玻璃陶瓷材料中Tm3+离子红外到蓝色上转换发光

系统研究了PbF2+GeO2+WO3ⅩⅣTmF3玻璃陶瓷材料中,在近红外光(1.06μm)激发下,Tm3+离子的发光特性.实验中观测到Tm3+离子的两组峰值位置分别在20920cm-1和22173cm-1的蓝色上转换发光,并证实这两组上转换发光分别与吸收三个和四个光子有关,同时建立了上转换发光的模型.为了选择最佳掺杂浓度,详细地测量了Tm3+离子峰值为20920cm-1的蓝色上转换发光强度与TmF3浓度的关系.     

Towards the synthesis of MAX-phase functional coatings by pulsed laser deposition

Pulsed laser deposition with a Nd:YAG laser was used to grow thin films from a pre-synthesized Ti₃SiC₂ MAX-phase formulated ablation target on oxidized Si(1 0 0) and MgO(1 0 0) substrates. The depositions were carried out in a substrate temperature range from 300 to 900 K, and the pressure in the deposition chamber ranged from vacuum (10⁻⁵ Pa) to 0.05 Pa Argon background pressure. The properties of the films have been investigated by Rutherford backscattering spectrometry for film thickness and stoichiometric composition and X-ray diffraction for the crystallinity of the films. The silicon content of the films varied with the energy density of the laser beam. To suppress especially the silicon re-sputtering from the substrate, the energy of the incoming particles must be below a threshold of 20 eV. Therefore, the energy density of the laser beam must not be too high. At constant deposition energy density the film thickness depends strongly on the background pressure. The X-ray diffraction measurements show patterns that are typical of amorphous films, i.e. no Ti₃SiC₂ related reflections were found. Only a very weak TiC(2 0 0) reflection was seen, indicating the presence of a small amount of crystalline TiC.     

Study of archaeological ceramics by total-reflection X-ray fluorescence spectrometry: Semi-quantitative approach

Total-reflection X-ray fluorescence spectrometry has been compared with Instrumental Neutron Activation Analysis in order to test its potential application to the study of archaeological ceramics in the archaeometric field. Two direct solid non-chemical sample preparation procedures have been checked: solid sedimentation and solid chemical homogenization. For sedimentation procedure, total-reflection X-ray fluorescence allows the analysis of the elemental composition with respect to the size fraction but not the average evaluation of the composition. For solid chemical homogenization procedure, total-reflection X-ray fluorescence provides precise (from 0.8% to 27% of coefficient of variation) and accurate results (from 91% to 110% of recovery) for 15 elements (Cr, Hf, Ni, Rb, Al, Ba, Ca, K, Mn, Ti, V, Cu, Ga, Y and Fe) with an easy sample preparation process of the solid clay and without previous chemical treatment. The influence of the particle sizes has been checked by total-reflection X-ray fluorescence sample angle scans and anomalous behaviors have been found for three additional detected elements: As, Sr and Zn, which can be attributed to interference effects of the mineral grain sizes of their associated chemical phases in the total-reflection X-ray fluorescence interference region. The solid chemical homogenization procedure produces data useful for archaeological interpretation, which is briefly illustrated by a case-study. Finally, the decantation procedure data can be also useful for size chemical speciation and, consequently, for alternative environmental total-reflection X-ray fluorescence applications.     

氟氧化物陶瓷的多谱线上转换发光

以氧化硅、氟化铅为基质制备了Er3 :Yb3 共掺杂氟氧化物陶瓷 ,X 射线分析表明陶瓷中存在着 β PbF2 晶相 ,沉积在其中的稀土离子由于具有很低的无辐射跃迁几率而显示出良好的上转换性能。Er3 ,Yb3 离子之间存在的多种能量传递通道 ,导致稀土离子十分丰富的上转换谱线的出现。     

