PbWO4晶体空位型缺陷电子结构的研究

采用基于密度泛函理论的相对论性离散变分和嵌入团簇方法计算了PbWO4晶体中与氧空位和铅空位相关缺陷的态密度分布,并运用过渡态方法计算了其激发能.结果表明:PbWO4晶体中WO3+VO缺陷的O2p→W5d跃迁可引起350nm和420nm附近的吸收,并且发现VPb的存在可以使WO42基团的禁带宽度明显变小 关键词： PbWO4晶体 密度泛函 氧空位和铅空位 态密度分布     

Thermal behavior of short-range-order in quenched Cu-12 at% Mn assessed by DSC

Summary The ordering behavior of quenched Cu-12 at% Mn was investigated by differential scanning calorimetry (DSC) under increasing temperature conditions. The ordering process can be better explained in terms of a homogeneous short-range-order (SRO) rather than a disperse-short-range-order (DSRO) model as for concentrated Cu-γMn solid solutions. At the employed high quench rates ordering is established in one stage here termed stage 1, assisted by excess vacancies. This stage obeys a first order kinetics law, being the effective activation energy consistent with a weighed average sum of the activation energy for migration of free and bound vacancies. An estimated solute-vacancy binding energy of 15 kJ mol^-1 seems quite reasonable for this alloy together with the assessed activation energy for complex migration of 92.6 kJ mol^-1. By adopting a first SRO order parameter based in quasi-chemical theory in pair approximation and using boundary values calculated from displayed features of DSC traces, the retained degree of quenched-in order at room temperature was calculated. This procedure also enabled to estimate an ordering energy of -2.7 kJ mol^-1. The effect of quenching temperature demonstrate that for smaller vacancy sink densities, the retained degree of order at room temperature goes through a minimum.     

EPR study of ceria–silica and ceria–alumina catalysts: Localization of superoxide radical anions

Oxygen adsorption experiments were performed on evacuated and prereduced CeO₂/SiO₂ and CeO₂/Al₂O₃ catalysts with and without platinum. Considerable amounts of the superoxide radical ions were stabilized on all the samples. Signal parameters suggest Ce⁴⁺–O₂⁻ positioning for all detectable superoxide species. Physisorbed oxygen broadens O₂⁻ signal beyond detection for all the alumina-based samples, while the same procedure for all the silica-based samples did not change signal shape of O₂⁻ species. Detectable O₂⁻ species are localized in the bulk of ceria and the nature of support (silica or alumina) determines the number of oxygen vacancies and the rate of electron transfer. XRD data suggest that for alumina-based samples small and/or thin islands of ceria dominate, while comparatively large ceria particles are stabilized on the surface of silica-based samples with the same ceria content. Average size of ceria crystallites is still not determining factor and cannot account for the observed differences. Higher concentrations of paramagnetic species may be stabilized on alumina-based samples and thus, sensor-like behavior towards gaseous oxygen at room temperature was detected for them—oxygen admission reversibly changes superoxide lineshape. For silica samples, only minor changes of O₂⁻ lineshapes were typical upon the change of the partial pressure of oxygen at ambient and low temperatures. Addition of platinum has little effect on parameters of the O₂⁻ signal, except an enhancement of the superoxide decay in the reducing media. Possible site for O₂⁻ stabilization inside the lattice of CeO₂ was proposed and relevance of the observed effects to the redox catalysis discussed.     

Energetics of magnesium, strontium, and barium doped lanthanum gallate perovskites

LaGaO₃ perovskites doped with Sr or Ba at the La site and Mg at the Ga site were prepared by solid-state reaction or sol-gel method and characterized. Enthalpies of formation from constituent oxides at 298 K were determined by high-temperature oxide melt solution calorimetry. Energetic trends are discussed in terms of defect chemistry. As oxygen deficiency increases, formation enthalpies define three trends, LaGa_1−yMg_yO_3−δ (LGM), La_1−xSr_xGa_1−yMg_yO_3−δ (LSGM), and La_1−xBa_xGa_1−yMg_yO_3−δ (LBGM). They become less exothermic with increasing doping, suggesting a dominant destabilization effect from oxygen vacancies. The endothermic enthalpy of vacancy formation is 275±37, 166±18 and 138±12 kJ/mol of V_O^·· for LGM, LBGM and LSGM, respectively. Tolerance factor and ion size mismatch also affect enthalpies. In terms of energetics, Sr is the best dopant for the La site and Mg for the Ga site, supporting earlier studies, including oxygen ion conductivity and computer modeling.     

