM-5沸石催化剂上的催化裂解反应.结果表明,丁烯催化裂解反应的丙烯选择性主要受氢转移和脱氢反应制约.这些C-H键型反应生成烷烃和芳烃副产物,并导致催化剂积炭.低温有利于氢转移(尤其异丁...     

Sensing of LPG with nanostructured zinc oxide thin films grown by spray pyrolysis technique

Nanostructured zinc oxide thin films were prepared by spray pyrolysis technique using Zn(NO₃)₂·6H₂O as the precursor solution. The resulting films were investigated by X-ray diffraction and scanning electron microscopy to know crystal structure, size of crystallites and surface morphology. The films have been found to be polycrystalline zinc oxide, possessing hexagonal wurtzite crystal structure and nanocrystallite with grain size of approximately 30-35 nm. The LPG sensing performance of the films has been investigated at various concentrations of LPG in air at operating temperatures varying from 225 to 400 °C. At 325 °C the maximum responses of 46.3% and 48.9% have been observed, respectively, for concentrations of 0.8 and 1 vol% of LPG in air (1 vol% of LPG in air corresponds to 50% LEL of LPG in air). The recovery time has been found to be less than the response time for all concentrations of LPG. A possible reaction mechanism of LPG sensing has been proposed.     

模拟激光制导的实验设计

通过固定激光器，改变光学系统的状态，实现了模拟激光制导的目的。     

液化石油气水蒸气重整镍催化剂新型载体研究

以共沉淀法合成了硅铝系载体（AS和SA），并采用改性天然高铝石为原料合成了矿物质载体（MC-1和MC-2）,采用浸渍法合成了镍负载型催化剂。用常压固定床管式反应器，考察了液化石油气水蒸气重整反应活性，通过XRD、物理吸附等手段对催化剂进行了表征。结果表明，以MC-1、MC-2和SA、AS为载体的催化剂的水蒸气重整活性明显高于目前普遍使用的Ni/α-Al2O3催化剂。以SA为载体，负载5%镍的催化剂具有最好的水蒸气重整活性。在750 ℃，水碳比为2.0的条件下转化率达100％，C1选择性达94.46％。XRD分析结果表明1 300 ℃焙烧后的SA载体中存在α-Al2O3晶型和莫来石结构。硅、铝添加次序对水蒸气重整活性影响较大，硅-铝添加次序的催化剂样品的活性高于铝-硅添加次序的样品，C1选择性提高12.7％。     

DME/LPG混合燃料HCCI燃烧模拟

根据碳氢燃料化学反应系统具有层次结构的特性,本文通过分析二甲醚(DME)与液化石油气(LPG)的详细化学反应机理,构建了反映DME／LPG混合燃料均质压燃(HCCI)燃烧的详细化学反应机理．采用该机理应用单区燃烧模型对DME／LPG混合燃料HCCI燃烧的化学反应动力学过程进行了数值计算．计算结果与试验结果对比表明,所构建的DME／LPG混合燃料氧化的详细化学反应机理能够准确预测DME／LPG混合燃料的两阶段放热特性,对低温和高温着火始点的预测很好;但高温反应过程预测欠佳,高温反应机理需要改进．     

基于长周期光栅的有机聚合物高速电光调制器

结合长周期光栅的特性和有机聚合物的优点,首次提出了一种新型的基于长周期光栅的有机聚合物高速电光调制器结构。应用多层光波导理论,分析计算了聚合物折射系数变化与长周期光栅谐振波长的关系。在此基础上进行了模拟实验,结果表明理论分析与实验基本一致。     

镁铝混合氧化物负载镍催化剂的制备及在液化石油气低温重整反应中的催化性能

采用共沉淀-浸渍法制备了不同Ni 含量的 Ni/Mg(Al)O 催化剂并用于液化石油气(LPG)的低温水蒸气重整反应. X 射线衍射和程序升温还原结果表明, 在 800 ℃焙烧的 Ni/Mg(Al)O 催化剂中, NiO 与 MgO 反应生成 Mg-Ni-O 固溶体, 还原后形成金属 Ni 纳米颗粒. 详细研究了 Ni 含量(质量分数)、反应温度和水/碳摩尔比(n_H2O/n_C) 等对催化剂性能的影响. 实验结果表明, 15%Ni/Mg(Al)O 催化剂对 LPG 低温重整反应具有最佳的催化性能. 提高反应温度能显著提高 Ni/Mg(Al)O 催化剂的催化性能. 当n_H2O/n_C=2时, 在400~500 ℃的温度范围使LPG完全转化的最大反应空速从 28900 mL·h^-1·g^-1Cat提高到 86800 mL·h^-1·g^-1Cat. 适当增大水/碳摩尔比有利于 LPG 转化为小分子气体, 但在 LPG 摩尔流量不变的情况下, 反应气中水含量过高会导致 LPG 转化率降低. 反应后催化剂的X射线衍射谱(XRD)和热重分析(TG)结果表明, Ni/Mg(Al)O催化剂优良的催化活性和反应稳定性可归因于催化剂表面Ni晶粒较高的稳定性和抗积炭性能.     

????й????????????????????????

在对室内液化石油气泄漏流动过程进行量级估算分析的基础上,提出了一种预测室 内泄漏液化石油气浓度分布的简化方法. 并结合一次居民室内液 化气爆炸事故,讨论了此方法在实际应用中的简易可行性.     

纳米HZSM-5沸石酸度的调节及对液化气裂解反应的影响

通过对纳米HZSM-5沸石进行钠离子浸渍改性和在小型常压固定床反应器中开展碳四液化气催化裂解制丙烯反应研究,探讨了催化剂酸度对反应选择性的影响.结果表明,钠离子改性能够选择性地去除纳米HZSM-5沸石表面的强酸中心,而对弱酸中心则基本无影响.在用钠离子改性基本上消除催化剂强酸中心的情况下,混合碳四液化气的催化裂解反应主要发生在丁烯分子上,丙烯的最高选择性可达60%,丙烯和乙烯的总选择性可达80%.     

Synthesis of long-period fiber gratings with a Lagrange multiplier optimization method

Based on the Lagrange multiplier optimization (LMO) method, a new synthesis approach for designing complex long-period fiber grating (LPG) filters is developed and demonstrated. The proposed synthesis method is a simple and direct approach. It was used to efficiently search for optimal solutions and constrain various parameters of the designed LPG filters according to practical requirements. The inverse scattering algorithm is a good tool for designing FBG filters; as well as for designing transmission-type fiber grating filters like LPGs. Compared to the results of the discrete layer-peeling (DLP) inverse scattering algorithm for LPGs, the synthesized LPGs, using the LMO approach, are more flexible and workable for the constraint conditions can be easily set in the user-defined cost functional, such as the limitation on the maximum value of the refractive index modulation and the parameters of the initial guess in LMO algorithm. Linear transmission LPG filters and EDFA gain flattening filters are synthesized and analyzed systematically by using the proposed method with different parameters. Moreover, as a variation-based method, we find that the convergence and the synthesized results of the LMO method are strongly dependent on the initial guess parameters.