离子阱中热库诱导退相干的控制

对单个囚禁离子在热库作用下的退相干的控制问题进行了研究.本文提出的控制方法是基于消除自由哈密顿技术和脉冲重聚技术的结合.前者是利用一个经典大失谐激光场作用于囚禁离子来实现的,而后者是利用一系列的激光π脉冲来实现的.解析与数值表明,应用这种控制方法可以有效消除量子退相干且比纯粹应用脉冲重聚技术要好.     

<Emphasis Type="Italic">J/Ψ</Emphasis>production

For more than 25 yearsJΨ production has helped to sharpen our understanding of QCD. In proton induced reaction some observations are rather well understood while others are still unclear. The current status of the theory ofJΨ production will be sketched, paying special attention to the issues of formation time andJΨ re-interaction in a nuclear medium.     

铁基添加剂增强细水雾灭火性能的实验研究

采用实验模拟的方法,研究了添加氯化亚铁的细水雾在不同添加剂浓度、不同喷头压力下,熄灭不同性质的液体池火的性能。实验结果表明:添加有氯化亚铁的细水雾,其灭火性能发生了显著变化。存在一个最佳的灭火浓度,其对应的灭火时间最短,耗水量最少,灭火效率最高。细水雾喷头的工作压力和燃料的性质也对细水雾的灭火性能有影响:工作压力越大,细水雾的平均灭火时间越短。在相同的实验条件下,细水雾扑灭煤油池火的时间要短于扑灭酒精池火的时间。     

Relaxation-Induced Suppression of Vortex Disturbances in a Molecular Gas

The influence of thermal excitation on a finite-amplitude vortex disturbance in a shear flow of a molecular gas is studied in a model problem. The evolution of such vortex structures is typical of both the nonlinear stage of the laminar–turbulent transition and for developed turbulence. Since the excitation level was assumed to be comparatively low, full Navier–Stokes equations for a compressible heat-conducting gas were used in calculations; nonequilibrium was taken into account by the coefficient of bulk viscosity. As the bulk viscosity increases in the range of realistic values, the disturbance-energy damping rate in a weakly compressible flow increases approximately by 10%. The increase in the Mach number enhances the effect of disturbance suppression.     

Suppression of red cell diffusional water permeability by lipophilic solutes

The inhibitory effect of a series of neutral lipophilic solutes (methanol, ethanol, n-propanol, iso-propanol, n-butanol, iso-amylalcohol, n-hexanol, diethylether, nitrobenzene, and pyridine) on the diffusional water permeability (Pd, tot) of bovine erythrocyte membrane at 25 degrees C was studied in comparison to that of p-chloromercuri benzoate (pCMB). Permeability data were obtained by measuring the transmembrane diffusional water exchange time tau(exch) using an 1H-T2 NMR technique. Maximal inhibition by approximately 50% of Pd, tot was produced by 2 mM pCMB which completely blocked the membrane water channels in 20 min, hence suggesting the channel-to-lipid diffusional water permeability ratio of about 1:1. Furthermore, the maximal inhibitory effect of pCMB in combination with the lipophilic solutes was lower than that of pCMB alone. As pCMB does not interfere with the lipid bilayer, and provided that it blocks the water channels in solute presence as well, this confirms that the solutes induce an increase in the lipid-mediated background water permeability contribution (Pd, lipid) by the formation of aqueous leaks in the membrane hydrophobic barrier. However, faster but less efficient in permeability inhibition than pCMB (either alone or combined with solutes) were the lipophilic solutes alone. Taken together, the results indicate that the lipophilic solutes suppress the membrane total permeability Pd, tot by two opposing effects: a reduction of its channel-mediated part (Pd, channel) to the extent exceeding that of a simultaneous Pd, lipid increase. The inhibitory potency of the solutes tested appears to be correlated with their solubility in the membrane medium.     