Properties of Ce–Zr–La–O nano-system with ruthenium modified surface

Structural peculiarities of Ce–Zr–La–O and Ce–Zr–La–O/Ru samples in mean of catalytic properties are compared. The samples (Ce:Zr = 1:1, La = 10÷30 mol.%, Ru = 1.5 wt.%) were obtained by sol–gel method (X-samples) and co-precipitation (P-samples). It is shown that Ce_0.45Zr_0.45La_0.1O_2−δ/Ru X-samples are characterized by high thermal stability and the highest catalytic activity in partial methane oxidation reaction. According to XRD, BET, FTIR, EPR and XPS data it is concluded that the difference in the samples catalytic activity is caused by various disposition of Ru-containing phase on the support surface. The distinction in the dimension of Ru-containing particles (3D or 2D) is conditioned by structural peculiarities of Ce_0.45Zr_0.45La_0.1O_2−δ and Ce_0.35Zr_0.35La_0.3O_2−δ P- and X-samples.     

Low-Temperature Phase Formation of Sn-Doped LaMnO3+δ Perovskite

The incorporation of Sn into LaMnO₃ perovskite and its influence on magnetotransport properties were studied in samples synthesized at low temperature. Single-phase materials for two series of samples with La/(Sn+Mn)=1 and La/(Sn+Mn)<1 ratios were obtained by substitution of up to 10% of the Mn ions by Sn⁴⁺. The effect of Sn substitution was monitored through measurements of thermal, “M(T)”, and magnetic field, “M(H)”, dependences of magnetization, as well as of resistivity, “ρ(T)”, at 0 and 70 kOe. These showed that this effect depends strongly on the perovskite cation site ratio (A/B). For La/(Sn+Mn)=1, M and T_C were depressed as Sn content was increased. The magnetization data suggest the presence of magnetic clusters with superparamagnetic behavior. No evidence of magnetoresistance (MR) was found. For La/(Sn+Mn)<1 ratio, the samples showed ferromagnetic behavior and MR and both M and T_C raised as Sn content increased. The results are discussed in terms of A site vacancies.     

First-principles study on the electronic structure and optical properties of La0.75Sr0.25MnO3-σ materials with oxygen vacancies defects

The electronic structure and optical properties of La_0.75Sr_0.25MnO_3-σ (LSMO_3-σ) materials with 1 × 1 × 4 orthorhombic perovskite structure were performed by first-principles calculation. The structural changing of LSMO₃ (ideal structure, σ = 0) was not obvious under generalized gradient approximation (GGA) and GGA + U arithmetic. On the contrary, the structural changing of LSMO_3-σ (σ = 0.25, with oxygen vacancies defects in the z = 0, c/8, c/6, c/4, and c/2) with GGA + U were more obvious than the result of ideal. This structural distortion induced distinct changing in density of states (DOS) for LSMO_3-σ materials. Oxygen vacancy defects caused a shift of the total density of states (TDOS) features toward low binding energies and LSMO_3-σ keep half-metal properties as well as LSMO₃ ideal structure. In addition, the hybridization between the Mn-e_g and O-2p orbital was weakened and the partial density of states (PDOS) of Mn indicated a strong d-d orbital interaction. By the result of oxygen vacancy formation energy, oxygen vacancy defects can be more easily formed in La-O layers (z = 0 and c/6) to compare with other layers (z = c/8, c/4 and c/2). The calculation result of optical properties suggested that the ideal LSMO could be produced strong absorption in the range of ultraviolet and visible light, while the LSMO_3-σ with oxygen vacancies defects were presented weak absorption in the range of visible light.     

