Investigation of thin-film electroluminescent structures on rough subsrates

Results of experimental investigations of the volt-brightness characteristics, frequency dependences of brightness, and the directional radiation pattern of electroluminescent MSDM, MSCM, and MSDCM emitters, where M stands for the first transparent and second nontransparent electrodes, S is a semiconductor, D is a thin-film dielectric, and C is a silicone-based composite liquid dielectric with a powdered segnetoelectric filler, developed on conventional “smooth” and rough glass substrates are presented. It is shown that electroluminescent structures on rough surfaces have a brightness approximately two times higher than that of similar structures developed on a “smooth” substrate. Ul’yanovsk State University, 42, L. Tolstoi St., Ul’yanovsk, 432700, Russia. Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No. 4, pp. 507–512, July–August, 1997.     

石墨和纳米碳中缺陷和电子密度随温度的变化

测量了石墨和纳米碳在不同温度下的正电子寿命谱,研究了石墨和纳米碳中缺陷和电子密度随温度的变化.结果表明,纳米碳中缺陷的开空间和缺陷浓度分别大于和高于石墨晶体;纳米碳的平均自由电子密度低于石墨晶体.当温度从25K升至295K时,石墨和纳米碳中的平均自由电子密度随温度的升高而下降:石墨晶体中的自由电子密度随温度的升高变化较小;纳米碳的自由电子密度随温度的升高变化较大.随着温度的升高,石墨和纳米碳中的热空位数量增多,而且这些空位可迁移至微孔洞的内表面使微孔洞的开空间增大.     

Slow positron beam study of corrosion-related defects in pure iron

Corrosion-related defects of pure iron were investigated by measuring Doppler broadening energy spectra (DBES) of positron annihilation and positron annihilation lifetime (PAL). Defect profiles of the S-parameter from DBES as a function of positron incident energy up to 30 keV (i.e. ∼1 μm depth) were analyzed. The DBES data show that S-parameter increases as a function of positron incident energy (mean depth) after corrosion, and the increase in the S-parameter is larger near the surface than in the bulk due to corrosion. Furthermore, information on defect size from PAL data as a function of positron incident energy up to 10 keV (i.e. ∼0.2 μm depth) was analyzed. In the two-state trapping model, the lifetime τ₂ = 500 ps is ascribed to annihilation of positrons in voids with a size of the order of nanometer. τ₁, which decreases with depth from the surface to the bulk, is ascribed to the annihilation of positrons in dislocations and three-dimensional vacancy clusters. The corroded samples show a significant increase in τ₁ and the intensity I₂, and near the surface the corroded iron introduces both voids and large-size three-dimensional vacancy clusters. The size of vacancy clusters decreases with depth.     

SHI induced modification in CR-39 polycarbonate by positron annihilation lifetime studies

CR-39 is a polycarbonate widely used as SSNTD for recording nuclear charged particles and in other applications. Latent ion tracks produced in the polymers due to the damage produced by the passage of Swift Heavy Ions contain amorphous material with highest degree of disorder, changing the free volume properties which have strong correlation with the macroscopic properties of the material. Positron annihilation lifetime spectroscopy (PALS) provides direct information about the dimension, content and hole size distribution of free volume in polymers. The effect of irradiation of ⁴⁰Ar (14.9 MeV/n) ions on CR-39 polycarbonate by Positron Annihilation Lifetime Spectroscopy (PALS) is reported here. PALS provides a non-destructive and non-interfering probe, having high detection efficiency for free volume hole properties. From o-Ps lifetime mean free volume hole radius and average free volume of the micro-voids have been calculated. PAL measurement shows an increase in free volume on irradiation.     

Effects of oxygen in gamma irradiated aromatic polyesters in film

The effect of gamma irradiation in air is investigated on four thermoplastic polyesters (PET, PBT, PEN, PCT-co-ET) in films containing aromatic rings, in order to evaluate the influence of aromatic density and the role of oxygen on radiation resistance. Physical-chemical-nuclear analyses were used to this purpose. EPR measurements were carried out to detect radical stability against oxygen permeation. Viscometric investigations reported a very similar trend for all the investigated polyesters: a chain break effect that decreases at the highest doses. FT-IR analyses focused on the formation of oxidized species. Positron annihilation spectra pointed out a decrease of the intensity of ortho-positronium formation, while its lifetime remains unchanged with radiation dose.     

Planned positron experiments at FRM-II

The new research reactor FRM-II near Munich has a strong positron source, which delivers an intense, nearly monoenergetic positron beam. Our positron systems, the pulsed low energy positron source (PLEPS) and the scanning positron microscope (SPM) will be operated at this beam. Some aspects of matching these systems to the new positron source will be discussed.Considerable improvements are expected, e.g. more than 10⁵ s⁻¹ recorded events at PLEPS and sub-micrometre resolution at SPM. They will enable investigations in so far inaccessible problems like the evaluation of annihilation characteristics and trapping constants of individual defects or studies of fast dynamical processes. In applied materials science complex defect structures will be studied which demand a resolution into many differing lifetimes, e.g. fractured specimens, wear, corrosion, etc. Also large series of measurements at small systematic modifications are planned. There is also the opportunity to analyse in addition the chemical microstructure of the specimens by means of a hydrogen microprobe and other ion beam techniques available close to FRM-II at the Technical University of Munich.     

冲击波处理的结晶MgO的化学分析正电子谱研究

冲击波处理的结晶ＭｇＯ的化学分析正电子谱研究＊张菊郑小明（杭州大学催化研究所，杭州３１００２８）常志向（抚顺石油化工研究院，抚顺１１３００１）关键词冲击波，化学分析正电子谱，结晶氧化镁，丁烯，脱氢冲击波是在介质中以超音速传播的压力脉冲．气体中的冲击波...     

涂敷法制作质谱场电离发射丝的方法及性能研究

本文介绍一种新的质谱场电离发射丝的制备方法——涂敷法,并研究了其制备机理及影响发射丝灵敏度的因素。此外,还对涂敷法制作的发射丝及高温活化法制作的发射丝进行了各项性能对比试验。最后,介绍了涂敷发射丝的应用效果。     

钆铁磁－顺磁相变的正电子寿命研究

通过测量金属钆在居里点附近的正电子湮没寿命谱随温度变化的关系，发现钆的正电子湮没寿命在居里点近邻Ｔ＜ＴＣ一侧随温度有显著变化，而在此温区以外几乎不随温度变化