夸克随机组合机制与激发态重子的产生

从强子化过程的两个基本性质出发,在夸克随机组合框架上,得出了包括所有激发态在内的重子产生权重的一组基本关系．解释了“自旋抑制”和单态重子产额大的原因．最后,讨论了进一步确定激发态重子产生比例的条件和方法．     

Mode selective directional couplers for overmoded waveguide systems

Two types of directional couplers for transverse electric (TE) modes are described: short and multihole couplers, respectively. They selectively pick one mode out of a mode mixture in an overmoded circular waveguide system. Unwanted modes are either statistically kept at low level or are suppressed by destructive interference in the coupling waveguide. Mode selectivity and directivity in multihole couplers oscillate up and down with an increasing number of holes, finally reaching a minimum of approximately 20 dB, unless there are competing modes with rational fractions of the beat wavelength. A multihole coupler for the TE₀₂ mode (28 GHz, 63.4 mm waveguide diameter, 41 holes) and a length of 1.6 m shows a calculated directivity of 68 dB and suppresses the unwanted modes TE₀₁ with 34 dB (24 dB), TE₂₂ with 37 dB (45 dB), and further modes TE_m (<5, m<6) with 17 dB to 34 dB in forward direction (figures in parentheses are for unwanted modes propagating in backward direction).A short directional coupler for the TE₀₁ mode (28 GHz, 63.4 mm waveguide diameter) with 16 holes and a length of 230 mm shows a directivity of 55 to 100 dB between 27.9 and 28.1 GHz, suppressing the TE₀₂ mode with 35 to 80 dB, the TE₀₃ mode with 30 to 65 dB, and the TE₂₂ mode with 30 to 70 dB.     

Effects of ion-pairing reagents on the electrospray signal suppression of sulphonated dyes and intermediates

High-performance liquid chromatography/mass spectrometry (HPLC/MS) analysis of anionic species such as sulphonic acid dyes and intermediates requires volatile ion-pairing mobile phase additives. Six di- and trialkylammonium acetates were compared with tetraalkylammonium salts and ammonium acetate in the concentration range 0-20 mmol l(-1) as mobile phase additives for HPLC/MS of polysulphonated compounds. The effects of the structure and concentration of the ion-pairing reagents on the electrospray response of mono-, di- and tetrasulphonic aromatic acids and acid dyes were studied in detail. Further, five different mass analysers and instrument geometries were compared. A higher signal decrease is observed with linear geometry instruments in comparison to orthogonal or even Z-spray geometry mass spectrometers. The concentration of mobile phase additives has a significant influence on the abundance ratios of multiply charged ions in the mass spectra of polysulphonated compounds. The competing ions of sulphonic acids may also cause significant signal suppression.     

Investigation into the structural composition of hydroalcoholic solutions as basis for the development of multiple suppression pulse sequences for NMR measurement of alcoholic beverages

An eight‐fold suppression pulse sequence was recently developed to improve sensitivity in ¹H NMR measurements of alcoholic beverages [Magn. Res. Chem. 2011 (49): 734–739]. To ensure that only one combined hydroxyl peak from water and ethanol appears in the spectrum, adjustment to a certain range of ethanol concentrations was required. To explain this observation, the structure of water–ethanol solutions was studied. Hydroalcoholic solutions showed extreme behavior at 25% vol, 46% vol, and 83% vol ethanol according to ¹H NMR experiments. Near‐infrared spectroscopy confirmed the occurrence of four significant compounds (‘individual’ ethanol and water structures as well as two water–ethanol complexes of defined composition – 1 : 1 and 1 : 3). The successful multiple suppression can be achieved for every kind of alcoholic beverage with different alcoholic strengths, when the final ethanol concentration is adjusted to a range between 25% vol and 46% vol (e.g. using dilution or pure ethanol addition). In this optimum region, an individual ethanol peak was not detected, because the ‘individual’ water structure and the 1 : 1 ethanol–water complex predominate. The nature of molecular association in ethanol–water solutions is essential to elucidate NMR method development for measurement of alcoholic beverages. The presented approach can be used to optimize other NMR suppression protocols for binary water–organic solvent mixtures, where hydrogen bonding plays a dominant role. Copyright © 2014 John Wiley & Sons, Ltd.     

Molecular signal suppression by in situ microextraction in nuclear magnetic resonance spectroscopy

The detailed characterization of complex mixtures by NMR is often hampered by the presence of signals from uninformative compounds, the resonances of which overlap with those of the molecules of interest. We provide here a proof of principle for an approach to NMR signal suppression in complex samples using Molecularly Imprinted Polymers (MIPS). Addition of a few milligrams of polymer to a solution traps the target molecule in typical micromolar to millimolar concentration, thus achieving in situ signal suppression, without altering any other spectral features. This method minimized any manipulation or perturbation of the spectrum and was applied to a complex mixture of known compounds and to a plant extract, in both cases spiked with a compound (bisphenol A), which was subsequently removed by selective binding to a complementary MIP. What is described in this report is comparable with microextraction and may in due course be applied to a large number of analytical challenges. Copyright © 2014 John Wiley & Sons, Ltd.