Phase-field modeling of void evolution and swelling in materials under irradiation

Void swelling is an important phenomenon observed in both nuclear fuels and cladding materials in operating nuclear reactors. In this work we develop a phase-field model to simulate void evolution and void volume change in irradiated materials. Important material processes, including the generation of defects such as vacancies and self-interstitials, their diffusion and annihilation, and void nucleation and evolution, have been taken into account in this model. The thermodynamic and kinetic properties, such...     

Feasible Tuning of Surface OVs on (001) TiO2 for Superior Photocatalytic Nitrogen Fixation Activity

A feasible tuning method for oxygen vacancies was realized by annealing under 3 atm H₂ with (001)-exposed TiO₂ nanosheets. The colored TiO₂ sample exhibits an excellent N₂ photo-fixation rate owing to the abundant oxygen vacancies (OVs) thus demonstrating that annealing with high pressure H₂ is exceedingly efficient for tuning surface OVs.     

溶剂热合成可调控氧空位的Bi2MoO6纳米晶及其光催化氧化制喹啉和抗生素降解

近年来,半导体光催化在环境净化和有机合成领域的研究引起了广泛的重视.其中,在有机合成领域中,光催化技术已经应用在醇类、环己烷以及芳香族化合物的选择性氧化研究.而另一类具有特殊结构的有机物——N-杂环芳烃,在药物化学和材料科学中具有重要意义.而传统用于合成N-杂化芳烃的脱氢催化氧化反应通常需要高温高压的苛刻环境,传统方法通常还需要使用贵金属催化剂,这也增加了N-杂化芳烃的合成成本;另外,如果合成是均相催化过程,则催化剂难以实现回收利用.因此,开发室温常压条件下的非贵金属多相光催化技术具有巨大的应用前景.本文以能够被可见光驱动的钼酸铋半导体为催化剂,利用氧缺陷策略来提升钼酸铋的光催化氧化性能.不同于传统氧缺陷制备方法(氢气还原热处理、离子掺杂等),本文采用一种低成本的乙二醛辅助溶剂热的方法合成具有可调控的含氧空位Bi₂MoO₆催化剂(OVBMO).通过X射线粉末衍射(XRD)、扫描电镜、透射电镜、紫外可见漫反射吸收光谱、氮气物理吸附脱附、X射线光电子能谱(XPS)、电子自旋共振光谱、光致发光光谱及电化学测试等技术对制备的OVBMO材料进行了物理化学性质及能带研究.XPS,XRD,Raman和FT-IR结果表明,氧空位存在于[Bi₂O₂]²⁺和MoO₆八面体的层间.紫外可见漫反射结果表明,随着氧空位的引入,Bi₂MoO₆的光吸收范围扩大,带隙变窄.结合莫特肖特基和VBXPS分析获得OVBMO的能带位置,发现氧空位的存在不仅会导致禁带中出现缺陷带能级,还会导致价带顶位置上移,促进光生空穴的迁移.PL和电化学结果表明,氧空位的存在使得载流子浓度、载流子的分离能力与界面电荷迁移能力都有较大提升,这是因为氧空位引入的缺陷能级可以浅势捕获电子,抑制光催化剂中的电子与空穴的复合,改变化学反应的速率.同时,氧空位有助于捕获分子氧,分子氧与捕获的光生电子发生反应,产生更多的超氧自由基(·O₂)和空穴(h⁺),从而极大地提升光催化剂的氧化性能.因此,OVBMO在1,2,3,4-四氢喹啉脱氢氧化产生喹啉及系列抗生素(环丙沙星、四环素、盐酸土霉素)的降解反应中,表现出较好的光催化氧化性能.结合多种表征分析,本文还进一步阐明了OVBMO催化剂将1,2,3,4-四氢喹啉脱氢氧化为喹啉的自由基参与的多相催化反应机理.