La2O3对氧化铝透明陶瓷显微结构和透光性能的影响

采用传统无压烧结工艺在氢气氛下制备Al2O3透明陶瓷。实验结果表明：MgO和La2O3复合添加时，随着La2O3掺杂量的增加体积密度总体上保持上升的趋势。随着保温时间的延长，陶瓷的致密化程度增大，残余气孔逐步排出，晶粒进一步长大。采用La2O3和MgO复合添加比单独掺入MgO陶瓷样品透过率更高，掺杂效果更好。在烧结温度为1750℃，保温时问为1h条件下，在波艮为300～800nm测试范围内，陶瓷样品的全透过率大于82％，最大值为86％。     

Evolution of Er^3＋ Distribution in the Oxyfluoride Glass Ceramics with Heating

The distribution characteristics of Er3+ ions doped in the oxyfluoride glass ceramics containing LaF3 nanocrystals heat-treated at 650 ℃ for different durations were investigated. The results of the integral absorption cross-section analysis demonstrated that the partition fraction of Er3+ in LaF3 nanocrystals increases with prolonging of heating time. The anomalous phenomena of Er3+ emissions in the up-and the down-conversion fluorescence spectra are well explained based on the calculated results.     

Characterisation of raw materials for production of ceramics

The aim of this paper is to characterize some raw materials used for ceramics material production. Five samples of clay have been analyzed. It has been carried out a patterned sampling in a quarry in Rosarno (South Italy). Chemical-physical properties on clay samples are determined. Test pieces have been prepared and physical properties after firing are determined by DSC thermal analysis, XRD analysis and X-ray fluorescence. It is important to note the high amount of Fe₂O₃. The mixture principally contains quartz, illite and oligoclase. It has been observed the colour and the shape after firing: predominant colour is red. In this case the clay has been used in mixtures covered with glazes. The colour of internal clay is hidden by opaque of glazes. The analysed raw materials can be used in a slip for single fired red tiles. The A2sp clay produces best ceramics at 1000°C.     

单相Ba2Ti9O20柠檬酸凝胶法制备、表征及介电性能

采用柠檬酸凝胶法两步热处理工艺制备了单相Ba₂Ti₉O₂₀。干凝胶在750 ℃热处理得到了物相为BaTi₅O₁₁和Ba₄Ti₁₃O₃₀、尺寸为30～50 nm的前驱体粉体。纳米前驱体具有高表面活性，促使单相Ba₂Ti₉O₂₀在1 200 ℃热处理温度下形成。两步热处理所得的粉体比一步热处理所得的粉体具有更好的烧结和介电特性，两步热处理所得的粉体，在1 250 ℃烧结4 h，可获得理论密度为97%的Ba₂Ti₉O₂₀微波介质陶瓷，其介电性能：ε_r=38.5，Qf=19 320 GHz，τ_f=8.7×10^-6 ℃^-1。     

LaxBa1—xCoO3系导电陶瓷导电性研究

对ＬａｘＢａ１－ｘＣｏＯ导电陶瓷的导电性及其导电机制进行了研究，在ｘ＝０．５ｍｏｌ处，导电陶瓷具有金属态导是性，在Ｌａ０．５Ｂａ０．５ＣｏＯ３陶瓷中，存在着氧缺位和导电电子，并且此种导电陶瓷具有较高的电子和氧离子混合导电特性。     

新型陶瓷材料的光激励发光性质研究

针对以往电子俘获光存储材料存在的问题，利用高温固相反应发制备了一种Eu^2 掺杂的氟氧化物玻璃陶瓷，研究表明在该材料中具有光激励发光(PSL)特性，并可用于电子俘获光存储。XRD分析表明该材料含有大量的BaF2微晶。根据其与BaF2相似的发光特性，推断玻璃陶瓷的PSL有可能来源于微晶中Eu^2 的5d-4f发射。但是决定光激励发光过程中的电子(空穴)陷阱的存在方式、电子迁移途径都有待进一步探讨的问题。与传统的BaFCl：Eu相比，这种材料的光激励发光衰减速度较慢。