Salting‐out‐assisted liquid–liquid extraction with acetonitrile for the determination of trimetazidine in rat plasma using liquid chromatography–mass spectrometry

A high‐throughout bioanalytical method based on salting‐out‐assisted liquid/liquid extraction (SALLE) method with acetonitrile and mass spectrometry‐compatible salts followed by LC‐MS/MS analysis of trimetazidine in rat plasma is presented. It required only 50 μL of plasma and allows the use of minimal volumes of organic solvents. The seamless interface of SALLE and LC‐MS eliminated the drying‐down step and the extract was diluted and injected into an LC‐MS/MS system with a cycle time of 2.5 min/sample. The retention times of trimetazidine and IS were approximately 1.1 and 1.7 min, respectively. Calibration curves were linear over the concentration range of 0.1–100 ng/mL, which can be extended to 500 ng/mL by dilution. The intra‐ and inter‐batch precision, accuracy and the relative standard deviation were all <15%. This method was successfully applied to determine trimetazidine concentrations in rat plasma. Copyright © 2014 John Wiley & Sons, Ltd.     

Effect of chemical parameters on pyrene degradation in soil in a pulsed discharge plasma system

Degradation of pyrene in soil in a net-to-net pulsed discharge plasma (PDP) system was reviewed. Effect of main chemical parameters, including air flow rate, pyrene concentration, initial pH and soil moisture content on pyrene degradation was examined. The obtained results show that 87.9% of pyrene could be removed under the condition of 60 min reaction; increasing of air flow rate within 1 L min⁻¹ was favorable for degradation; pyrene removal was decreased with the increase of initial pyrene concentration; oxidation of pyrene was more evident in acidic soil; enhancement of soil moisture content has no benefit on pyrene degradation.     

Elongating the area of plasma/fluid interaction of surface nanosecond pulsed discharges

Plasma-assisted flow control is of high industrial interest, but practical applications at full scale require a large surface of interaction. Nanosecond pulsed Dielectric Barrier Discharge (DBD) have demonstrated promising results of flow control, but their interacting region is limited to only a few cm². In this paper, the conditions to extend a surface nanosecond DBD are documented. It is shown that a sliding discharge regime can fully fill an inter-electrode distance of 40 mm. This discharge regime promotes the formation of two hemispheric pressure waves originating from both air-exposed electrodes while an horizontal region of pressure gradient is also observed.     

Enhancing the Water Stability of Al‐MIL‐101‐NH2 via Postsynthetic Modification

The resistance of metal–organic frameworks towards water is a very critical issue concerning their practical use. Recently, it was shown for microporous MOFs that the water stability could be increased by introducing hydrophobic pendant groups. Here, we demonstrate a remarkable stabilisation of the mesoporous MOF Al‐MIL‐101‐NH₂ by postsynthetic modification with phenyl isocyanate. In this process 86 % of the amino groups were converted into phenylurea units. As a consequence, the long‐term stability of Al‐MIL‐101‐URPh in liquid water could be extended beyond a week. In water saturated atmospheres Al‐MIL‐101‐URPh decomposed at least 12‐times slower than the unfunctionalised analogue. To study the underlying processes both materials were characterised by Ar, N₂ and H₂O sorption measurements, powder X‐ray diffraction, thermogravimetric and chemical analysis as well as solid‐state NMR and IR spectroscopy. Postsynthetic modification decreased the BET equivalent surface area from 3363 to 1555 m² g^?1 for Al‐MIL‐101‐URPh and reduced the mean diameters of the mesopores by 0.6 nm without degrading the structure significantly and reducing thermal stability. In spite of similar water uptake capacities, the relative humidity‐dependent uptake of Al‐MIL‐101‐URPh is slowed and occurs at higher relative humidity values. In combination with ¹H‐²⁷Al D ‐HMQC NMR spectroscopy experiments this favours a shielding mechanism of the Al clusters by the pendant phenyl groups and rules out pore blocking.     

