玻璃陶瓷材料中Tm3+离子红外到蓝色上转换发光

系统研究了PbF2+GeO2+WO3ⅩⅣTmF3玻璃陶瓷材料中,在近红外光(1.06μm)激发下,Tm3+离子的发光特性.实验中观测到Tm3+离子的两组峰值位置分别在20920cm-1和22173cm-1的蓝色上转换发光,并证实这两组上转换发光分别与吸收三个和四个光子有关,同时建立了上转换发光的模型.为了选择最佳掺杂浓度,详细地测量了Tm3+离子峰值为20920cm-1的蓝色上转换发光强度与TmF3浓度的关系.     

Electronic structure of Ti metal and TiO2 powder studied by hard and soft (Cu Kα1 and Al Kα1) X-ray photoelectron and Auger spectroscopy

High-energy X-ray photoelectron spectroscopy (XPS) is of particular importance for minimizing the effects of surface contamination by increasing photoelectron escape depths. In this study high-resolution high-energy Cu Kα₁ and soft Al Kα₁ XPS and Auger electron spectroscopy were used to compare the electronic structure of Ti in TiO₂ powder and Ti metal. The Ti 1s in TiO₂ XPS line is narrower and more symmetric than in Ti metal. A comparison of the relative intensities of the L₂₃M₂₃M₄₅ and L₂₃M₂₃M₂₃ Auger transitions in Ti metal and TiO₂ is consistent with the expected transfer of Ti 3d electrons away from the Ti site in the oxide. The satellites accompanying the Ti 1s XPS line excited by Cu Kα₁ X-rays occur at the same energies as the satellites accompanying the Ti 2s and 2p XPS lines excited by Al Kα₁ X-rays indicating that they do not depend on the core-level, the experimental resolution or inelastic scattering processes.     

Preparation and properties of homogeneous V2O5-SiO2 xerogel composite based on interpenetrating polymer network

In this paper, we report the conducting and electrochemical properties of a homogeneous V₂O₅-SiO₂ xerogel composite obtained from the simultaneous polymerization in both inorganic components (Si-O and V-O based polymers) forming an interpenetrating polymer network, where a mutual “solubility” due to cross-links and entanglements was observed. The presence of V₂O₅ inside the silica matrix has a strong effect on electrical conductivity; measurements showed room temperature conductivity almost 1000 times higher than what is found in the literature. In addition, the electrochemical behavior is quite similar to that found in V₂O₅ xerogel. Moreover, the effects of thermal treatment on the conducting and electrochemical properties were investigated. It was found that both properties were improved with no significant effect on V₂O₅ xerogel layered structure.     

Study of archaeological ceramics by total-reflection X-ray fluorescence spectrometry: Semi-quantitative approach

Total-reflection X-ray fluorescence spectrometry has been compared with Instrumental Neutron Activation Analysis in order to test its potential application to the study of archaeological ceramics in the archaeometric field. Two direct solid non-chemical sample preparation procedures have been checked: solid sedimentation and solid chemical homogenization. For sedimentation procedure, total-reflection X-ray fluorescence allows the analysis of the elemental composition with respect to the size fraction but not the average evaluation of the composition. For solid chemical homogenization procedure, total-reflection X-ray fluorescence provides precise (from 0.8% to 27% of coefficient of variation) and accurate results (from 91% to 110% of recovery) for 15 elements (Cr, Hf, Ni, Rb, Al, Ba, Ca, K, Mn, Ti, V, Cu, Ga, Y and Fe) with an easy sample preparation process of the solid clay and without previous chemical treatment. The influence of the particle sizes has been checked by total-reflection X-ray fluorescence sample angle scans and anomalous behaviors have been found for three additional detected elements: As, Sr and Zn, which can be attributed to interference effects of the mineral grain sizes of their associated chemical phases in the total-reflection X-ray fluorescence interference region. The solid chemical homogenization procedure produces data useful for archaeological interpretation, which is briefly illustrated by a case-study. Finally, the decantation procedure data can be also useful for size chemical speciation and, consequently, for alternative environmental total-reflection X-ray fluorescence applications.     

Band bending at the Si(1 1 1)–SiO2 interface induced by low-energy ion bombardment

Experiments employing photoreflectance spectroscopy have uncovered band bending due to electrically active defects at the Si(1 1 1)–SiO₂ interface after sub-keV Ar⁺ ion bombardment. The band bending of about 0.5 eV resembles that for Si(1 0 0)–SiO₂, and both interfaces exhibit two kinetic regimes for the evolution of band bending upon annealing due to defects healing. The healing takes place about an order of magnitude more quickly at the (1 1 1) interface, however, probably because of less fully saturated bonding and higher compressive stress.     

Ab initio study of sodium intercalation into metal oxides

Using the full-potential linearized augmented plane wave (FP-LAPW) method, we have studied the effect of chemistry on the average intercalation voltage (AIV) caused by the Na ions intercalating into transition metal oxides. The effect of transition metal was systematically studied by varying M=Co, Ni and Mn in NaMO₂ and fixing the α-NaFeO₂ layered structure. The effect of the guest atoms into the host material is discussed in terms of the structural and electronic properties. Comparatively to Li intercalation, a significant electron transfer towards transition metal was found. This observation suggests that the transition metal contribute to the AIV determination and confirms the common assumption that intercalated electron reduces M⁴⁺ to M³⁺.     

氟氧化物陶瓷的多谱线上转换发光

以氧化硅、氟化铅为基质制备了Er3 :Yb3 共掺杂氟氧化物陶瓷 ,X 射线分析表明陶瓷中存在着 β PbF2 晶相 ,沉积在其中的稀土离子由于具有很低的无辐射跃迁几率而显示出良好的上转换性能。Er3 ,Yb3 离子之间存在的多种能量传递通道 ,导致稀土离子十分丰富的上转换谱线的出现。     

Superconductivity and normal state resistivity of Ba0.6K0.4BiO3: an optical phonon approach

We discuss the nature of the pairing mechanism and the physical properties associated with the normal as well as the superconducting state of cubic perovskites Ba_0.6K_0.4BiO₃using the strong coupling theory. An interaction potential which includes the Coulomb, electron–optical phonon and electron–plasmon interactions is developed to elucidate the superconducting state. A model dielectric function is constructed with these interactions fulfilling thef-sum rule. The screening parameter (μ^* = 0.26) infers the poor screening of charge carriers. The electron–optical phonon strength (λ) estimated as 0.98 is consistent with an attractive electron–electron interaction and supports the moderate to strong coupling theory. The superconducting transition temperature of Ba_0.6K_0.4BiO₃is then estimated as 32 K. Ziman's formula of resistivity is employed to analyse and compare this with the temperature-dependent resistivity of a single crystal. The estimated contribution from the electron–optical phonon together with the residual resistivity clearly infers a difference when a comparison is made with experimental data. The subtracted data infer a quadratic temperature dependence in the temperature domain (30 ≤ T ≤ 200 K). The quadratic temperature dependence of ρ [ = ρ_exp − (ρ₀ + ρ_e–ph)] is understood in terms of 3D electron–electron inelastic scattering. The presence of these el–el and el–ph interactions allows a coherent interpretation of the physical properties. Analysis reveals that a moderate to strong coupling exists in the Ba_0.6K_0.4BiO₃system and the coupling of electrons with the high-energy optical phonons of the oxygen breathing mode will be a reason for superconductivity. The implications of the above analysis are discussed.