HPLC with fluorescence detection assay of perampanel,a novel AMPA receptor antagonist,in human plasma for clinical pharmacokinetic studies

Perampanel (Fycompa®), a novel α‐amino‐3‐hydroxy‐5‐methyl‐4‐isoxazolepropionic acid (AMPA) receptor antagonist, is registered for the adjunctive treatment of patients (aged ≥12 years) with refractory partial‐onset seizures. To support therapeutic drug monitoring, a simple high‐performance liquid chromatography (HPLC) assay with fluorescence detection was developed to determine perampanel concentrations in human plasma and validated to support clinical trials. Human plasma samples (1.0 mL) were processed by liquid extraction using diethyl ether, followed by chromatographic separation on a YMC Pack Pro C₁₈ column (150 × 4.6 mm i.d., 5 µm) with isocratic elution of acetonitrile–water–acetic acid–sodium acetate (840:560:3:1.8, v/v/v/w) at a flow rate of 1.0 mL/min. Column eluent was monitored at excitation and emission wavelengths of 290 and 430 nm, respectively. The assay was linear (range 1.0–500 ng/mL) and this could be extended to 25 µg/mL by 50‐fold dilution integrity. No endogenous peaks were detected in the elution of analytes in drug‐free blank human plasma from six individuals and no interference was observed with co‐medications tested. Intra‐ and inter‐batch reproducibility studies demonstrated accuracy and precision within the acceptance criteria of bioanalytical guidelines. Validation data demonstrated that our assay is simple, selective, reproducible and suitable for therapeutic drug monitoring of perampanel. Copyright © 2015 John Wiley & Sons, Ltd.     

Influence of Azimuthal Structure of Surface Waves on Efficiency of their Excitation by Tubular Electron Beams

The excitation of eigen surface waves by tubular electron beams in cylindrical discharge devices is studied. The influence of the wave‐field azimuthal structure on the excitation efficiency and nonlinear stage of the plasmabeam instability is investigated both numerically and analytically. Analytical expressions for the saturation amplitude and excitation efficiency of the wave under study are derived. They are found to agree well with results obtained by numerical modelling of the plasma‐beam interaction presented in this paper. (© 2006 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)     

Analysis of a 2D “liquid”plasma lattice

Adustyplasmacanbedefinedasacomplicatedplasmacontainingsmallsolidmattercalleddustgrainsordustparticles,whichareusuallychargednegatively,duetoelectronshighermobilitythanion,bycollectingelectronsandionsfromthebackgroundplasma.Theuniverseisfilledwithdustyplasmassuchasplanetaryrings,comettails,andnebulae.Also,inindustrialplasmaprocessing,particulatessuspendedinplasmaarethemajorcontaminationinsemiconductormanufacture.Studiesondustyplasmahavebeenextendedtofar-flungtopicssuchaswaves,instabilities,stro…     

Synthesis of molecular imprinted organic-inorganic hybrid polymer binding caffeine

Random copolymers of poly{(methacrylamide)-co-(vinyl trimethoxysilane)} and poly{(methacrylic acid)-co-(vinyl trimethoxysilane)} were synthesized via a free radical polymerization reaction. Acid catalyzed sol-gel process of tetraethylorthosilicate (TEOS) with aforementioned polymers in the presence of methyl xanthine class of alkaloid like caffeine resulted in the formation of highly transparent monoliths. Solvent extraction of the template leaves behind the recognition sites intact with high selectivity towards the print molecule. The ionic and non-specific adsorptions, which are considered to be the main disadvantages of the molecularly imprinted polymers (MIP), are prevented to a considerable extent by the end capping of surface silanol groups. The template binding efficiencies of MIP were determined by HPLC analysis.     

Role of Bulk Vaporization in the Dynamics of Laser-Induced Erosion Plumes of Metals

In different regimes of exposure of metals to pulsed laser radiation, we show the role played by the liquid-drop phase formed from the target material in a laser-induced erosion plume due to bulk vaporization, in the dynamics of this plume. For some metals, the ranges of power densities of the acting laser radiation, at which the condensed-phase particles influence the passage of laser radiation to the target surface, have been determined experimentally. The mechanism of realization of a low-threshold breakdown has been revealed.